查询词典 calculation error

Determination of laser absorptivity of metal by numerical calculation technique and trial-and-error method .

用数值计算技术和试错法确定金属材料表面对激光的吸收率。

The problem of the error of calculation formula calculating the variance of grouping data within distances in statistics was put forward,and the concrete forms of correcting formula were given by the theorem of addition and the variance of even distribution.

提出统计学中的组距分组资料方差和标准差计算公式误差问题，由方差的加法定理和均匀分布方差给出分组资料方差计算和标准差计算的修正公式具体形式，并就均匀分布数列和正态分布数列组内方差平均数进行了讨论

Cash dividends, dividend reinvestment, to amend the error, the additional investment, these features are easy to achieve accurate calculation.

现金分红、分红再投资、修改误差、追加投资，这些功能都轻松实现精确计算。

In the use of optical water level, due to eye fatigue, on-site allowable error index calculation and other reasons, accuracy and speed is difficult to meet our requirements, but generally require 6 people / groups: one person observation, 1 record, 2 Fu-foot, 2 lamps.

在使用光学水准仪时，由于眼睛疲劳，现场限差指标计算等原因，精度和速度很难满足我们的要求，而且一般需要6人/组：其中1人观测，1人记录，2人扶尺，2人照灯。

Examination found a number of major quality problems: First, part of the observed deformation and deformation measurements are not laying a solid reference point, deformation monitoring points do not comply with regulatory requirements; deformation observation, the calculation is not strictly enforce the state standards, such as the base network is not on a regular basis retest , no point will work in conjunction with the reference point for measurement, the standard of measurement stations and other allowable error overrun.

检查中发现了一些主要质量问题：一是部分变形观测与形变测量项目基准点埋设不稳固，变形监测点设置不符合规范要求；变形观测、计算未严格执行国家标准，如基准网未定期复测，未将工作基点与基准点进行联测，水准测量测站限差超限等。

Because of face patterns anfractuosity and destructibility, algorithms of face detection have a lot of disadvantages such as plentiful calculation,extraordinarily slow operation speed and very high error detection ratio under common circs.

人脸检测是一个极具挑战性的研究课题，由于人脸模式错综复杂、易受干扰，因而目前人脸检测算法一般都存在计算量大、速度慢、误报率高的缺点。

With the combination of lighting, cooling and heating under daylighting, the study on the effect of the key characteristic parameters on total energy consumption is provided. The validation of the comparability of daylight distribution for building antetype and model is made through theoretical analysis and simulating calculation in the thesis. Due to the variable sky condition, daylighting factor is used for experimental validation instead of illuminance. The error analysis of several testing methods used in the experiment is conducted, followed by the experimental validation of the effect of WWR, sill and transmittance on daylighting factor distribution.

基于天空状态的多变性，提出用天然采光因数替代照度进行实验验证，对实验中的几种测试方法进行了误差分析，并通过实验验证了窗墙比、窗台高和透光率对天然采光因数分布的影响。4 为了更直观地分析各参数对照明节电的影响，提出了"特征点"、"特征线"和"特征距离"等概念；分析了天然采光下的照明节能状况，综合考虑照明、采暖和空调能耗，计算分析了几个主要特性参数对总能耗的影响。

Double-precision measurements of the bridge higher, but in terms of accession to the approximate calculation, and therefore will have a certain margin of error.

双电桥测量精度较高，但在计算中加入了近似计算，因此会产生一定的误差。

By means of analyzing the noise error, it is proposed to use an algorithm of singular value decomposition total least squares to conduct the interharmonics estimation, namely taking the noise interference at both sides of the matrix equation into account simultaneously and solving the minimum norm problem by least square method under such condition. In the proposed algorithm by means of singular value decomposition of a new augmented matrix and by use of a simple and practical method to determine the number of principal singular value related to signal to noise ratio, the storage calculation of right singular matrix is performed, thus a more accurate frequency estimation of interharmonics can be obtained.

通过分析噪声误差，提出采用奇异值总体最小二乘(singular value decomposition total least squares，SVDTLS)算法进行间谐波频率估计，即同时考虑矩阵方程两边的噪声干扰，采用SVDTLS算法求解该情况下的最小范数解，通过对增广矩阵进行奇异值分解(singular value decomposition，SVD)，采用简单实用的与信噪比相关的主奇异值个数确定方法对分解的右奇异矩阵进行存储计算，得到了较精确的间谐波频率估计结果。

The results show that the error of considering the curve of strand as line is less than 2%, through the comparison with the result of FEA and experimental data, the error of principal tensile stress is less than 0.2 MPa, which prove that the precision of the method meets engineering calculation requirement, the method is feasible.

理论分析结果显示，将预应力束的平弯曲线用直线代替产生的误差不超过2%，该公式计算结果与有限元结果及实测数据比较表明，主拉应力的计算误差小于0.2 MPa，结果满足工程精度需要，该方法可行。

Since historical times,England ,where the early inhabitants were Celts, has been conquered three times .

从有历史以来，英国，在此地早期居住的是凯尔特人，已经被征服了三次。

Bluetooth OBEX File Transfer Enables the sending and receiving of files on your phone via Bluetooth.

蓝牙OBEX文件移动允许经过蓝牙传送和接受文件。。。。