- 更多网络例句与梭口相关的网络例句 [注：此内容来源于网络，仅供参考]
-
This paper describes the investigation for weaving process of elastic jean, concerned with the following adjustments: shed, balance time of heddle, warp stop device, and the process of weft insertion.
从梭口调节、综平时间调节、停经装置的调节以及引纬工艺调节等几个方面对弹力牛仔布的织造工艺进行了探讨；同时通过对比实验，对后整理工艺进行了研究。
-
After analyzing, some deduction is confirmed. First, the product hasapproached import very much, not only in outer dimension, but also on mainproperties. Second, best weaving-process parameter: symmetry degree is0.5～1, back roll height is 6cm more than front one. Third, weavingpreparation process: heddle draft is section, reed-in uses special yarns.Finally, the product can match import one that using 2/1 twill as basicweave, and 60～70D nylon as material, and 60 roots/cm.
通过分析，得出结论：(1)自行研制的网格圈产品，无论是外形上，还是性能上均已十分接近进口产品；(2)最佳织造工艺参数：0.5～1之间的梭口对称度，后梁高出胸梁6cm左右；(3)织前工艺：穿综法采用分区穿法，穿筘法采用布边比布身少穿入经纱数，并加入特线的方法；(4)以2/1斜纹为基础组织、60～70D范围内的锦纶为原料、60根/cm为织物密度制织出的网格圈产品在各项性能(强伸性、耐磨性、透气性等)上均接近进口产品。
-
Shed ; Noil ; Warp-friction ; Patent Heddle ; Profit
梭口；落物；经纱-摩擦；专利-综丝；利润
-
Back rest system of loom is the main equipment of controlling the warp tension and sheld location.
喷气织机后梁系统是控制经纱张力和梭口位置的重要装置。
-
The main difficulty is that the amplitude of the sley's movement necessary to allow a large enough shed would produce very large forces of acceleration and retardation if its movement were confined to a relatively small part of the pick cycle.
这样做的主要困难是，如果筘座的运动被限制在引纬循环中的较小部分，为了形成较大的梭口，筘座的动程会引起较大的加速力和减速力。
-
The main difficulty is that the amplitude of the sley's movement necessary to allow a large enough shed would produce very large forces of acceleration and retardation if its movement were confine d to a relatively small part of the pick cycle.
这样做的主要困难是，如果筘座的运动被限制在引纬循环中的较小部分，为了形成较大的梭口，筘座的动程会引起较大的加速力和减速力。
-
The advantages of a period of sley dwell, in order to increase the time available for weft insertion and thus allow a higher loom speed to be achieved, are so obvious that the possibility of including a similar feature on a shuttle loom should be considered. The main difficulty is that the amplitude of the sley's movement necessary to allow a large enough shed would produce very large forces of acceleration and retardation if its movement were confined to a relatively small part of the pick cycle.
筘座的静止时间对增加引纬时间，提高织机速度的这一优点是如此之明显，以至于应该考虑是否让有梭织机也具有类似的性能，这样做的主要困难是，如果筘座的运动被限制在引纬循环中的较小部分，为了形成较大的梭口，筘座的动程会引起较大的加速力和减速力。
-
In reality, the shuttle is actually a projectile but the distinctive feature of shuttleless looms that the filling package be exterior to the filling carrier, disqualifies the shuttle loom from consideration.
片梭织机利用一只小片梭携带纬纱穿过梭口，实际上的梭子是片梭，只是由于具有无梭织机纬纱卷装不在载纬器之内的特点，因此不再将其看成有梭织机。
-
The projectile loom uses a projectile with grippers to carry the yarn through the shed.
片梭织机使用一个带有夹子的片梭将纬纱引过梭口。
-
The purpose of the protector motion found on a shuttle loom is to stop the loom when, for any reason, the shuttle does not completely pass through the shed or does not enter the shuttle box at the proper time.
在有梭织机上护经机构的作用是，在由于某种原因梭子未能完全穿过梭口或未在规定时间内进入梭箱时，使织机停车。
- 更多网络解释与梭口相关的网络解释 [注：此内容来源于网络，仅供参考]
-
shed dormer：单坡老虎窗,三角形天窗
shed coal 煤线 | shed dormer 单坡老虎窗,三角形天窗 | shed forms 梭口形式
-
heald：综丝
梭口 Shed | 综丝 Heald | 织轴 Beam
-
heald frame：综框
开口目的与任务:(1)要实现经、纬的交织必须把经丝按一定的规律分成上、下两层,形成能通过纬丝的通道--梭口(shed);(2)根据所制织物组织的要求,由纹板图(pegging plan)所定的提综顺序,控制综框(heald frame)或综丝(heald)的升降次序,
-
multiphase motor：多相电动机
multiphase loom 多梭口织机 | multiphase motor 多相电动机 | multipicture TV set 多画面电视机
-
multiphase inverter：多相换流器
multiphase alloy 多相合金 | multiphase inverter 多相换流器 | multiphase loom 多梭口织机
-
open fire kiln：开放型加热干燥炉
open fermenter 开放发酵罐 | open fire kiln 开放型加热干燥炉 | open shed 全开梭口
-
ripsaw：纵切锯
ripple-shedding loom 多梭口织机 | ripsaw 纵切锯 | Risalin 黄草硝
-
closing machine：封口机
closed shell and tube condenser 封闭式壳管冷凝器 | closing machine 封口机 | closing the shed 闭梭口
-
cross-dye effect：交染效應
胸宽 cross-chest width | 交染效应 cross-dye effect | 交叉开口,绞梭口 crossed shed
-
tappet motion：踏盘开口装置
tappet for open shedding 全开梭口凸盘 | tappet motion 踏盘开口装置 | tappet shape 踏综盘形状