查询词典 coating material

The thermostability of the coating was investigated by thermal analysis, and the maximum sustainable temperature for the coating was as high as 280℃.

通过热分析手段考察了该涂层的热稳定性，涂层使用温度可达280℃。

The effects of pulse parameters such as pulse width Ton, pulse interval Toff, pulse frequency f, pulse current density J on the morphology ,grain size , hardness, internal stress and orientation of coating , and coherence of coating to sucbstrate have been examined .

研究了脉冲电镀参数：脉冲宽度Ton ，脉冲间隔Toff，脉冲频率f，脉冲电流密度 J对镀层微观形貌、颗粒大小、硬度、与基体结合力的影响，分析了镀层内应力、择优取向与脉冲参数的关系。

The electrochromic reaction of this coating in theliquid electrolyte is reversible.X-ray diffraction was used to analyse the coating,and the result shows that the original WO_3 film is triclinic WO_3 while the colouredlayer is orthorhomic H_...

X 光衍射实验发现，变色后的涂层由原来的三斜 WO_3晶体变成了 H_(0.1)WO_3斜方晶体。本文还用扫描电子显微镜对热处理前后涂层的表面形貌进行了分析。

The latest energy-saving environmental protection structure series waterproof coating applied to concrete, cement, masonry, metal, PVC and other materials, roofing, inside the wall, room, water-proof underground facilities, water works; anti-aging, can withstand long-term water immersion; high and low temperature resistance and ultra-violet radiation, yet energy-saving effect; no irritating smell, does not contain harmful substances; non-combustible; bonded resilient seamless, waterproof coating seamless.?

适用于混凝土、水泥、砖石、金属、PVC等材料的屋面、内外墙、卫生间、地下设施的防水、止水工程；抗老化，能长期抵御水的浸泡；耐高低温及紫外线照射，且具节能效果；无刺激性气味，不含有害物；不可燃；粘结力强，无接缝，防水涂层浑然一体。

But the coating of adjustment and revision is relatively easy using either coater coating, usually sterilizatin or the ultrared oven, and then use solvent UV-curing method or directly through the UV-curing.

但涂布量的调整及改版相对比较容易利用上述任何一种涂布机涂布后，一般采用热风烘箱或红外线烘箱使溶剂挥发，然后利用紫外线固化的方式或直接通过紫外线固化。

It was proved that the chemical solution coating method is benefit for the uniform distribution of coating constitution.

E DX扫描分析的结果表明用化学溶液涂覆法制备的涂层成分分布均匀。

The grain size of the coating was 100~400nm. The nano-grains resulted from the re-crystallization of melted and partially melted nanoscale powders and some unmelted nanoscale powders preserved in the coating.

涂层的孔隙率大约为19%；纳米—亚微米MoS_2涂层的物相主要为六方的MoS_2，还有少量的Mo，Mo_2S_3和MoO_3，涂层由片状MoS_2组成，尺寸在100～400nm。

UFP/MPA/TiO2 nanocomposite coating was prepared with urushiol formaldehyde polymer and multihydroxyl polyacrylate via sol-gel process. Its structure and dynamic mechanical properties were characterized by PT-IR, TEM and DMTA. The physico-mechanical and ultraviolet resistant properties of the coating film were also investigated.

采用Sol-Gel法制备了漆酚缩甲醛聚合物／多羟基丙烯酸树脂／TiO2纳米复合涂料(UFP/MPA/TiO2)，并用透射电镜、动态机械热分析、红外光谱和其它手段对复合涂膜进行测试。

Arc-glow plasma depositing technique is a new surface coating method. With the help of vacuum arc discharge, a cold cathode arc source continually emits ion beams of coating elements with high currency density and high ionizing ratio.Upon the ion bombard and diffusion work on, the surfaces of the parts form deposited layers, diffusion layers. In this study, a commercial magnesium alloy AZ91 was coated with Ti film layer.

加弧辉光离子渗镀技术将辉光放电与弧光放电有机地结合起来，利用辉光放电空心阴极效应使工件迅速升温，同时在真空容器壁上设置一个或多个金属阴极电弧靶源，利用真空电弧放电而不断地发射出高能量、高电流密度、高离化率的欲渗金属离子流，依靠扩散和离子轰击作用快速渗入工件表面层，在工件表面可以形成渗层、镀层、渗镀结合层。

Moreover, the coating had a good vulcanize degree, Its stabilization was good for anti-heat,the dosage of coating components accorded with design request.

且该涂料固化反应程度完全，热稳定性能好，各组分含量符合设计要求。

The receding calculations and experiment analyses in this subject are built on the blood cast of pig tongue.

本研究课题的前期工作是采用猪舌血管铸型模拟人舌而进行的数值计算与实验分析。

"Each human infection constitutes an opportunity for genetic modification of the virus through reassortment, mutation, or both...."

&每一次人类的感染都暗藏着一次基因修改的机会，无论是通过病毒的整合、突变或者兼而有之。。。。&