查询词典 vertical deflection

Single factor experiments were done with the factors including the width of protrusion and the trolley's velocity, which showed that the surface frictional coefficient decreases with the width of protrusion increasing, and doesn't change with the trolley's velocity changing, which was consistent with the results of the orthogonal experiment. A theoretical model of the horizontal projection of a corrugated bionic surface's contact area was built, which showed that the contact area's horizontal projection decreases with width and interval increasing respectively and that the ratio of the contact area's horizontal projection and the vertical load decreases with the vertical load increasing. It indicated that the surface frictional coefficient decreases with the above three factors increasing respectively. Finite element modeling and analysis of interactions of a plate and soils was done using ANSYS, which showed that the plate frictional coefficient is little relative to soil elastic modulus and decreases with vertical surface pressure and that trolley's pull and vertical displacement of bionic surface's control pilot keep constant almost during the plate being pulled. Finite element modeling and analysis of interactions of a corrugated bionic surface and soils was done using ANSYS, which showed that surface frictional coefficient is little relative to soil elastic modulus and decreases with bionic surface's structural parameters and vertical pressure increasing. However, the three factors all didn't affect the surface frictional coefficient remarkably on the condition of 90% dependability. For the first time, bionic surfaces were applied to screw piles, which formed bionic screw piles, and the contrast experiments showed the bionic screw pile had certain resistance-decreasing effects.

建立了波纹型仿生曲面与土壤的接触面积的水平投影的理论模型，表明接触面积的水平投影A随着波纹型仿生曲面突起宽度、两相邻突起间距的增大而减小，接触面积的水平投影与波纹型仿生曲面表面垂直载荷之比随着波纹型仿生曲面表面垂直载荷的增大而减小，进而得出仿生曲面摩擦系数随着波纹型仿生曲面突起宽度、两相邻突起间距以及表面垂直载荷的增大而减小；利用ANSYS软件对平板与土壤的相互作用进行了有限元建模与分析，表明平板摩擦系数与土壤弹性模量关系不大，而随着表面垂直载荷的增大而减小；平板牵引过程中台车牵引力和仿生曲面控制节点垂直方向位移基本保持不变；利用ANSYS软件对波纹型仿生曲面与土壤的相互作用进行了有限元建模与分析，表明波纹型仿生曲面系数在一定范围内基本不受土壤弹性模量的影响，随着波纹型仿生曲面突起宽度、两相邻突起间距以及表面垂直载荷的增大而减小，但在可信度为90％的前提下，三个因素影响都不显著；首次将波纹型仿生曲面应用于与土壤作用方式以挤压为主的螺旋桩，形成仿生螺旋桩，并与普通螺旋桩进行了沉桩对比试验，表明波纹型仿生曲面应用于螺旋桩桩体表面具有明显的降阻作用。

In the third chapter, I first gain the equation of the large deflection considering the plate that has original deflection, that is the equation of the compatibility and the bend deflection of the plate which has the effect of initial curvature.

第三章中首先叙述了考虑初挠度的薄板的大挠度微分方程，即相容方程和板的挠度方程、得出膜应力方程，再通过瑞次法求解板的挠度方程，得出在有初挠度情况下。

In a this tube pair of deflection plate, besides demonstration electron under electric field role deflection movement, but also played causes the beam convergence the function, if causes two deflection plates the electric potentials to be lower than the acceleration extremely electric potential approximately 30 volts, then the focusing condition is best.

该管内的一对偏转板，除了演示电子在电场作用下的偏转运动外，还起了使电子束会聚的作用，如使两偏转板的电位低于加速极电势约30伏，则聚焦状态最佳。

Maintain deflector if the size of the same voltage, the voltage change is accelerating, we can see a very accelerated voltage reduce, electron beam deflection angle instead of increasing, it is because of low accelerating voltage, the electron velocity smaller horizontal direction, electronic deflection plates in the field of the role of the extended time, the angle of deflection increases .

如果保持偏转板的电压大小不变，改变加速极的电压，可以看到加速极的电压减小，则电子束偏转的角度反而增大，这是因为加速极电压低，则电子的水平方向速度变小，电子在偏转板中受电场力作用的时间加长，所以偏转的角度增大。

Studyed the analytical model of buried pipeline and suspending pipeline, introduced a factor about the redistribution of deflection and moment of suspending pipeline, rasied a analytical model between deflection and moment, showed that the deflection

3分析管道裂纹形式和种类，探讨脆性断裂和延性断裂失效判据及其适用条件，对裂纹扩展进行应力-应变场分析，建立了适合本研究课题的应力-应变场模型。

At last, the paper thoroughly researchs the deflection of the ultrasonic wave measuring, and detailedly introduces the cause of the deflection, at the same time,, bings up some measurement to avoid the deflection. Additionally, the paper provide the experimental result and experimental data.

最后本文还给出了实验结果和实验数据，并对超声波测距的误差作了较为深入的研究，对误差的产生作了较为详细的介绍并提出一些避免误差的措施。

The deflection yoke has an electrically insulative liner (15) with vertical (17) and horizontal deflection coils (13) attached thereto.

该偏转磁轭包括具有与其附接的垂直(17)和水平偏转线圈(13)的电绝缘衬套(15)。

The vertical deflection coil is insulated from the horizontal deflection coil.

所述垂直偏转线圈与所述水平偏转线圈绝缘。

Also, the conversion between counteracting force and deflection of the bridge is achieved. The study analyzes on the characteristics of the beams" stress and deformation and gets the beams" vertical fiexture stress and deflection, their rigidity rotation stress and lateral inner force caused by the beams distribution of load.

通过实测结果，得到了桥梁的支反力与挠度，箱梁桥的受力特点：包括纵向弯曲产生的竖向变位，畸变角及由畸变产生的隔板横向弯曲应力，纵向弯曲应力及箱形梁的剪力滞现象及影响因素，箱梁桥刚性转动效应和截面的歪扭情况，箱形梁在局部荷载作用的横向内力，桥面板的有效工作宽度，荷载的横向分配分析。

A vertical profile of the 3D wellbore trajectory is generally.The challenge is how to draw the actual wellbore trajectory on the vertical profile of planned well trajectory.A planned 3D well path profile is depicted using vertical depth and projection length,however,the actual wellpath profile is supposed to be drawn using vertical depth and apparent projection length.

三维井眼一般都绘制垂直剖面图，其难点就是怎样在设计井眼轨道的垂直剖面图上描绘实钻井眼轨迹的剖面线，由于三维井眼设计剖面图是用垂深与投影长度绘制，其实钻井眼轨迹剖面图应该是用垂深和视投影长度绘制。

Who? I never heard of him, Paul said, before asking teammate James Posey if he had heard of him.

赛后，科比说，他一直都是一名非常出色的射手，今天他打得很棒。

When I joined the company, I rotated around the different sections.

我加入这个公司时，轮换过几个不同的部门。