查询词典 cathode current

Preparation of the cathode includes:shaping under the press of 40Mpa, sintering at 550℃for 1 hour and at 900℃for 8 hours and threading with molybdenum bar; Considering the literatures we choose CaCl2 as salt for preparation titanium. Pretreatment of salt is for 1 hour at 100℃and for 2 hours at 300℃. Partial pressure of oxygen which need lower than 5.11×10-7Pa to reduct titanium oxides and hygroscopic property of salt need a sealed equipment to electrolyse. And finally successfully designed a satisfied one and the results show that the equipment can be satisfied the requirment of the experiment. Flow of the inert gas is 1.5L/min, the voltage is 2.8 V, temperature is 850℃and time is 2 hours during pre-electrolysis. Flow of the inert gas is 0.2L/min, the voltage is 3.1 V, temperature is 900℃and time changes with the mass of TiO2 during electrolysis, namely the greater need the longer time; To eliminate influence of salt and other impurities, the products need to wash with distilled water and dilute chlorhydric acid , then wash with dilute hydrochloric acid under supersonic wave assistant. Finally, electrometical properties of the electrolysis of TiO2 is researched by cyclic voltammetry and chronoamperometry, and results show that there are two main reodox steps, namely from TiO2 to TiO and from TiO to Ti.

阴极制备主要包括40MPa压力下模压成型、两段式烧结(1小时内升至550℃保温1小时，再1小时升温至900℃保温8小时)及烧结后TiO2块打孔用钼棒串接三个主要环节；实验中选用CaCl2作为电解熔盐，并对其进行预处理(100℃，保温1小时； 300℃，保温2小时)；经热力学计算，还原钛氧化物的氧分压至少要低于5.11×10-7Pa，结合电解过程中所用熔盐CaCl2有极强的吸水性的特点，电解装置应有较高的密封性，自行设计了一套密封性可靠的电解装置，便于实验过程中熔盐预处理和氧分压的控制；通过干燥处理预电解过程中Ar流量大约为1.5L/min、电压为2.8 V、温度为850℃、时间为2小时，电解过程中Ar流量大约为0.2L/min、电压为3.1V、温度为900℃，实验结果表明电解时间与TiO2质量密切相关，质量越大需要电解的时间越长；通过自来水冲洗—稀盐酸浸泡、洗涤—在超声波辅助作用下稀盐酸洗涤，可减少熔盐及其它杂质对电解产物检测结果的影响；最后，通过循环伏安法、计时电流法对电解机理的研究，确定电解还原TiO2制备金属钛主要经历了TiO2-TiO-Ti的过程。

Study on cobaltous recovery from cathode leachate of lithium-ion battery by salting out ;2. Then further study was made on extracting pectin from the orange skin by means of salting out with mixed salt for the best condition investigation.

通过浸取、碱溶依次从柑橘皮中提取出橙黄色素、橙皮甙后，利用混合盐析的方法进一步做提取果胶的研究与探讨，对提取果胶的最佳条件进行摸索，并测定这种物质的含

And the cathode heat appearance to also flap to concuss to have influence to the low frequency.

而阴极加热状态也对低频振荡有所影响。

By using a new method of corroding cathode point,we have corroded metal material most in use.

采用一种腐蚀阴极尖端的新方法，对阴极常用金属材料W，Mo，Ir，Ta制作的阴极尖端进行腐蚀。

Cuprous oxide microspheres can also be served as cathode materials for lithium ion batteries.

Cu_2O亚微球还可作为锂离子电池负极材料。

The key of cathode surface treatment is the component of glue liquid and the uniform degree of daubing glue, especially whether the carbon grains are transferred into diaphragm and electrolyte or not.

对负极片进行表面处理的关键是浸胶胶液配方及涂抹胶液的均匀程度，特别是负极片表面的碳颗粒是否会迁移到隔膜和电解液中。

The value of voltage affects depositive thickness, depositive rate, depositive morphology, and field emission property of cold cathode.

电泳电压是电泳过程中的重要参数，不同电压会影响阴极沉积的厚度和效率、形貌结构及场发射特性。

Said cathode material is compound material consisting of copper and selenonium, especially having different chemical element proportional of copper - selenium compound: copper diselenide, copper selenide, cuprous selenide.

该阴极材料是由铜和硒组成的化合物材料，具体为含有不同化学元素比例的铜-硒化合物：二硒化铜、硒化铜、硒化亚铜。

In order to research the influence to the deterioration of anode and cathode by the impaction of the moving electriferous particle in electric discharge channels and the insufficiency of the polarity effect theory, a series of systematic research is taken, which include monpulse EDM experiment, limited continuous pulse experiment and model analysis.

这不仅对完善电火花加工理论本身有着重要的意义，同时必将促进并有助于推动电火花加工工艺的发展和进步。

Oscillographic analysis is a group of electroanalytical methods based on the use of a cathode-ray oscillograph as the main instrument.

示波分析是最近十多年来在我国迅速发展起来的一个新的电分析化学领域。

What was it that made you want to change sider ?

是什么使你临阵倒戈？

I don't know what he wants, but let's play along with him.

我不知道他要干什么，可我