长节

A design method of non-perpendicular pitch cone of the honing wheel is presented in this article. By adjusting the distance from the contact point of pitch cones to the axis of honing wheel, the relative velocity between pitch cones is ensured to be in the direction of the tooth trace of the gear.

提出了用于珩磨螺旋锥齿轮的非正交珩磨轮节锥面的设计方法，通过调整节锥面切点到珩磨轮轴线的距离，保证了节锥面之间的相对速度恰好沿着齿长方向。

While leafstalk length and node length were two important constituent characters of fruit length.

而叶柄长、节间长为果长的重要构成性状。

Abdomen is rear add bag of white waxiness egg, there is line of backbone state upheaval on bursa 14 ～ 16, without the wing, antenna is black Brown, 11, every have black bristle; Mouthparts is small, rostellum 2, extreme has a lot of short-haired pelt, buccal shot is not long.

腹部后方附白色蜡质卵囊，囊上有脊状隆起线14～16条，无翅，触角黑褐色，11节，每节都有黑色刚毛；口器小，喙2节，末端有许多小毛，口针不长。

Pods toward1 m long,8-12 cm wide, compressed, septate, with thick sutures; seeds suborbiculate,4-6 cm in diam.

荚果长达1米，宽8-12厘米，扁平，具荚节，边缘增厚，成熟后逐节脱落，每节内有1颗种子；种子暗褐色，有光泽，近圆形，直径4-6厘米。

The time to peak systolic longitudinal strain and the time to peak systolic radial strain were derived from the LV apical views , and to peak systolic circumferential strain was derived from the parasternal short axis. The standard deviation for time to peak longitudinal、circumferential and radial strain in the 18 segments (LS-SD18、CS-SD18、RS-SD18) and the maximal temporal difference of any two segments(LS-dif、CS-dif、RS-dif)were calculated as a strain-derived dyssynchrony index.

方法16例慢性心衰患者，获取心尖长轴观测量各节段收缩期纵向应变达峰时间，径向应变达峰时间，胸骨旁短轴观测环向应变达峰时间，计算CRT术后1个月、术后3个月18节段纵向、环向、径向应变达峰时间标准差(LS-SD18、CS-SD18、RS-SD18)、左室各节段收缩期纵向、环向、径向应变达峰时间最大差值(LS-dif、CS-dif、RS-dif)作为应变非同步指标。

The shortest slubby length is 2cm and the longest is arbitrary.

最短节长能纺2cm，最长任意，最短间距2cm，最长任意，最大粗度为6倍。

Leaf sheaths loose, villous; leaf blades linear-lanceolate, 5–20 × 0.3–0.9 cm, villous, margins thickened, smooth, base constricted, apex acuminate; ligule 1–3 mm. Racemes terminal, paired, appressed back to back, 5–8 cm, long exserted; rachis internodes and pedicels stoutly cuneate, triquetrous, villous.

叶鞘松散，具长柔毛；叶片线形披针形 5-20 * 0.3-0.9 厘米，具长柔毛，边缘加厚，平滑，基部使收缩，先端渐尖；叶舌1-3毫米总状花序顶生，配对，背靠背贴伏，5-8厘米，长时间外露；节间的轴和略胖楔形，三棱，具长柔毛的花梗。

Begin with collocation designing of slubby yarn's three key elements(slubby length,slubby fine,slubby distance),further set forth the weaving technique of warp slubbed fabric and weft slubbed fabric.

文章从竹节纱三要素，即节长、节距、节粗的搭配设计入手，进一步阐述了经竹节纱和纬竹节纱织物的织造工艺。

As to the problem that the top apron cradle of carbon fiber is of complicated structure and high requirement of elasticity plus difficult cleaning, to upgrade quality of yarn, an introduction is made to the flat top apron cradle RS-6939 regarding its features. Through spinning practice with 100% long fiber cotton J 7.3 tex, J 4.9 tex, 100% fine fiber cotton J 9.7 tex, 14.5 tex, conclusion is made that the flat top apron cradle is of good abrasion resistance and rigidity, free of maintenance, stable quality, good anti-static property, thus being propitious to further upgrading evenness of resultant yarn, reducing slubs and snicks plus cotton neps, especially in production with fine fiber cotton.

针对目前使用的碳纤弹性上销结构复杂，对弹簧要求较高、不易清洁的现状，为了提高纱线品质，介绍了RS-6939型直板上梢的特点，并通过纺J7.3tex（100%长绒棉）、J 4.9tex（100%长绒棉）、J9.7tex（100%细绒棉）、J 4.5tex（100%细绒棉）的纺纱实践，指出RS-6939型直板上销具有较强的耐磨性和刚性，不需维修，质量稳定，杭静电性能良好，对进一步提高条干水平，减少粗节、细节及棉结非常有利，特别是在纺细号长绒棉时，效果更加显著。

Results: The incidence that T2-T5 ganglions located at the corresponding intercostal space was 92.7%, 85.5%, 40.0% and 36.4% respectively.

结果：星状神经节及T2～T5神经节的长径依次是（21.5 3.2）、（10.6 2.8）、（8.5 3.1）、（8.2 2.7）和（7.1 1.8）mm.T2～T5神经节出现在相应肋间水平的发生率依次是92.7%、85.5%、40.0%、36.4%。

On closer examination, though, this is not a vote for multilateralism but just the opposite.

仔细审视后我们发现，这并非是对多边主义投出的赞成票，而是恰好相反。

Uncovering their weak spots, so I can defeat them.

揭露出他们的弱点，这样我就可以打败他们了。