松驰的

Results indicated that the variation was significant from treatment to treatment. S-deficiency caused bulging chloroplasts, loosening and dishevelled grana lamella, reducing organelle, and damaged chondriosome in mesophyll cells of the leaves, and empty cells of the roots, while S-excess, however, led to densification, condensation and randomization of grana lamella of the chloroplasts of the leaves, and separation of cytoplasms from walls of the cells of the roots.

结果表明，受S素营养胁迫的水稻，其根系及叶片的超微结构均发生了显著的变化：低S胁迫会造成水稻叶片叶肉细胞内的叶绿体结构肿胀，基粒片层松驰、散乱，细胞器减少，线粒体结构被破坏，根系细胞内几乎没有内含物；S浓度高则会使叶片叶绿体基粒片层致密、浓缩，无规则化，根系细胞发生质壁分离。

Film or paper surface dirty, and wrapped it into the dust or clear plastic mulch films after the crease or relaxation phenomena, film hemming switched to a new membrane drying temperature is too high, adhesive surface crust adjust oven temperature, clear crusts partⅱ thermotolerance cohesion and not enough use better glue wrinkle of polymer-coated film transfer after the roll is not the proper balance of films at both ends are inconsistent or wave; adjustment layer of polymer-coated machine too thick, solvent evaporation incomplete, viscosity, pressure drum extrusion, paper (Business card printing and membership card making products) and films between slide to adjust the film covering technology electrothermic roll and rubber roller ends is not plain, pressure is inconsistent, ranging from the adjustment of the linear speed of the machine after the temperature inside the plastic mulch film covering the subject in yellow glue resin particularly resin or additives not resistant to ageing, in the light, heat, under the influence of ultraviolet radiation, chemical change, build the pigments should be switched to a new glue

薄膜或纸张表面不干净，裹入灰尘或杂质清除后再行覆膜薄膜有折皱或松驰现象，薄膜卷边换用新膜干燥温度过高，粘合剂表面结皮调整烘道温度，清除结皮胶的粘接力和耐热性不够换用更好的胶水覆膜后起皱薄膜传送辊是否不平衡；薄膜两端松紧不一致或波浪边；调整覆膜机器胶层过厚，溶剂蒸发不彻底，影响了粘度，受压力滚筒挤压，纸张与薄膜之间产生滑动调整覆膜工艺电热辊与橡胶辊两端不平、压力不一致、线速度不等调整覆膜机器覆膜后易变黄胶水中的主体树脂特别是一些增粘树脂或助剂不耐老化，在光、热、紫外线的影响下，发生化学变化，生成有色物质应换用新胶水

In the computation of aerodynamic forces, the present work is based on the work of Morino et al., but the following aspects are improved:(1) In computing the steady transonic aerodynamic load, the steady transonic nonlinear integral equation is solved by relaxation-iteration method in this thesis, instead of solving the time dependent transonic nonlinear integral equation, so that the computing time is saved greatly;(2) The influence coeifficients represented by volume integral are transformed to surface integral by using the Gaussian Theorem, so the analytical form of these coeifficients can be obtained and this leads to be more convenient to analyse and compile computer program;(3) The shock capturing method is used in every time step in present work, no shock moving term is added in the integral equation, so that it is more convenient and simpler to treat.

在气动力计算方面，本文基于Morino等人的工作，作了如下几方面的改进：（1）在计算定常跨音速流场（作为非定常绕流计算的初场）时，本文采用松驰迭代法直接求解跨音速定常非线性积分方程，而不是采用时间相关法求解非定常非线性积分方程，这样大大节省了计算机时；（2）将以体积分形式出现的影响系数化为面积分，并获得解析公式，这样便于分析和编写程序；（3）对运动的激波，本文通过在每一个时间步长上采用激波捕捉法而得到，而不是在积分方程中附加激波运动项，因而处理起来简单方便得多。

The main content includes that the accuracy of interpolation operators is creased since defect equations introduce less error: Gauss-Seidel solution can save effectively the computational time, in particular, the CPU-time for the setup phase; Jacobi-relaxation interpolation contributes to efficient and robust algebraic multigrid methods by a simple and purely algebraic mean.

