查询词典 yield point

The second section analyzes the restraint conditions of establishing zero-coupon bond yield curve in China. In order to analyze the constraint conditions of establishing zero-coupon bond yield curve, we should firstly study the current situation and problems of Chinese bond market because the data estimating zero-coupon bond yield curve mainly come from bond market which can't be separated from the analysis of the development history of bond market. So the main content of this section includes the development history of bond market, the present problems of Chinese bond market and the restraint conditions of establishing zero-coupon bond yield curve in China.

第二节分析中国零息票债券收益率曲线构造的约束条件，由于估计零息票债券收益率曲线所需要的数据主要来自债券市场，这样，要研究零息票债券收益率曲线构造的约束条件，首先必须研究中国债券市场的现状和问题，而这一切又离不开对中国债券市场发展历史的分析，因此本节的内容包括中国债券市场发展的历史沿革、中国债券市场目前存在的主要问题和中国零息票债券收益率曲线构造的约束条件三个部分。

According to the principle of the diameter of a circle corresponding to the right angle and the principle of short side for little angle in right triangle, projecting the initially-chosen point to the hyper-planes of the linear equation group in which every linear equation can be regarded as a hyper-plane and the projection points can be obtained. The initially-chosen point, and one arbitrary projection point, and the solution point are all on the surface of the relative hyper-geometry ball, therein-to, there is a projection point which is nearest to the solution point and it can be regarded as the next iterative initially-chosen point, so the solution problem of the linear equation group can be changed as an iterative problem of approaching the solution on the surface of a hyper-geometry ball.

根据直径对应的圆周角足直角以及直角三角形中短边对小角的原理进一步知道，当将初始点向线性方程组中各个方程所代表的超平面上投影得到投影点时，初始点和其任何一个投影点及方程组的解点都将位于一个相应的超球面上，其中必定存在一个投影点离问题解点的距离最短，即把该点作为下一次迭代的初始点，从而可将线性方程组求解的问题变成球面上逼近解点的迭代问题。

Thence in a southeasterly direction to Corner Point No. CP14 (X = 484 330, Y = 683 415); thence in a. northeasterly direction to Corner Point No. CP15 (X = 484 390, Y = 683 490); thence in a southeasterly direction to Corner Point No. CP16 (X = 484 415, Y = 683 470); thence in a southwesterly direction to Corner Point No. CP17 (X = 484 355, Y = 683 395); thence in a southeasterly direction to Corner Point No. CP18 (X = 484 430, Y = 683 335); thence in a southeasterly direction to Corner Point No. CP1, the point of beginning.

从该点起向东南延伸至隅角点CP14（X = 484 330，Y = 683 415）；从该点起向东北延伸至隅角点CP15（X = 484 390，Y = 683 490）；从该点起向东南延伸至隅角点CP16（X = 484 415，Y = 683 470）；从该点起向西南延伸至隅角点CP17（X = 484 355，Y = 683 395）；从该点起向东南延伸至隅角点CP18（X = 484 430，Y = 683 335）；从该点起向东南延伸至隅角点CP1。

At first, starting point and hypothesis used to establish yield criterion of powder metals have been comprehensively and profoundly investigated and then the stress at the location of porosity has been supplementarily defined, Moreover, on the basis of Mises's yield criterion, author proves that yield surface of powder metals is a rotative ellipsoid surface in principal stress.

因此，关于粉末体塑性加工理论问题的研究，引起了人们极大的关注。本文在分析国内外大量文献基础上，着重对粉末体塑性理论中的屈服准则和流动应力进行了理论分析和实验研究。

For this reason, the generic term yield stress is used, and it can mean either yield point or yield strength.

基于这个原因，一般是用名词产生压力，可以说是屈服点或屈服强度。

The results indicate that in the synchronizing condition the MRF is unyielded, every point of MRF in the flow field has the same angular velocity. Under the slipping condition, with the increase of magnetic field or the decrease of slip speed, MRF may transfer from whole yield to partial yield. When the MRF wholly yields, the angular velocity of MRF increases nonlinearly with its radius, the non-linear distribution becomes more obvious as the magnetic intensity in the working gap increases. When the MRF partially yields, the yield region expands with the decrease of magnetic intensity or the increase of slip speed and the unyield region always reaches the driven rotor. The transfer torque of MRTD increases with the increase of the external magnetic field, but the transfer torque maintains a constant value approximately with the variation of slip speed at the same magnetic intensity.

