形成的

Meanwhile, the concentration of Pb,Zn and other heavy metals is rather high in the oxidation zone and decreasesdownward to levels that are unbelievably low for Pb-Zn mine tailings. Theseobservations suggest that heavy metals should be re-immobilized by secondaryminerals, rather than primary minerals, in the oxidation zone, and could be leachedout from suboxic environment due to low rate oxidative dissolution which preventsthe precipitation of secondary minerals in significant amount. Thus, cover scenarioswhich establish a suboxic environment beneath the cover layer might not always beeffective in preventing heavy metal release from mine tailings.Sequential extraction studies indicate that, in addition to heavy metal leaching,oxidation of the mine tailings increased the mobility of residual Zn, and Cu, while Pb remains immobile due to the formation of anglesite (PbSO4). Using the seven-step extraction technique developed by Dold (J. Geochem. Explor., 2003, 80: 55-68), galena dissolves in significant amount at step 2 most probably due to the strong complexing of Pb2+ by acetate, while other metal sulfides dissolve at step 6, which suggest that this extraction technique could not be used to evaluate the mobility of lead in natural environment

重金属含量均低于新鲜尾矿，但以硬化层中的含量最高(Pb、Zn含量分别为0.47%和0.93%)，往下大幅度降低，表明尾矿风化过程中形成的次生矿物对Pb、Zn等重金属元素有较强的固定作用，而次氧化带的淋溶作用造成了金属元素的大量流失；(4)与新鲜尾矿相比，硬化层中铅的可迁移性大大降低，硬化层之下尾矿样品中铅的可迁移性也不同程度降低，这是由于硫化物氧化产生的硫酸根与尾矿中的铅反应形成铅矾(PbSO_4)的缘故；(5)氧化作用使尾矿中的zn、Cu等重金属的可迁移性不同程度地增大，其中对锌的可迁移性影响最大，铜的可迁移性与铁比较相似，铅则容易与硫化物氧化形成的SO_4~(2-)反应形成铅矾(PbSO_4)；(6)为了减少尾矿污染和修复矿山环境，人们提出了各种不同的尾矿覆盖方案，本文的研究结果表明，这些方法不一定能够有效地阻滞污染元素的迁移。

The following conclusions can be obtained through above studies:(1) High density of different species algae are accumulated on the surface of savageness and artificialness filling in the city riverway. The activity of charcoal filling biofilm were much high than the biofilm of plastic filling and plants root of floating carriers.

通过上述研究，得出以下结论：(1)城市河道天然或人工填料基质表面所形成的生物膜膜均附着高密度的藻类，木炭和竹炭形成的生物膜活性高于弹性立体填料及浮床植物根系所形成生物膜活性。

A device and method for preparing compound nano fiber endless tow, which contains feeding material liquid to pair of electric spinning nozzle on frame, each nozzle respectively applied with high dc voltage with opposite polarity, each pair of nozzle jetting out nano fiber with opposite electric charge, said nano fiber attracting and colliding each other to form compound nano fiber, then forming nano fiber endless tow after drawing and stretching, the first opposite set pair of electric spinning nozzle jetted compound nano fiber endless tow is stretched down and used as acceptor which covered by the nano fiber jetted by second pair of nozzle an d forming two layers of compound nano fiber endless tow after drawing and stretching, in turn to get multilayer compound nano fiber endless tow after drawing and stretching by godet roller.

复合纳米纤维长丝束制备装置及其制备方法是一种简单、高效电纺制备纳米纤维长丝束的方法，其步骤为将料液输送给支架(3)上的电纺喷头对(1)；喷口相向的电纺喷头对(1)的每个喷头分别施加相反极性的直流高电压；每对相向喷口喷出分别带相反电荷的纳米纤维，并在空中相互吸引、碰撞形成复合纳米纤维，经牵引、拉伸后形成复合纳米纤维长丝束；第一对相向放置的电纺喷头纺丝形成的复合纳米纤维长丝束向下拉伸，并作为接受体与第二对电纺喷头喷出的分别带相反电荷并相互吸引的纳米纤维在空中相遇，被第二对电纺喷头喷出的纳米纤维包裹，经牵引、拉伸后形成两层复合纳米纤维长丝束；依次类推，最后经导丝辊对(2)牵引、拉伸后得到多层复合纳米纤维长丝束。

In this paper, the Iron-oxide-coated sand absorption character prepared in different temperatures was studied, mainly tested its absorb hexad chromium, and the inherent reason that formed this differences was explained.

本文研究了不同温度下制备的铁覆膜砂吸附性能的差异，对铁覆膜砂吸附Cr的性能进行了综合的测试，说明了形成这些差异的内在原因制备温度对IOCS的吸附性能有显著影响，一般低温制备的IOCS要比高温制备的铁覆膜砂吸附性容量较大，去除效率较高；覆盖在石英砂表面的铁氧化物在不同的焙烧温度下形成了不同的物质，110℃的低温一般形成FeOOH，而600℃高温下形成的则为α-Fe2O3。

The formed long and linear chain alkyl benzene changes into benzene methyl and alkene through β-scission and monomolecular homolysis, and then benzene methyl shifts to the position of α-Carbon in the long chain alkyl benzene through H-transfers.