最主要的内容是基于亏量方程引入的误差较小，从而进一步提高插值算子的精度；采用Gauss-Seidel解法有利于节省计算时间，特别是预备阶段的CPU时间；插值的松驰以一种简单的纯代数的方式获得高效且稳健的代数多重网格算法。

From the 0 degree to 130 degree at per 10 degree migration changes of anteromedial and posterolateral bundle of the ACL were measured in comparison with the migration at 90 degree in the condition of no force and vertical force of 50 N.

分别在不受力和受纵向力50N的状态下在膝关节屈曲0度到130度之间每隔10度测量前内侧束和后外侧束相对于90度时的位移变化；并通过固定金属标记物分别推算两束的松驰和紧张时的角度。

The new sequential penalty functionmethod stems from the smoothing technique for nondifferentiable optimization prob-lems,and the two point barrier function method is based on Mangasarian's normal so-lution theory of linear programming.

新型序列罚函数方法的思想来自于非光滑优化问题的光滑化技术，而双点障碍方法的思想来自线性规划最小模松驰法。

The derivation of the method is papered in highly paralleled relaxed Newton method for transient stability real-time simulation-paralel algorithm.

关于该方法的导出在《基于高度并行松驰牛顿方法的暂态稳定性实时分析计算的并行算法》［1］中发表。

The effect of training, prestrain amount and recovery annealing temperature on the shape memory effect, the absolute shape recovery ratio , and the superelasticity of Fe14Mn6Si9Cr5Ni alloy is studied.

研究了训练、预应变量和退火温度对Fe14Mn6Si9Cr5Ni合金的形状记忆效应、绝对形状回复率和超弹性的影响，测定了合金的蠕变和应力松驰特性，讨论了降温ε马氏体对形状记忆效应的间接贡献。

According to the ac cident survey and the field test data,the paper analyses the reason of tower body discharge due to jumping wir e, solves the problem fundamental way to reduce wind oscillation of jump l ine insulator string and the relaxation degree of jump line.

根据事故概况及现场测试数据，通过计算就跳线对塔身放电原因进行了认真分析认为解决引流跳线对塔身放电最根本的措施是要减小跳线绝缘子串的风偏摆动和减小跳线的松驰度。

It is known,spinning the as-spun yarn at a speed 3 000m/min.,after being properly drawn and thermoseted,the industrial yarn canbe with properties:tenacity--7.1 cN/dtex,modulus(tenacity at 5%elongation)--higher than 4.4cN/dtex,thermal shrinkage in 1 77℃hotair for 10 min.

实验结果表明，在3000米/分纺速下的卷绕丝经过牵伸、紧张热定型及松驰热定型等工艺过程，纤维的性能可达：断裂强度7.1cN/dtex，模量(5%伸长时的应力)大于4.4cN/dtex，干热收缩率小于2.9%(177℃，10分钟)。

Cynanchum Lingtai apricot production in the average weight 65 grams, the brightly-colored fruit, juicy rich, sweet-sour taste, sweet from the nucleolus, when the late Qing Dynasty famous Shaanxi, Gansu provinces, the Qing imperial court Tongzhi tribute for years.

灵台生产的牛心杏平均单果重65克，果实色泽鲜艳，汁多味浓，甜酸适口，离核仁甜，清末时就驰名陕、甘两省，清同治年间曾为朝廷贡品。

Chenopodium album,Solanum nigrum, and Amaranthus retroflexus were very susceptible to the herbicides. Polygonum persicaria and Abutilon theophrasti were relatively less susceptible to the herbicides, and Lycopersicon esculentum was not susceptible to it. The relationship between reduction rates of weed biomass and PPM values of weed leaves 2,4, and 6 days after treatment was established.

供试的6种杂草对该混剂的敏感性存在显著差异：红心藜Chenopodium album、龙葵Solanum nigrum和反枝苋Amaranthus retroflexus对该混剂最敏感，ED90值分别为47.65、71.67和29.17g/hm2；春蓼Polygonum persicaria和苘麻Abutilon theophrasti敏感，ED90值分别为96.91、114.20g/hm2；而番茄不敏感。