性能

The research is to develop a new material----high performance concrete of hill sand on the basis of practice of high strength concrete of hill sand and knowledge of ultra-fine trass additive by using concrete material in Guizhou and mixing fly ash.

本文通过对配制的山砂高性能混凝土和普通混凝土的拌合物性能、力学性能、长期性能及耐久性能的研究，得到流动性、保水性、粘聚性等性能优良的山砂高性能混凝土。

Some revision of the compressor characteristics and the turbine sections has been made to accommodate the increased pressure ratio, the increased airflow and the moisture and heat addition in the saturator. Based on the HAT gas turbine, the part load performance of HAT cycle has been gained.

本文推导了HAT循环燃气轮机稳态性能数学模型，并分别研究了各换热器的变工况性能，在此基础上，本文对HAT循环燃气轮机的变工况性能进行了研究，得出HAT循环具有变工况性能好的结论。

Effects of scandium addition on the microstructure and properties of Al-5.3Cu-0.8Mg-0.6Ag-0.2Zr (mass fraction,%) alloy were investigated using optical microscope, scanning electron microscopy and transmission electron microscopy, tensile testing and intercrystalline corrosion testing.

通过金相、扫描电镜、透射电镜、性能测试等实验方法，研究了Sc对铸态Al-5.3Cu-0.8Mg-0.6Ag-0.2Zr合金的组织和性能影响。结果表明，添加0.10 %～0.5 % Sc后，在室温到300 ℃测试范围内，合金的室温拉伸强度、高温耐热性能及晶界腐蚀性能得到了改善。

The mechanical behavior of Shape Memory Alloys material is tested, and the constitutive model of the SMA is established. A kind of SMA combined rubber isolator is developed, and the isolation effect of the SMA combined rubber isolator for long-span bridge and tall building structures is numerically simulated, from which the adaptive isolation performance and the self-restoring capacity of the SMA combined rubber isolator are verified. A kind of SMA damper is developed, the mechanical behavior of the SMA damper is tested, and the model of restoring force of the SMA damper is established. The theory and method of adaptive control based on the SMA damper for the long-span bridge are built, and the effectiveness and reliability of the adaptive control for the long-span bridge using the SMA damper are verified through numerical simulation and model test. The MRF-04K type magnetorheological damper is developed, the mechanical behavior of the MR damper is tested, and the model of restoring force of the MR damper is established. The theory and method of adaptive control based on the MR damper for the long-span bridge and tall building structures are built, and the effectiveness and reliability of the adaptive control for the long-span bridge and tall building structures using the MR damper are verified through numerical simulation and model test. In addition, the theory and method of sub-structural damage identification for long-span bridge are derived, the influence of soil-structure dynamic interaction on the seismic isolation and control effects with different isolation and control measures and the damage responses and the sliding base-isolation of large structures under the excitation of underground explosion are investigated.

试验研究了形状记忆合金材料的力学性能，建立了SMA材料的本构模型；研制了一种SMA复合橡胶隔震支座，数值仿真分析了应用SMA复合橡胶支座的大跨桥梁和高层建筑结构的隔震效果，从而验证了SMA复合橡胶支座的自适应隔震性能及其震后自恢复能力；研制了一种SMA阻尼器，试验研究了SMA阻尼器的力学性能，建立了SMA阻尼器的恢复力模型，建立了基于SMA阻尼器的大跨桥梁结构自适应控制理论与方法，通过数值仿真与模型试验验证了大跨桥梁结构SMA阻尼器自适应控制的有效性与可靠性；研制了一种MRF-04K型磁流变阻尼器，试验研究了MR阻尼器的力学性能，建立了MR阻尼器的恢复力模型，建立了基于MR阻尼器的大跨桥梁和高层建筑结构的自适应控制理论与方法，通过数值仿真和模型试验验证了大跨桥梁和高层建筑结构MR阻尼器自适应控制的有效性与可靠性；还建立了大跨桥梁结构的子结构损伤识别的理论与方法，研究了土-结构动力相互作用对不同隔震和控制措施的减震控制效果的影响以及地下爆炸波作用下各类大型结构的灾害响应与滑移隔震。

Fluorin boric acid acidification system's acid liquid delay corrode,matching,delay velocity capability,sullage test,iron ion stabilization test,depend expanding capability was evaluated through static state and rock core acidification dynamic test.

