驱动电路

It shows out the analysis, debugging of excogitation and the graphics of corresponding objects.

本文着重描述了反馈式力传感器的前向通道设计，主要完成了力发生器及驱动电路、位移检测电路、系统机械结构的设计及制作，并给出了方案的分析和调试及相应的实物图。

This paper describes a design of the frontal channel of pressure sensor based on feedback and mainly accomplishes the design and manufacture of force generator, electric drive, displacement-measure circuit and the system mechanical structure.It shows out the analysis, debugging of excogitation and the graphics of corresponding objects.

本文着重描述了反馈式力传感器的前向通道设计，主要完成了力发生器及驱动电路、位移检测电路、系统机械结构的设计及制作，并给出了方案的分析和调试及相应的实物图。

This paper describes adesign of the frontal channel of pressure sensor based on feedback and mainly ac complishes the design and manufacture of force generator,electric drive,displacement-measure circuit and the system mechanical structure.It shows out the analysis,debugging of excogitation and the graphics of corresponding objects.

本文着意描述了反馈式力传感器的前向通道设计，主要完成了力发生器及驱动电路、位移检测电路、系统机械结构的设计及建造，并给出了方案的分析和调试及相应的实物图。

The luminescence power of semiconductor laser diode is tested after the radiator element of laser diode is made and the drive circuit is designed. Then, chaos mathematic model is introduced to produce deterministic class stochastic signal and C langrage program, which is based on the hardware circuit design of MSP430, is designed and on-line debugged to implement the dynamic stimulation effect and avoid the body adaptability with the duty cycle of chaos sequence. The duty cycle is adjusted and controlled to accomplish the reinforcing and reducing in moxibustion. At last, Average power of laser diode is tested under the conditions of different duty cycles and the waveforms are collected by applying virtual instrument.

在半导体激光器散热装置的特别制作及工作驱动电路的设计基础上，完成半导体激光器发光功率的测试，然后引入混沌数学模型方法来产生确定性的类随机信号，在 MSP430 单片机硬件电路设计的基础上，应用单片机 C语言进行程序设计并在线调试，实现传统灸法的动态刺激效果，采用混沌序列占空比信号消除人体适应性，调整和控制输出占空比的改变以达到灸疗的补泻手法的实现，最后对不同控制占空比情况下激光器输出的平均功率进行测试，完成工作波形的采集。

An adaptive Light Emitting Diode lighting driver based on switching power is proposed according to the LED driver characteristics.

针对半导体发光二极管作为照明的驱动特性，设计了一种基于开关电源的自适应LED驱动电路。

Then discuss the power drive circuit and the logic control circuit in detail.

并详细介绍了功率驱动电路及逻辑控制电路。

Then the parallel control circuit and software is designed and the whole parallel system is built.

主电路设计中，功率器件采用IPM代替IGBT，具有体积小，驱动电路简单等优点。

In this paper,traditional H-bridge circuit for Electric Power Steering System was introduced and analysed.

对智能功率开关的功能特性和采用智能功率开关组成的H桥电路的控制方法与工作原理进行了系统研究，并在试验台上对新的H桥驱动电路进行了试验验证。

Research on design and reality of the power supply.

电源主电路和驱动电路的设计与实现。

This circuit faults is under the arm, bridge, no power transistor must therefore be adopted by isolating circuit or special driving power.

该电路的缺点是上、下桥臂的功率晶体管不共地，因此必须采用专门驱动电路或采用隔离电源。

Chrysanthemum of 10 thousand birthday is lax to edaphic requirement, with the arenaceous qualitative loam with fecund, good drainage had better.

万寿菊对土壤要求不严，以肥沃。排水良好的砂质壤土为好。

He unstepped the mast and furled the sail and tied it.

他拔下桅杆，把帆卷起，系住。