研究结果表明，在同步工况下，传动装置流场中磁流变液未屈服，各点角速度相同；在滑差工况下，随外加磁场的增大和滑差转速的减小，磁流变液逐渐从完全屈服向部分屈服转变；磁流变液完全屈服时，磁流变液角速度随半径呈非线性增加，工作间隙中磁场越强，流场的非线性分布越明显；磁流变液部分屈服时屈服区域随外加磁场的增大而减小，随滑差转速的增大而增大，未屈服区与主动转子相连；稳态下磁流变传动装置传递的转矩随外加磁场的增加而近似呈线性增大，但在相同外加磁场下，传递转矩基本不随滑差转速改变而改变，表现出良好的恒转矩特性。

Sb can combine with Cu and P to form a low melting point compound which lowers the melting point of binary Cu-8P eutectic alloy by nearly 200℃. Bi and Cu can create compounds with low melting point(270℃) distributing at the boundaries and that is the reason why the melting point of (Cu-8P)-Bi is lower than that of binary Cu-8P eutectic alloy. The eutectic cluster can be refined with the addition of Fe, and that is the reason why the addition of Fe can decrease the melting point of Cu-8P alloy. Two means of decreasing the melting point of Cu-8P are found.

一定量的Sb与Cu， P形成低熔点相，从而大幅降低了Cu-8P合金的熔点，使其熔点降低近200℃；加入少量Bi后， Bi与Cu在共晶团晶界上形成熔点为270℃左右的低熔点化合物，且Bi的加入明显细化Cu-8P合金共晶团，从而使Cu-8P合金的熔点降低；加入Fe能明显细化Cu-8P合金的共晶团，使层片间距由8μm减为2μm以下，并使共晶团由层片状向短棒状转变，虽然Fe与Cu形成熔点为806℃的高温相，但Fe的细化作用使得Cu-8P合金的熔点降低，但降低幅度不大。

For a continuous map of trees or graphs to itself, we show the properties that every isolated chain recurrent point is an eventually periodic point, and an isolated chain recurrent point which is not in the orbit of a critical point and has no critical point in its orbit is a periodic point.

第三章主要讨论一些特殊连续统上连续自映射的孤立链回归点与最终周期点之间的关系，证明了对树或图上连续自映射，孤立链回归点是最终周期的，且如孤立链回归点不在临界点的轨道中，也无临界点在其轨道中，则此点必为周期的。

Resistance to Earth magic by an amount equal to your skill in Earth and lasts one hour per point of skill. 1 point resistance per point of skill 2 points resistance per point of skill 3 points resistance per point of skill 4 points resistance per point of skill P

每提高一个土魔法等级可以增加1点防御值每提高一个土魔法等级可以增加2点防御值每提高一个土魔法等级可以增加3点防御值每提高一个土魔法等级可以增加4点防御值 P

Results show that floes' VC and D at the surface water were closely related to current velocity; and the peaks of VC lag those of the current velocity. The lag variation during ebb and flood tides is 10-30min and 30-50 min, respectively. Current velocity at 50 cm/s is a turning point of D vs. vertical average current velocity, before the point, Dm increases with current velocity, and decreases after the point. Similarly, VC at 75μl/L becomes a critical point in the surface water, below the point, D increases with VC, and above the point, D stabilizes.Δp is D dependent, larger floes have much lower Δp than smaller floes. Both D and Δp of floes affect ω. In the surface water during spring tide and neap tide, a power exponent relationship exists between Δp and D, and ω and D.

研究表明：①长江口徐六泾表层絮凝体体积浓度主要受水流流速影响，再悬浮现象明显，体积浓度过程线滞后流速过程线，落潮期间滞后10-30min，涨潮则滞后30-50min；②小于一定流速时絮凝体平均粒径随流速增大而增大，大于一定流速时絮凝体平均粒径则随流速增大而减小，徐六泾夫、小潮表层絮凝体在50cm/s的垂线平均流速时出现平均粒径与垂线平均流速关系的转折；③徐六注大、小潮表层絮凝体平均粒径在体积浓度75μl/L时出现平均粒径与体积浓度关系的转折，体积浓度小于75μl/L时粒径随体积浓度增加而增大，超过75μl/L时粒径随体积浓度的增加变化不明显；④絮凝体有效密度由粒径大小控制，粒径大，有效密度小，反之亦然，粒径和有效密度共同决定絮凝体静水沉速，有效密度和沉速与平均粒径之间均存在良好的幂指数关系。

I was just taking her hand, to help her out of a car, and I knew it.

我只是握着她的手，扶她下车，但我知道这一切。

China and South Korea have excoriated Japan over its approval of new school books which they say whitewash the atrocities committed during Japanese occupation, and anti-Japanese protests have been held in Chinese cities. The lingering bitterness over Japan's past imperialism still threatens to mar relations between the big East Asian powers

中国和韩国强烈谴责日本通过新的中学历史教科书，他们认为这一教科书掩盖了日本在其占领期间所犯下的残酷暴行，反日抗议活动在中国数座城市发生，历史上日本帝国主义制造的痛楚无法被忘却，这有可能破坏东亚强国间的关系。