firing iron

firing iron的基本解释

-

火烙铁

与firing iron相关的网络例句 [注：此内容来源于网络，仅供参考]

Do not insolate, firing or iron the Fir Pad to avoid damage the insulator of heating conductor.

不能暴晒、洪烤、熨烫，避免造成发热线绝缘损坏。

Porcelain clay which is due to iron content in the composition, when firing is oxidized to ferric iron, the club was yellow.

是由于瓷泥里面含有铁的成分，烧成时铁被氧化为氧化铁，故而呈淡黄色。

The reliability of the whole temperature range process model for firing iron ore pellets containing solid fuel is test and verified through a serious of experiments in the new firing device.

此外，作者还严格测定了焙烧杯体的热惯性的有关参数，提出热惯性对料层中热工状态影响的定量计算方法。

Synthesized all above, the heat and mass transfer of charge bed is discussed in detail. After choosing seriously the former study results in this field, a whole temperature range process model for firing iron ore pellets containing solid fuel is established as well as its software is edited. The main physical chemistry reaction process within pellets and the heat statement can be calculated exactly with the process as long as the physical and chemical parameters of raw material are obtained through basic experiments. After finding out the reason of"temperature hysteresis"and"heat inertia"of the experimental induration device, a new kind of experimental induration device is designed. The"temperature hysteresis"of hot gas flow in the new device is avoided.

综合以上对焙烧球团矿时球团矿内各种物理化学反应过程的分析与研究的结果，仔细地分析研究了球团矿料层中的传热质现象，认真筛选了前人对填充床的传热传质的研究结果，提出了全温度范围球团矿焙烧过程模型，并编制了相应的计算机软件，只要通过基础实验，获得原燃料的基本物性参数（如化学反应速度常数，矿粉、煤粉的粒度及此表面积以及球团矿的导热性等），利用这一软件就能准确地计算出焙烧球团矿时球团矿内各种物理化学反应过程和料层内的热工状态。

Longquan celadon use of local high-quality porcelain clay, soil Zijin, quartz chinaware and other raw materials, forming the pile after the traditional, carved, front, engrave, engraved, sticky, zoned skills such as hand-made of semi-finished products, and then glazing, at about 1300 ℃ high temperature to restore the atmosphere of heavy firing, glaze the high iron was reduced to low iron, so a dark green enamel.

龙泉青瓷采用当地优质瓷土、紫金土、石英等陶瓷器原料，成型后以传统的堆、雕、贴、镂、刻、粘、划等手工技艺制成半成品，然后施釉，在1300℃左右的高温下用重还原气氛烧制，釉中的高价铁被还原为低价铁，使瓷釉呈现青绿色。