查询词典 accumulated error

And the temperature error could be divided into accidental error and systematic error.

其温度误差分为随机误差和系统误差两部分。

Sampling error or allowable error is conventionally accepted between 1% and 10%; however, it is suggested that sampling error should be carefully assessed in light of the nature of the derivation of the population proportion and other aspects of the initial data.

抽样误差或允许误差是接受常规的1 ％和10 ％，但是，有人建议，抽样误差应当认真评估根据的性质推导的人口比例和其他方面的初步数据。

Allowable platform motion error allocation is an important part of system-wide allocation in SAR system. It is a necessary system design procedure to take into account error effects, error sources, and performance-limiting factors to determine more reasonable design.

摘要合成孔径雷达系统平台运动容差分配是系统要求分配的一个重要方面，它是系统设计中的必要步骤，通过考虑误差源、误差影响和性能极限等因素使得最终的设计方案更为合理。

After the analytic model is set up and the error rate is derived, the system error performances of uncoded and Turbo coded DPIM are simulated and analyzed under weak turbulence channel, and the system error performances under Gaussian channel are simulated for comparison.

在建立分析模型和推导差错率的基础上，在弱湍流信道条件下仿真分析了Turbo码编码前后的系统差错性能，同时与高斯信道条件下的系统差错性能进行了比较。

There are two sources of error: error manifested as an apparent magnification drift and error due to fringe tracing.

两种误差来源：放大倍数的改变引起的误差，图像歧变引起的误差

Point out the electromagnetism signal produced by human campaign not be noise completely, in which, part has formed useful signal. Analyse through error theory, have gotten the mathematics relation of phase error and apparent resistivity error.

引入CSAMT的理论，对MT勘探中电干扰和磁干扰进行了研究，从理论上证实了磁场的信噪比要优于电场的，指出人类活动所产生的电磁信号并不全部是干扰，其中一部分构成了有用信号。

The result shows that the mixed boundary condition can greatly reduce the calculation area without affecting accuracy of the solution.It is followed by the higher accuracy of Dirichlet boundary condition which makes the boundary error greater when measured points is near the boundary, so we must take a sufficiently large border region.The homogeneous boundary condition has relatively large error, but the use of non-triangle poles devices makes apparent resistivity calculation error become small, because of elimination of the effect on potential difference for the infinite boundary. In inversion, in order to save computing time, homogeneous boundary conditions are often used to perform finite element forward calculation.

结果表明，混合边界条件精度最高，可大大缩小求解区域而不影响计算精度，其次是Dirichlet边界条件精度较高，但测点越靠边界误差会越大，必须取足够大的边界区域，齐次边界条件的误差比较大，但如果采用非二极装置，通过电位差计算得到的视电阻率，由于无穷远边界对电位差的影响基本消除，视电阻率计算误差与混合边界条件下的接近，在反演中，为了节省计算时间，经常使用齐次边界条件进行有限元正演。

The arc data interpolation error by secant, tangent and chord, and the smallest error by secant mode is analyzed in this paper. The relation between the maximum radial error and arc radius and approach step-length in the secant mode of arc data interpolation in CNC system is detailed.

在分析数控系统圆弧数据插补割线方式较切线、内接弦插补方式误差更小的基础上，讨论了数控系统圆弧数据插补割线方式中最大径向误差与圆弧半径和逼近步长的关系。

Finally, an autocollimator and a high precise measuring head were used in the measurement of the displacement straighness and the the error of the lifting displacement, respectively. The experiment results show that the error of the displacement straighness is smaller than 1 and the error of the lifting displacement is less than 0.02 mm, which shows that the structure achieves the design desire completely.

用自准直平行光管和高精度测量头分别检测了平台的位移直线度和升、降位移误差，实验结果得出，该机构的位移直线度误差小于1，升、降位移误差小于0.02 mm，达到了平台设计要求。

The average error, maximum error and the error standard deviation regarding the test data decrease by 37%(45%), 34%(40%) and 35%(40%), respectively.

对测试数据的平均误差、最大误差和标准差较传统ANFIS分别下降了37%(45%)， 34%(40%)和35%(40%)。

Must have Coordination and negotiation skill, flexible ideas, and be punctilious person.

必须具备较好的协调与谈判能力，头脑灵活，工作认真仔细

Result: 18 patients are all with simple eye.The pigment mole lies in nasal and temple sides of the ball conjunctiva,in which 2 lie in lacrimal caruncle and semilunar plica.

结果：18例患者均为单眼，色素痣大多数位于内外侧睑裂部球结膜面，2例位于泪阜及半月皱襞，经激光治疗后，10例色素痣消失，有5例行再次激光后消失，2例行第三次激光后消失，1例第四次激光后消失。