charging density

charging density的基本解释

-

电荷密度, 装载密度

与charging density相关的网络例句 [注：此内容来源于网络，仅供参考]

The fiber length has only little influence on the basic density within the growth rings, and significant correlation at 0.01 levels was found between the basic density and the fiber length among the different rings. Only slight negative correlation was found between the basic density and the fiber width within the growth rings, but significant positive correlation at 0.01 levels was indicated between the basic density and the fiber width among the growth rings, contrary to that of fiber length. It was demonstrated that significant positive correlations at 0.01 levels between the basic density and fiber double wall thickness, fiber length to width ratio and double wall thickness to diameter ratio, significant negative correlations at 0.01 levels between the basic density and fiber diameter and diameter to width ratio, only slight negative correlation between the basic density and fiber width both in the same growth rings and among the different growth rings. No significant correlation was found between the basic density and the vessel morphological features, nor was the tissue proportion in the same growth rings. But among the different rings, it was found there was significant positive correlation at 0.01 levels between the basic density and the fiber proportion among the different rings, and significant negative correlation at 0.01 levels between the basic density and vessel-elements proportion and ray proportion, only slight negative correlation between the basic density and the parenchym proportion. Significant or no significant negative correlation was found between the basic density and the microfibril angle in the same growth rings, but significant negative correlation was found between the basic density and the microfibril angle among the different growth rings.

生长轮内纤维长度对基本密度的影响不大，而在不同生长轮间纤维长度与基本密度达极显著正相关，纤维宽度与此相反，同一生长轮内纤维宽度与基本密度极显著负相关，不同生长轮间只有微弱负相关；基本密度与纤维双壁厚、长宽比、壁腔比在生长轮内和生长轮间均呈极显著正相关，而与胞腔直径、腔径比均呈极显著负相关，仅与纤维宽度呈微弱的负相关；导管形态对基本密度的影响不显著；同一生长轮内组织比量对基本密度的影响也不显著，但不同生长轮间基本密度与纤维比量呈极显著正相关，与导管比量和木射线比量呈极显著负相关，与轴向薄壁细胞比量仅呈不显著负相关；生长轮内基本密度与微纤丝角呈显著或不显著负相关，但在生长轮间这种负相关达到极显著水平。

The influence of charging parameters (such as charging voltage, charging time and charging temperature, etc.) on piezoelectricity and its thermal stability of cellular polypropylene film electrets was studied by means of contact charging and constant voltage corona charging methods and the thermal stimulated discharge technique.

通过接触法充电、恒压电晕充电，以及开路热刺激放电技术，对充电参数(例如充电电压，充电时间和充电温度等)对聚丙烯蜂窝膜驻极体的压电性及其热稳定性的影响的研究，并从孔洞型薄膜压电体的材料结构和理论模型出发，讨论了这些参数对其影响的原因，分析了与压电活性密切相关的空间电荷的动态特性。

Optical density d of the material or the density of photographic film itself d field part of density d the density of the deep and change some of the most high density (h-red, green, or blue channels in maximum density) L intermediate density density (red, green, or blue channels in minimum density) M minimum density (red, green, or blue channels in the middle of the density) T transmission 4.2Murray-Davies formula in the measurement of surface films, film dot business card printing and membership card making dot area usually is the most important parameters.

光学密度 D 材料或片基本身的密度 D 实地部分的密度 D 深浅变化部分的密度 H 最高密度（红，绿或蓝通道的最大密度） L 中间密度密度（红，绿或蓝通道的最小密度） M 最低密度（红，绿或蓝通道的中间密度） T 透射率 4.2Murray-Davies公式在测量胶片的表面网点面积时，胶片制卡和会员卡制作网点面积通常是最重要的参数。

与charging density相关的网络解释 [注：此内容来源于网络，仅供参考]

charging by friction：摩擦生电

charging by contact 接触起电 | charging by friction 摩擦生电 | charging by induction 感应起电

charging by friction：接触起电

带电粒子 charging by contact | 接触起电 charging by friction | 摩擦生电 charging by induction

charging by induction：感应起电

charging by friction 摩擦生电 | charging by induction 感应起电 | charging by sharing 授受起电