中板的

Based on the domain superposition method and the differential cubature method as well as the Levy s general solution technique, a new semi-analytical solution has been developed in this paper, for free vibration analysis of moderately thick plates with abrupt thickness.

采用Mindlin中厚板理论，基于Levy解法和微分容积法，给出一种求解轴向受压的阶梯式变厚度板的自由振动问题的半解析解，板的边界条件为两对边简支、另两边任意。

I think today's market's big rebound is still benefited from the news of the positive changes, in fact, several previous blog, I have repeatedly mentioned the importance of the message surface changes, but fortunately, the message is very disappointing, there have been positive changes, yesterday After the close, the SFC message out to safeguard market stability, the Commission Vice Chairman Liu Xinhua, said:"To ensure a smooth launch of the GEM, smooth operation," this sentence is very important ah, sources said that the GEM Bank rate was only 3.68%, departments is very anxious, I opened two days trading software, that information will be prompted to me:"GEM is drawing near, open an account in order to avoid congestion, allow investors to open an account in advance"!

我觉得今日大盘的大反弹依然是得益于消息面的积极变化，其实前几篇博客中我不止一次提到了消息面变化的重要性，还好，消息面很争气，出现了积极变化，昨天收盘后，证监会消息全力维护市场稳定，证监会副主席刘新华称："确保创业板顺利推出，平稳运行"，这句话很重要啊，有消息称，创业板的开户率仅3.68%，有关部门很着急，最近两天我打开交易软件时会有消息提示我："创业板临近，为避免开户拥堵，让投资者去提前开户"！

In the study of moisture absorption and desorption in composites, Fick s law is often used to describe the diffusion process of water in the composites.

在研究复合材料层合板的吸湿和退湿过程中，常常采用菲克定理来描述水分在层合板中的扩散过程。

Based on the request of filter press, better filter cloth was choose and on the bases of calculation by using I-deas8.0 software, the structure of draw-plate was improved, and the filter gasket of filter press was redesigned.

根据本课题中板框压滤机的要求选择了合适的滤布，利用有限元软件I-deas8.0对滤板进行了受力分析，并在此基础上进行结构改进设计；同时对拉板装置、压滤机的滤圈进行了改进设计。

After take analyzed deeply for the opened magnet circuit with FEMM (Finite Element Method Magnetics) we find out the field distributing that is separated into three sections . One is the main area what we called as positive field section. Beside the main field there are tow areas that are called the inverted field sections. Loudspeaker arise a very serious distortion when the voice coil moving into inverted field areas. The direction of induced current in the coil part of entered inverted field area is same with the current driving into loudspeaker so that total currents increas largely and heat increase rapidly. With more coils moving into inverted area the voice coil will take on negative inductance properties. It is the main reason that voice coil is burned by heating with increasing current due to arise negative inductance. So opened magnetic circuit is not suitable for the woofers in which the voice coil have wider displacement range. When using this kind magnetic circuit design, the voice coil moving range should be less than the range of positive field to avoid loudspeaker arise serious distortion and heating. Even though voice coil moving range is in the positive area, loudspeaker will still arise more distortion because the field distribution is very cliffy at tow sides of the positive area and full range of magnetic field distribution is not parallel that will arise distortion. Base on above reasons, opened magnetic circuit is not an ideal magnetic circuit for low-frequency loudspeakers. But it can be used in mid-range or high-frequency productions.

开式磁路是由2片钕铁硼磁铁和主导磁板和导磁垫片组成，我们在实践过程中发现这种磁路结构不适合于低频扬声器的使用，我们通过使用FEMM（Finite Element Method Magnetics）软件包对该磁路进行了分析，该磁路的磁场范围被分成3个区域，其中在主导磁板附近形成一个正向磁场，在正向磁场的两边存在反向的磁场，音圈在工作时有很大一部分进入了反向磁场中，在反向磁场内线圈的感应电流方向与驱动电流方向相同，使得音圈呈现出负感抗特性，由于音圈的负感抗特性引起电流的增加导致音圈发热甚至烧毁，因此在扬声器中使用开式磁路时，音圈的运动范围应控制在正向磁场范围之内，否则音圈运动到反向磁场区域时将会产生很大的失真和发热，即使在设计时已经将音圈的运动范围控制在正向磁场范围之内，由于正向磁场的2个边缘磁场强度衰减太快，同时开式磁路中磁场的分布不是平行的，而是自由发散的分布，这样肯定会导致扬声器的非线性失真，因此我们得到的结论是：开式磁路并不是一个理想的磁路，它不适合于低频扬声器的使用，但它还可以应用于中高频扬声器。

The opened magnetic circuit is composed as tow NdFeB permanent magnets and a top plate without U-yoke. After take analyzed deeply for the opened magnet circuit with FEMM (Finite Element Method Magnetics) we find out the field distributing that is separated into three sections . One is the main area what we called as positive field section. Beside the main field there are tow areas that are called the inverted field sections. Loudspeaker arise a very serious distortion when the voice coil moving into inverted field areas. The direction of induced current in the coil part of entered inverted field area is same with the current driving into loudspeaker so that total currents increas largely and heat increase rapidly. With more coils moving into inverted area the voice coil will take on negative inductance properties. It is the main reason that voice coil is burned by heating with increasing current due to arise negative inductance. So opened magnetic circuit is not suitable for the woofers in which the voice coil have wider displacement range. When using this kind magnetic circuit design, the voice coil moving range should be less than the range of positive field to avoid loudspeaker arise serious distortion and heating. Even though voice coil moving range is in the positive area, loudspeaker will still arise more distortion because the field distribution is very cliffy at tow sides of the positive area and full range of magnetic field distribution is not parallel that will arise distortion. Base on above reasons, opened magnetic circuit is not an ideal magnetic circuit for low-frequency loudspeakers. But it can be used in mid-range or high-frequency productions.

