查询词典 vector component

During the cold crystallizing process, when PBT component was above 20%, the existence of PBT promoted the cold crystallizability of the blends. While during the melt crystallizing process, the addition of a second component restrained the crystallization of the system.

在冷结晶过程中，当PBT含量超过20%时，将促进体系的结晶性能；而在熔融结晶过程中，第二组分的加入抑制了体系的结晶性能，当配比为50/50时，结晶速率相对最低。

In the first chapter of this paper we introduced the emergence and evolution of component technique as well as the leading component-developing technologies curtly.

本文的第一章主要对组件技术的产生、发展以及组件开发的主流技术作一个大略的介绍。

The steps involved are as follows: 1 Clean ultrasonically all component parts with a degreaser in a warm water solution. 2 Rinse with warm water in an ultrasonic bath. Rinse again in cold water. 3 Put all component parts under black light for inspection of any carbon.

清洗步骤包括如下：1 在含有脱脂剂的温水溶液中用超声波清洗所有部件。2 在一个超声池内用温水冲洗，再用冷水冲洗。3 将所有部件放置在红外线下检查是否有碳。

Firstly, the optimum network was determined on the degree of approximation, which made the network avoid over fitting. It was shown that the single component and multi-component pollutions were identified and quantified successfully.

首先，采用模拟的光谱数据，引入逼近度的概念确定最优网络模型，避免了网络陷入局部极小，成功地实现了单组分和多组分污染物的同时鉴别和定量分析。

Analysis of variance and principal component analysis were used to analyzed the data. Results: three hundreds and one women (30.28%) met AX criteria for PMS. There was statistic difference between the normal and the PMS cases. The pattern of symptoms were differ in different age-groups, Principal component analysis of TCM syndrome show that this questionnaire include most of the PMS symptoms. Health status and denutrition were the main cause for PMS.

结果：301名受试者(30.28%)满足PMS诊断要求，正常人群与PMS患者的症状水平差异显著，PMS患者不同年龄组部分症状水平差异显著，主成分分析显示本筛选表涵盖了PMS发病的主要症状；健康程度、营养程度低的女性易发病；部分PMS患者伴有痛经。

Thus, the coefficients of governing equations are pressure dependent and consequently the analysis of transients in the two-component flows is more complex and difficult than in single-component flows.

而且，控制方程的系数是与压力相关的，因此在含有两种物质瞬变流动分析比单相流动更为复杂和困难。

STUDY ON COMPARISON OF BIDIRECTIONAL SPECULAR REFLECTION COMPONENT AND BIDIRECTIONAL DIFFUSE REFLECTION COMPONENT FROM GRANITE SURFACES.

花岗岩表面二向性镜面反射分量和漫反射分量的比较研究。

In HDF, the diffusive component of HD is combined with the convective component of HF.

在高密度纤维板的扩散组成部分， HD是结合对流短波组成部分。

The volumetric strain due to stress-dilatancy of sand is found to be composed of a reversible dilatancy component and an irreversible dilatancy component.

基于对较高精度的砂土扭剪试验成果的分析，表明砂土的剪胀是由一个完全可逆的体应变分量和一个不可逆的体应变分量构成的。

When the molar fraction of SnO2 is 83%, the main component of the coating isO2 solid solution with rutile structure. When the molar fraction of SnO2 is 44%, the main components of coating are theO2 solid solution with rutile structure andO2 solid solution with fluorite structure. When the molar fraction of SnO2 is 17%, the main component of the coating isO2 solid solution with fluorite structure. Annealed at higher temperature than 450 ℃, CeO2 is found in the coating containing 83%Sn, and there is not SnO2 in the coating containing 83%Ce, which suggests that fluoriteO2 has higher thermal stability than rutileO2. When the molar fraction of SnO2 increases, the dispensability of the coatings is improved greatly.

结果表明：通过控制制备条件可获得具有纳米结构的钛阳极涂层；当Sn的摩尔分数为83%时，涂层主要为金红石相的O2固溶体；当Sn的摩尔分数为44%时，涂层中金红石相O2固溶体和萤石结构的O2固溶体共存；当Sn的摩尔分数为17%时，涂层由萤石结构的O2固溶体组成；高于450 ℃退火时，含83%Sn的涂层中出现CeO2相，而在含83%Ce的涂层中没有出现SnO2相，表明在相同的溶质浓度下，萤石结构的O2固溶体比锡基金红石相O2固溶体具有更好的热稳定性；而涂层中的SnO2具有明显改善涂层分散性的作用。

Chimborazo and Cotopaxi, took me by the hand.

越过琴博腊索山和科托帕克西山。

This car is in a good condition.

这辆车的状况很好。