查询词典 bulk density

We employ ab initio plane-wave pseudopotential density functional theory to calculate the coordinate,the equilibrium lattice parameters,bulk modulus,shear modulus and elastic constant,and those calculated results agree well with the other experimental data and the theoretical data which have been published.

本文采用平面波赝势密度泛函理论方法计算了PtN2的坐标、平衡态的晶格常数、体模量、剪切模量和弹性常数，计算结果与已有的实验值和理论值吻合较好。

2After the utilization of seasonal exclosure, the proportion of coarse sand (2.00～0.25 mm) dropped significantly, and the proportion of fine sand (0.25～0.05mm) and silt and clay (.05mm) increased significantly, soil bulk density and compaction dropped, soil porosity, nutrient and microbe quantity increased, soil microbial biomass and enzyme activity enhanced in the layer of 0～10cm and 10～20cm.

2放牧草地采用生长季围封恢复措施后，土壤0～10cm、10～20cm土层中粗沙(2.00～0.25 mm)含量显著降低，细沙(0.25～0.05mm)和粉粘粒(。05mm)含量显著增加，土壤容重和紧实度降低，土壤孔隙度、养分含量、微生物数量、微生物生物量碳、氮含量增加，土壤酶活性增强。

Based on KT-01 nickel catalyst, the scientific research personnel of our company and the expert group of the former subject group from Lanzhou University made joint efforts to tackle the key problems and successfully developed the 2nd generation of KT-02 supported nickel catalyst through in-depth study on the technical formula, catalytic activity and other mechanisms and taking modified carrier, the properties of acid and alkali, the degree of decentralization of active ingredients on the carrier surface, and fundamental breakthrough has been achieved on the aspects of catalytic activity, specific surface area, bulk density, etc, and the technical defects of KT-01 nickel catalyst are completely overcome; the catalytic activity becomes higher, the starting temperature becomes lower, the industrial serviceability temperature is lowered and the yield increased.

在KT-01型镍催化剂的基础上，我公司科研人员与兰州大学原课题组专家联合攻关，通过对工艺配方及催化活性等机理的深入研究，从载体改性、酸碱性、活性组分在载体表面的分散程度等方面入手，成功开发出第二代KT-02负载型镍催化剂系列产品，在催化活性、比表面积和堆密度等方面都有根本性突破，彻底克服了KT-01型镍催化剂的技术缺陷，使催化活性更高、启动温度更低，降低了工业使用温度，提高了生产收率。

The measuring method of bulk density of abrasive micro grits and the principle of the instrument are introduced in this paper.

本文介绍了微粉堆积密度的测量方法及测量仪器的基本原理，采用数理统计的方法对试验数据进行了分析，确定了测量过程的不确定度。

It has been found that during the spark plasma sintering process, under the condition of large current, short sintering time and lower sintering temperature, the metastable icosahedron quasicrystal phase in primary powder particles is kept. And the strong discharge plasma among particles can decompose or break the oxide film on the primary powder's surface, resulting in the increment of their combination strength. So the as-prepared bulk alloy possesses high density and ultra-high strength.

结果表明，在放电等离子烧结过程中，采用大电流、短时、低温的烧结条件可使快冷雾化法制备的原始合金粉末中的准晶强化相及其它细小强化相得以保存，而局域强放电等离子体可以分解或破碎铝合金粉末表面的氧化膜，使合金粉末颗粒间的结合强度增加，制备出的块体铝合金具有高的致密度和超高强度。

This option is not possible for many countries where the bulk of the land is low-lying and the density of population is high.

对于很多国家来说，这是很难做到的，因为那里的领土大都海拔很低，且人口众多。

Results showed that both bulk density and micropore volume of the formed activated carbon controlled the volumetric storage capacity of methane.

结果发现：随粘接剂含量的增大，所制型炭的抗压强度、堆密度增大，而比表面积及孔容减小，其对甲烷的吸附性能也呈下降趋势。

The results show that the penetrability of powder loads can be improved when suitably reducing bulk density and grain size of gun propellant, increasing nitrogen content of NC and choosing oblate spheroid explosive respectively under the constant test con

结果表明，在其它试验条件不变的条件下，适当降低发射药堆积密度、适当提高发射药中硝化棉含氮量、选用恒面燃烧的扁型药、降低发射药粒度均有利于提高射钉的穿透能力。

Preferential oxidation of Ti on NiTi alloy surface has been observed and was consistent with the experimental result and the free energy of formation A G?(298K) of NiO, TiO, TiO2. Mulliken population and the partial density of state analysis showed that the interaction between Ti and O atoms was mainly donated by O 2p and Ti 4s orbital and O 2p and Ti 3d, 4s, 4p hybridization orbital. The electron structure in NiTi bulk material was not altered during 62 molecule adsorption process and the surface passivation oxide formation.

进一步对钛与氧之间相互作用本质的研究表明，O 2p轨道和Ti 4s轨道以及O 2p轨道和Ti 3d 4s 4p杂化轨道间的相互作用是NiTi合金表面氧分子吸附的驱动力，在此过程中，NiTi合金的体相结构没有发生变化，从而保证了其一系列力学性能和形状记忆特性在表面氧化后不发生明显的变化，使表面改性的工作可以安全、可靠的完成而不影响其植入人体后发挥正常的生理功能。

Mulliken population and the partial density of state analysis showed that the interaction between Ti and O atoms was mainly donated by O 2p and Ti 4s orbital and O 2p and Ti 3d, 4s, 4p hybridization orbital. The electron structure in NiTi bulk material was not altered during O〓 molecule adsorption process and the surface passivation oxide formation. Thus the mechanical properties and shape memory effect would not change after NiTi alloy surface oxidation. Stable microstructure demonstrates reliability of implant material.

进一步对钛与氧之间相互作用本质的研究表明，O 2p轨道和Ti 4s轨道以及O 2p轨道和Ti 3d 4s 4p杂化轨道间的相互作用是NiTi合金表面氧分子吸附的驱动力，在此过程中，NiTi合金的体相结构没有发生变化，从而保证了其一系列力学性能和形状记忆特性在表面氧化后不发生明显的变化，使表面改性的工作可以安全、可靠的完成而不影响其植入人体后发挥正常的生理功能。

We have limited budget let me know if you can do this competitively.

我们有限的预算让我知道如果你能做到这一点竞争力。

We don't know how other critters breathe--lizards, for example.

我们还不知道诸如蜥蜴之类的动物如何呼吸。