开式磁路是由2片钕铁硼磁铁和主导磁板和导磁垫片组成，我们在实践过程中发现这种磁路结构不适合于低频扬声器的使用，我们通过使用FEMM（Finite Element Method Magnetics）软件包对该磁路进行了分析，该磁路的磁场范围被分成3个区域，其中在主导磁板附近形成一个正向磁场，在正向磁场的两边存在反向的磁场，音圈在工作时有很大一部分进入了反向磁场中，在反向磁场内线圈的感应电流方向与驱动电流方向相同，使得音圈呈现出负感抗特性，由于音圈的负感抗特性引起电流的增加导致音圈发热甚至烧毁，因此在扬声器中使用开式磁路时，音圈的运动范围应控制在正向磁场范围之内，否则音圈运动到反向磁场区域时将会产生很大的失真和发热，即使在设计时已经将音圈的运动范围控制在正向磁场范围之内，由于正向磁场的2个边缘磁场强度衰减太快，同时开式磁路中磁场的分布不是平行的，而是自由发散的分布，这样肯定会导致扬声器的非线性失真，因此我们得到的结论是：开式磁路并不是一个理想的磁路，它不适合于低频扬声器的使用，但它还可以应用于中高频扬声器。

In this dissertation, the moderately thick plate which works as transfer layer in" JinChao Mansion"in Hangzhou is analyzed by 3 dimensional solid finite element and the 9node mixed plate bending element. Several computation models for the transfer plate and the axial deformations of the columns and ahear walls which support the plate are considered in the analysis.

文中用三维实体单元和九节点混合板弯曲单元对杭州&金潮大厦&厚板结构转换层进行了分析，分析中考虑了多种计算模型，并用弹性支承近似地考虑了支承转换板的柱和剪力墙的轴向变形，文中给出了大量的图表。

Through research and analysis of data, it was observed that the length and width of bark fiber varied according to the lop and age, the results show the fiber of the Salix bark is longer than the Salix and width of fiber almost same, fiber length of the Salix bark mainly influenced by the times of lop. The ash in Salix bark,1% Sodium Hydroxide Solubility in Salix bark, water solubility in Salix bark, Ethanol-Toluene in Salix bark, acid-insoluble lignin in Salix bark changed with the lop and age is also been investigated, the component of Salix bark is higher than Salix except acid-insoluble lignin,and it's high effected by times of lop; the TG analysis and DSC analysis is been used on the Salix bark and Salix to study the character of the hot-action, and the rang of the pyrogenate temperature is confirm; the quantity of Salix bark effect on the MOR, MOE, swelling in 24h water, nail withdraw and inner strength was determined, the results show that the Salix bark notability effect on the properties of board and dropped it; the properties of the Salix bark board is nearly the board product by other bark residues, it was established the multi regression equation of each properties and optimized the fitting produce condition of Salix bark board.

通过试验和数据处理，得出了沙柳树皮纤维长度、宽度随平茬和材龄的变化规律，结果表明沙柳树皮长度要比沙柳材的要长，宽度基本相同，沙柳树皮纤维长度主要受平茬次数的影响；找出了沙柳树皮中灰分、冷热水抽出物为、1%NaOH抽出物为，甲苯乙醇抽出物、酸不溶木素与平茬次数和材龄之间的关系，除酸不溶木素外，其他成分均明显高于沙柳材，沙柳树皮的化学成分主要受平茬次数的影响；利用TG和DSC法分析了沙柳树皮和沙柳材的反应热特征，确定了热解的温度范围；研究了沙柳树皮量对于刨花板MOR、MOE、吸水厚度膨胀率、握钉力以及内结合强度的影响，结果证明沙柳树皮量对于刨花板的各项性能指标影响显著，它的掺入降低了刨花板的各项性能；对沙柳树皮板的研究表明，沙柳树皮板的各项性能与同类树皮板的性能基本相近，建立的二次回归模型稳定，并利用回归方程求出了适宜的沙柳树皮板制造工艺。

This paper studies on the layout problem of allocating the plugholes on the circular jack panel of a spacecraft,subject to the constraints of non intervention feasible domain,force of inserting and drawing the plugholes,bolts' fixing force and springs force etc.

研究航天器中一种复杂插座板上插孔的布局设计问题，简化为在圆形插板上，根据给定的 n个插头，考虑插座板的非凸的可布空间和插头的拔脱力、插座板的紧固螺栓力、边缘弹簧的弹簧力等约束情况下，布置其插孔位置。

Aiming at the troubles appeared in trial operation such as steel scrap appearance, flatness badness, dimension out-of-tolerance and telescoping etc, through controlling the temperature strictly, optimizing the parameters of the side guide, loop, coiling machine and the load distribution of the mill, adding the functions of hydraulic AGC and roll bending and adopting concave camber, the teehnohgieal difficulties in production are settled.

针对试生产中出现的废钢、板形不良、尺寸超差、塔形等问题，通过严格控制温度、优化侧导板和活套以及卷取机参数、优化轧机负荷分配、投入液压AGC和弯辊功能、采用负辊型等措施，解决了生产中的技术难题，产品成材率97.6％，综合合格率99.8％，已转入批量生产。

If you are unfortunate enough to the lovelorn, please tell me, I will help you out, really, please contact me!

如果你不幸失恋了，请告诉我，我会帮助你摆脱困境，真的，请联系我啦！

China's plan to cut energy intensity by 20 percent and pollutant discharges by 10 percent between 2006 and 2010 is a case in point.

中国计划在2006年到2010间降低20%的能源强度和减少10%的主要污染物排放，就是一个这样的例子。