谐振腔

We proved that under some concrete conditions imposed on μ, e and restrictions on the boundary value, the operator of Maxwell's equations becomes a symmetric ...

如果不满足对称性，引入伴谐振腔的概念，所谓伴谐振腔在几何形状上和原来的腔相同，但、和边界条件不一样。

We proved that under some concrete conditions imposed on μ, e and restrictions on the boundary value, the operator of Maxwell's equations becomes a symm...

如果不满足对称性，引入伴谐振腔的概念，所谓伴谐振腔在几何形状上和原来的腔相同，但、和边界条件不一样。

By the optimization of the cavity parameters, the resonator is thermal insensitive, which controlled the astigmatism existing in the folded cavity.

通过优化谐振腔参数，使谐振腔具有热透镜不敏性，有效地控制了折叠腔具有的像散。

Therefore,based on microwave highQ cavity resonator,a new technique of calculating the quality factor through theoretical derivation is presented,which allows flexibility in choice of measurement point.This method solves the problem of coupling system influence,which can cause larger error in measuring.

为此，针对微波高Q谐振腔，给出了一种测量其品质因数的新方法，该方法可以根据实测的谐振曲线灵活选取测量点，有效解决了传统方法中由于谐振腔受外电路影响导致测量误差较大的问题。

A basic theory for constructing cavity resonator with a kind of slowwave transmission lines is presented, the procedure of determining sizes of cavity for a designed resonant frequency is proposed.

分析了盘荷同轴型谐振腔的TM慢波模式，并给出TM主模特征值和谐振频率的计算方程，证明了单一的TM高次模不能作为慢波模式单独存在于这种谐振腔之中，必须由多个高次模共同组成一个谐振模式。

By considering this effect,the realizability and the stability of the cavity can be improved, when a high power and asymmetric laser cavity is considered.

利用激光谐振腔的此性质可以对Kerr被动锁模激光器的谐振腔的设计进行优化，从而提高其锁模的可实现性以及谐振腔的稳定性。

The coupling characteristics of the bicrystal Josephson junction with the Fabry-Perot resonator have been investigated experimently, showing that it was greatly affected by the factors such as the location of the sample in the open resonator, the angle between them, the pattern of the junction and the distance between the two reflecting mirrors of the resonator.

重点研究了双晶约瑟夫森结与Fabry-Perot谐振腔的耦合特性，发现放置在谐振腔中的结的位置、角度、结的图形以及Fabry-Perot谐振腔中两镜面间的距离等对耦合都有很大的影响。

Based on the laser longitudinal mode splitting theory, a novel scheme of dual-frequency laser with large frequency-difference is presented using electrically controlled birefringence of liquid crystal, and the transmitted resonant mode splitting by birefringent of Fabry-Perot etalon has been analyzed theoretically. A new element of liquid crystal Fabry-Perot etalon is designed and fabricated, which serves as aselector and splitter of both laser longitudinal modes and Fabry-Perot etalons transmitted resonant modes. Two different experimental systems of laser-diode end-pumped Nd:YAG laser have been set up using two different LDs, and the transmission of liquid-crystal cell have been measured. When the empty LCFP is inserted in the cavity of high-power LD pumped Nd:YAG laser, the oscillation of a single laser longitudinal mode have been observed, such a result shows that the designed and fabricated LCFP element is capable of selecting single axial mode. While an anti-reflected liquid crystal cell is inserted in the cavity of Nd:YAG laser end-pumped by the high-power LD, it is difficult to confirm weather the laser longitudinal modes have been spitted or not. The subject is summarized in this thesis and the improvement of the project has been presented.

论文以激光纵模的分裂理论为基础，提出了可望获得几十GHz甚至上百GHz的液晶电控双折射双频Nd：YAG激光器的总体方案，并对用双折射效应分裂F-P标准具透射谐振模进行了理论分析；设计并加工了一种集激光纵模选择、激光纵模分裂和F-P标准具谐振透射模分裂于一体的多功能元件——液晶电控双折射F-P标准具；建立了两种不同功率激光二极管端面泵浦的Nd：YAG激光实验系统，并对液晶盒的透射性质进行了测试；将未灌注液晶的空液晶F-P摘要标准具插入大功率LD泵浦Nd：、叭G激光谐振腔内，观察到了单纵模激光输出，说明所设计和加工的液晶F一P标准具具有纵模选择能力；将镀有增透膜的液晶盒插入大功率LD泵浦Nd八7AG激光谐振腔内，是否产生了激光纵模分裂现象还难以确定。

Based on there studies, a new temperature compensation method is proposed to stabilize the resonant frequency of a rectangular resonant cavity.

根据热双金属材料的温度特性，本文提出了一种稳定谐振腔谐振频率、对谐振腔进行温度补偿的方法。

In order to support a preselected resonant mode, a series of concentric rings (18) is formed in the blocking layer (16, 19), surrounding the resonant cavity (2) so as to provide a Bragg structure which reflects light from the cavity with a phase characteristic that supports the preselected transverse resonant mode.

为支持预定的谐振模式，在阻挡层（16、19）中形成一组围绕谐振腔（2）的同心环（18）以提供一种反射腔中的光的布拉格结构，其相位特性支持预定的横向谐振模。

If you are unfortunate enough to the lovelorn, please tell me, I will help you out, really, please contact me!

如果你不幸失恋了，请告诉我，我会帮助你摆脱困境，真的，请联系我啦！

China's plan to cut energy intensity by 20 percent and pollutant discharges by 10 percent between 2006 and 2010 is a case in point.

中国计划在2006年到2010间降低20%的能源强度和减少10%的主要污染物排放，就是一个这样的例子。