时效

Short time bar and specific time bar intermit in B/L system easily results in time bar invalid.

特别是无船承运人提单和代理签发的提单识别困难，提单制度的短时效和特有的时效中断规定使得承运人识别错误容易导致时效过期。

The effects of trace Ce and La on the damping capacity of aged Zn-22%Al have been studied using TEM,SEM and room temperature low frequence torsional pendulum damping meter.

采用自然时效、人工时效等热处理工艺，借助透射电镜和室温低频扭摆内耗仪，研究了微量Ce，La对高阻尼Zn-22%Al合金时效后显微组织和阻尼性能的影响。

The results show that La can refine the microstructure of Zn-22%Al alloy, slow down the grain growth and reduce the equiaxial degree during ageing, that the strength of Zn-22%Al-alloys and Zn-22%Al alloy remains constant after ageing below the warm-rolling temperature, and that La can improve the strength and the stability of mechanical properties of Zn-22%Al alloy.

结果表明：La具有细化Zn-22%Al合金的组织并阻碍时效时晶粒长大和等轴程度降低的作用；在低于温轧温度(80 ℃)下时效时，加La和不加La的Zn-22%Al合金的室温力学性能保持不变； La可提高Zn-22%Al合金的强度以及时效时力学性能的稳定性。

The applied scope of the extinctive prescriptions is the scope of the civil legal relations and civil rights in which the extinctive prescriptions can be applied.

一、问题的由来诉讼时效制度的适用范围，传统民法理论上一般又称诉讼时效的客体或称对象，是指诉讼时效制度适用于哪些民事法律关系或民事权利。

Acquisitive prescription system will not only be conducive to ending disputes, establish property ownership, stable socio-economic and legal order. But also pay more attention to the effectiveness of property, safeguard the security of transactions. Moreover, acquisitive prescription system is not replaced by good intentions to obtain and extinctive prescription.

取得时效制度不仅有利于定分止争，确立财产的归属，稳定社会经济秩序和法律秩序，而且更注重物的效用，发挥财产的效用，维护交易的安全，况且取得时效制度也不能由善意取得和诉讼时效来替代。

The applied scope of the extinctive prescriptions can be classfied into three kinds:"the extinction of obligatory properties";"the extinction of obligatory rights and other non-ownership properties" and "the extinction of rights of claim".

诉讼时效制度具有广泛的适用性，许多的民事法律关系都可以适用诉讼时效制度；但法律出于对某些民事法律关系予以特殊保护的重要性，以及某些民事法律关系自身所具有的特殊性而不能或不应适用诉讼时效制度。

In this thesis, the phase diagram of Zn-Al binary system on 10~69.5 w% was reinvestigated by using differential scanning calorimeter, X-ray diffraction and pushrod dilatometer. The process of isothermal transformation during the aging of high-Aluminum-Zinc-based alloy was studied by using differential scanning calorimetry, and the aging behavior of the alloy was analyzed at the aspect of thermal analysis kinetics. The change of microstructure which the alloy was being heated was observed on high-temperature metallurgical microscope. The microstructure and wear-friction properties were compared among the alloys treated with several different heat treatment processes, and a model for heat treatment processes was proposed based on artificial neural network,so as to predict the relationship between friction coefficient and parameters of aging treatment such as aging temperature and time.

本文采用高温X射线衍射、示差扫描量热分析、热膨胀等方法重新测定含锌量范围为10％～69.5％的Zn-Al系二元相图，利用示差扫描量热分析法，研究高铝锌基合金时效等温转变过程，并从热分析动力学的角度分析高铝锌基合金合金时效行为；使用高温金相显微镜观察合金加热时的组织变化；比较几种不同热处理工艺对高铝锌基合金显微组织与耐磨性能的影响并利用人工神经网络建立高铝锌基合金热处理工艺模型，预测合金摩擦系数随时效温度及时间变化规律。

In this project, the selection criteria of matrix and reinforcement for obtaining composites with high strength and toughness are determined. The as-cast and aged microstructures of composites reinforced with particles of different strength are observed, and their metallurgical conditions and stabilization mechanisms are analyzed. The aging precipitation behaviors and mechanisms are studied. Some characteristics of nano-materials (micro-distortion areas) are found in 150nm- Al2O3p/Al composites and their formation mechanisms are expatiated. The "flexible" restriction to the deformation of the matrix by low strength AlN particle is observed by in-situ TEM and SEM techniques, and the mechanisms of its resist on cracks propagation and its contribution to composite strength are revealed. The high temperature deformation behaviors of Al2O3p/Al composites are studied. A rare-earth coating is established on sub-micron Al2O3 particles, leading to an improvement in wettability between coated Al2O3 and liquid aluminum and a decrease in infiltration pressure. The strength and ductility of coated particles reinforced composite are also increased. The interfacial characteristics, bonding structures and their formation mechanisms are studied, and the crystal orientation relationships between reinforcement particles and aluminum matrix are investigated. Finally a lighter composite with better balance of strength and damping properties is reinforced with hollow ceramic microballoons of ultra-lower strength.

本项目发现了获得高强度和高韧性复合材料的基体、增强体选择依据；观察了各种强度质点增强复合材料的铸态和时效态微观组织，分析其微观结构形成的金属学条件及稳定性机理，研究了其时效析出规律和时效机制，发现了150nmAl2O3颗粒增强铝基复合材料基体中的纳米材料特征，并解释了其形成机理；利用TEM和SEM动态拉伸技术发现了低强度质点AlN颗粒对变形协调的&柔性强化&机制，揭示了其对裂纹扩展的阻碍作用和对复合材料高强度的贡献；研究了中强度质点的Al2O3颗粒增强铝基复合材料的高温变形行为，并对其进行了稀土界面层设计与制备，改善了颗粒与铝合金之间的界面润湿性，降低了复合材料铸造渗透压力，提高了复合材料的强、韧性；研究了多种复合材料界面结构及形成机理，确定了增强体与基体之间的界面结合机制，分析了复合材料界面处的晶体学位向关系；最后制备了含微孔的中空型陶瓷颗粒增强的特种复合材料，得到了强度和阻尼综合性能较好的轻质复合材料。

The effects of single aging,duplex aging and conditions between the first and second step agings on the microstructures and properties of the extruded plate of 7050 aluminium alloy were investigated,by means of TEM,tensile and conductivity tests.

采用力学性能和电导率测试及透射电镜组织观察的方法，研究了7050合金挤压带板的单级时效、双级时效及两级时效之间处理条件对合金组织和性能的影响。

The effect of experiment duration and the factors influencing the valid duration of model test are analyzed based on the experimental data given by predecessors obtained from conceptual models carried out in flumes.

结合对概化水槽试验的分析，论述了河流自然模型试验时效的定义、实质及其影响因素，初步得出试验时效与河床组成、河谷比降以及流量的关系，并提出时效的判定指标。

If you are unfortunate enough to the lovelorn, please tell me, I will help you out, really, please contact me!

如果你不幸失恋了，请告诉我，我会帮助你摆脱困境，真的，请联系我啦！

China's plan to cut energy intensity by 20 percent and pollutant discharges by 10 percent between 2006 and 2010 is a case in point.

中国计划在2006年到2010间降低20%的能源强度和减少10%的主要污染物排放，就是一个这样的例子。