已形成的长直链烷基苯通过β分裂、单分子均裂形成苯甲基、烯烃，苯甲基通过氢转移到长链烷基苯的α碳上，烯烃再与α碳结合形成带支链的烷基苯。

The second chapter discusses the deep-layer reason of the formation of the belief from the two layers-classical thought and the general knowledge, thought and belief, analyzes deeply the factors of promoting the formation of the belief. We think the decisive power for the formation of the belief was still man" s longing for everlasting life, happiness and freedom. The human-centered reason provoked directly man" s wishes of magnifying life power and seeking the freedom of spirits; The turbulent social environment stimulated man s thirst for life and happiness; The free atmosphere of thought made it possible for the people to develop fully their imagination and to show fully the power of human nature; The thought of Taoist School and Yin-Yang Wu Xing provided the theory basis for the formation of immortal belief.

本文第二章从精英思想和一般知识、思想与信仰两个层面上探讨神仙观念形成的深层动因，对促进神仙观念形成的各种因素进行深入分析后，认为，对神仙观念形成起决定作用的仍是人们对生命永恒与快乐自由的追求，"人本理性"直接刺激了人们张大个体生命力量、追求精神自由的深层愿望；动荡、混乱、战争频仍的社会环境激发了人们对生存与快乐的渴望；自由的思想氛围使人们可以充分发挥他们的想象，充分彰显人性的力量；道家、阴阳五行思想为神仙信仰的形成提供了理论依据。

Scanning electron microscopy,transmission electron microscopy,circular dichroism and small-angle X-ray diffraction were used to analyze the aggregation mode of CSG in the organogel phase.A hierarchical self-assembly model was proposed to explain the transition from molecular to primary and secondary structure.It is shown from our results that CSG can aggregate into a micellar fibril nanostructure with high length-to-width ratio which is bundled and entangled to form a three-dimensional(3D) network that immobilize the fluid component probably by surface tension.Moreover,sol-gel polymerization of tetraethoxysilane was carried out using CSG in the gel phase.

通过扫描电镜(ScanningElectron Microscopy，SEM)、透射电镜(Transmission Electron Microscopy，TEM)、圆二色谱(Circular Dichroism，CD)和小角X—射线衍射仪(Small-angle X-rayDiffraction，SAXRD)考察CSG分子自组装行为结果表明，CSG形成的聚集体具有多级结构：首先CSG通过手性堆叠自组装形成直径在9—10nm的细纳米纤维，这些细的纳米纤维再以不规则的六方堆积的方式进行排列，构成直径在40—100nm的粗纳米纤维(即细纳米纤维的&捆束&)，最后粗纳米纤维互相粘连形成三维网络状结构，使有机溶剂&固定&，从而形成凝胶；以CSG有机凝胶为模板，四乙氧基硅烷为前体，通过溶胶—凝胶聚合的方法制备了直径大约为100nm的二氧化硅纳米管。3。

By analyzing the metallographical characteristic of the secondary short circuited melted bead fomed in different conditions,the law of the metallographical characteristic of the secondary short circuited melted bead changing by different conditions is obtained.

通过对在不同条件下形成的二次短路熔珠的金相组织分析，得出了二次短路熔珠随形成条件的不同金相组织的变化规律，找出了铜导线二次短路熔珠在消防射水影响下形成的金相组织与国家标准给出的二次短路熔珠不同的组织特征，并分析了形成不同于国家标准的特征的原因。

After two hundred years, the French-Canadian society had taken shape, which has been the most important pole in the structure of the Canadian society. The French-Canadian is the character of Canada, and the base of formation of the political principles.

经过两百年的经营，法裔社会渐渐形成，而法裔社会的形成则意味着日后加拿大社会结构中至关重要的一极的形成，法裔的存在是加拿大社会的特质，是日后政治原则形成的基础。

Results of non-reducing sodium dodecyl sulphate polyacrylamide gel electrophoresis of the supernatant and aggregate precipitate formed in refolding process show that except being refolded to native egg white lysozymes, the reduced-denatured lysozymes can also form the aggregates with molecular weights being separately about 30.0 and 35.0 kD, while the reducing SDS-PAGE and the refolding results in the presence of sodium dodecyl sulphate show that these aggregates are formed chiefly through the misconnection of disulfide bonds between the reduced-denatured lysozymes, and the aggregate precipitates are formed through the non-covalent interactions between the aggregates with molecular weight being about 30.0 kD.

复性过程形成的上清和集聚体沉淀的非还原电泳结果表明，除了能复性成天然态的溶菌酶分子外，还原变性蛋白溶菌酶同时还能形成分子量分别约为30.0KD和35.0KD的蛋白溶菌酶分子集聚体；而它们的还原电泳和在SDS存在时的复性结果表明，这些集聚体主要是通过还原变性蛋白溶菌酶分子间的二硫键错配而形成，而集聚体沉淀则是通过分子量约为30.0KD的集聚体分子之间的非共价相互作用而形成。

I am sure after a few weeks of adaptation and familiarization I will have no difficulty in functioning on a daily basis in an English speaking society or in participating fully in graduate studies.

在大学的三年的学习生活不仅给予我自身的充实，更重要的是磨练和培养了我较强的自觉能力和严谨，踏实的作风以及不怕困难的精神，对未来充满了信心！

As the first volcanoes erupted, one of the gases that bellowed out was steam.

在第一批火山喷发时，喷出的气体之一就是水蒸汽。