对石南油田选用的氟硼酸酸化体系从酸液缓蚀性能、配伍性能、缓速性能、残渣试验、铁离子稳定试验、防膨性能等方面进行了较全面的室内静态评价和岩芯酸化动态评价。

The influences of different kinds of conducting materials and their contents and different volume of PVC grain on the electrical property,mechanical properties and terrazzo lines of the floor were studied.

采用特殊成型方法，研制类似网络结构的水磨石形式的抗静电地板，研究了多种导电材料及其不同用量对网络地板导电性能、力学性能和地板纹路的影响；研究了PVC颗粒大小对地板的导电性能、力学性能和地板纹路的影响；对体积电阻率曲线用三次方程进行了拟合，得到体积电阻率与含量的函数关系，并发现其具有很好的相关性。

First of all, the paper carried out test study on four two-spanned model members of FSMRCWB, including three 1/2-scaled two-storeyed models and one 1/3-scaled three-storeyed model. The paper analyzed the test results, including analysis on mechanical property of the composite wall beam under vertical loads, and failure mode, deformation capacity, aseismic performance under horizontal loads and constant vertical loads. Secondly, the nonlinear property of concrete is studed and the nonlinear models of FSMRCSS is builded by ANSYS. Last, The paper studies the result of ANSYS, which mainly includes the loading-displace curve of FSMRCSS under horizontal loads and constant vertical loads, the mechanics of arch under vertical loads lonely and under horizontal loads and constant vertical loads respectively, and status of the distribution and changing of vertical stress and cross shear on the surface of the suporting beam, and the influence of span ratio and hole.All in all, the caculating results are in good agreement with the test results.

本文首先进行了三个1/2比例的两跨两层和一个1/3比例的两跨三层的框支密肋复合墙梁的模型试验，分析了框支密肋复合墙梁在竖向荷载作用下的受力性能，以及在竖向荷载与水平低周反复荷载共同作用下的受力性能、变形性能、滞回性能、耗能系数及破坏形态；其次，研究了混凝土的非线性特性，建立了框支密肋复合墙梁非线性有限元模型，并借助大型通用有限元软件ANSYS进行计算；再则，进行了非线性有限元结果分析，主要研究框支密肋复合墙梁在竖向荷载与水平地震力共同作用下的荷载位移曲线，分析在竖向荷载单独作用下和在竖向荷载与水平地震力共同作用下墙梁的拱作用，托梁顶面的竖向应力和横向剪应力分布及变化情况，并讨论跨度比、洞口对墙梁拱作用和托梁顶面的竖向应力的影响。

All of the properties of the sheet were tested. The results show that the mechanical and heat-resistant properties of the supporter can meet the requirements of turbogenerator, and the cost is relatively lower.

通过对支架的力学性能和热稳定性能进行测试，结果表明其性能尤其是力学性能和热稳定性优异，完全能满足发电机端部支架的技术要求。

First of all, vertical load function test of function, we workingbench designed to need to carry on vertical loaded analysis to guide mainly, can be drawn lessons from method of the analysis of performance of vertical load,etc.

首先，垂直载荷作用下的性能测试，我们需要设计的工作台主要就是对导轨进行垂直载荷的分析，针对垂直载荷性能分析的方法等都可以在具体的加载方案中可以借鉴，再次是对侧面载荷作用下的性能测试的分析，最后对力矩作用时性能测试的结果也作了详尽的分析，其作用在加载方案的选择上面有一定的意义。

So we must seek for new coating technique and new wearable material to improve wearability,load property and adaptability of bearing material,to suit for the development of productivity.

因此必须寻找新的涂层技术和性能优良的耐磨材料以改善轴承材料的耐磨性能、承载性能及适应性等力学性能，提高轴承的使用寿命，以适应生产力发展所提出的要求。

What are your goals and strategies for growth?

你的成长目标和策略是什么？

And unto the angel of the church in Sardis write; These things saith he that hath the seven irits of God, and the seven star I know thy works, that thou hast a name that thou livest, and art dead.

3：1 你要写信给撒狄教会的使者，说，那有神的七灵和七星的，说，我知道你的行为，按名你是活的，其实是死的。