查询词典 to some degree

The results showed that the different mass concentration of HPAM's absorbance decreases slightly when the PH value of the buffer solution is 5.0, but its reproducibility is better;In order to make the absorbance become more stable, the reaction time was identified adding proper quantities of bromine water, sodium formate and starch-cadmium iodide reagent to the solution separately; the mass concentration curve of the HPAM was draw, by means of the straight degree of the curves, the coincidence degree of the straight line about the concentration of every sampling point and so on , it shows that the mixer has good mixed effect compared with the standard curve.

如下是一些主要问题：1）文章的行文格式。文章没有按照一般科技论文的表述方式，如1是引言，2是常用方法，其实这都应该是第一部分引言里应该介绍的，引言中应扼要介绍文章的研究背景、目的，意义，采用的主要方法等。还有3是实验装置，4是实验步骤，应该这些都是第二部分，试验材料与方法。2）文章的内容。文章应主要介绍本研究的具体内容，但是本文没有，如3 实验装置部分，这个721分光光度计的原理与论文内容联系不大，根本没必要介绍，标准曲线的研究应该放在最前面等。3）文章的表述不清。如HPAM是何物，文章一直没有介绍，什么曲线的直线度、浓度与直线的重合度、什么加入溴水后的时间，应该是反应时间，总之表述不清！ 4）文章的图表。图标绘制的很难看。如图2，应该纵坐标起始点从0.25开始，这样图形就会美观很多，图3又没有纵坐标标注，还多了一个纵坐标等。5）文章的结论。文章的结论中有些严格来说不是结论，而是实验中的现象与操作注意事项。

As to the topology structure of the network with constraints, a new tree encoding for Genetic Algorithms was developed to represent a tree solution containing the information of degree and connectivity on for its corresongding genetic operators, which could be used to solve the minimum spanning tree problem with degree constraint, capacity constraint, and leaf constraint.

本项目主要研究了带约束网络拓扑结构的设计与优化；供应链网络拓扑结构的设计与优化；移动信息网络位置管理的策略与优化。

So put forward the following physics hypothesis:A CURVE AT N-DEGREE SPACE WILL BE A POIT AT (N+1)-DEGREE SPACE.

于是我提出如下的物理学假设：N度空间的一条曲线在(N+1)度空间将是一个点。

LiJunYu Hypothesis:A CURVE AT N-DEGREE SPACE WILL BE A POIT AT (N+1)-DEGREE SPACE.

李均宇假设：N度空间的一条曲线在(N+1)度空间将是一个点。

Brightness of aware sort is the classification norm of distance classification. Distance classification compares brightness between aware sort and unknown pixels. Angle of spectral line is the classification norm of degree classification. Degree classification compares angle of spectral line between aware sort and unknown pixels.

距离分类器是以已知地物类别的亮度值作为分类基准，通过比较未知类别像元与已知类别像元亮度值间的距离进行分类；角度分类器是以光谱谱线角为分类基准，通过比较n维波段空间中未知类别像元与已知类别像元光谱角度进行分类。

And There was no serious complication;②In the course ofinterventional therapy, Direct portal vein angiography demonstrated vena coronaria ventriculi(100%)andgastricveins(65.26%)andvenagastricaposterior38.43%, Angiography demonstrated venacoronariaventriculi communicate esophagus varicose veins, gastric veins and vena gastrica posterior communicategastric varicose veins. vena coronaria ventriculi had only a small percentage of double vein, about30.57%. The sites of vena coronaria ventriculi arising from the portal vein, splenic vein, portosplenic junction, were found in 52.06%、27.39%、20.55% respectively.③12 extrahepaticprotosystemic shunts were found in these patients. Include gastro-nephrosshuntof 3 cases, 7 caseswere splenetic- nephros shunt and 2 cases shown recanalization of umbilical vein .④The averageportal pressure before and after the procedure were 3.87±1.82kPa and 3.64±1.14kPa in 73patients, but to the time of rebleeding, it was 3.96±0.23kPa in the 11 cases.⑤There werethree kinds of variceal outcome: disappearance (54,low degree (19).⑥Spearman logisticanalyse and ANOVAtest shown liver function class, variceal degree of the splenic necrosis area,the blood direction in portal vein before operation and remain small collateral routes were thesignificant factors concerning outcome of varices.⑦The bleeding volume and portalhypertensive gastropathy are main risk factors of rebleeding.⑧The course of livercirrhosis is the risk factor of survival and extrahepatic portosystemic shunt , fine varices are thebeneficial factors to survival.⑨During all cases'followed-up data, the 1, 2, 3, 4, 5 yearcumulative survival rates and rebleeding rates were 17.81%, 28.77%, 38.36%, 43.84%, 47.95%and93.15%,91.78%,86.30%,83.56%,80.82%respectively. Conclusion The interventional disconnection treatment for liver cirrhosis and portalhypertension was designed suitability. It rapidlycontrol bleeding,butpressure of portal vein was notobvious high, perfusion was not low .it was compared with surgery therapeutic that interventionaldisconnection treatment was safe and had a significant clinical effect to hemorrhage and preventfrom rebleeding.

结果：①术后一过性发热62例(84.9%)，腹痛腹胀48例(65.8%)是介入断流术常见的并发症，未发生严重并发症；②门静脉造影显示胃冠状静脉、胃短静脉和胃后静脉的曲张分流的出现率是100%、65.26%和38.34%；显示食管静脉曲张主要由胃冠状静脉供血，胃静脉曲张主要由胃短静脉和胃后静脉供血；胃冠状静脉大多数为单支，少数为双支，其双支的出现率分别为30.57%；胃冠状静脉开口于门静脉主干的为52.06%，开口于脾静脉主干的为27.39%和开口于门脾静脉交汇处的为20.55%；③发现胃肾分流3例，脾肾分流7例、腹膜后门腔静脉分流2例，以及CTA检查发现脐静脉开放者2例；④73例患者介入断流术前和术后平均自由门静脉压力分别为3.87±1.82kpa和3.64±1.14kpa，前后比较存在显著性差异；11例再次介入手术患者的术前、术后和复发后的自由门静脉压力分别为4.02±0.24kpa、3.82±0.25kpa和3.93±0.23kpa ，前后比较发现首次术前与术后存在显著性差异，首次术前和复发出血术前门静脉压力比较无显著性差异；⑤介入术后复查曲张静脉转归基本消失54例，轻度19例；⑥Spearman相关分析和Logistic多因素回归分析，肝功能分级、静脉曲张程度、门脉血流方向和残存小侧支四个因素对曲张静脉转归有影响；Spearman相关分析和Logistic多因素回归分析门脉高压性胃病和出血量等因素对复发出血时间有影响；⑦COX回归分析，门体分流和曲张静脉转归两个因素对术后生存有影响；⑧术后随访6-70月，1、2、3、4、5年的累计复发出血率和累计生存率分别为17.81%、28.77%、38.36%、43.84%、47.95%和93.15%、91.78%、86.30%、83.56%、80.82%；结论：介入断流术治疗门脉高压食管胃底静脉曲张有独特的优点，可以快速直接控制曲张静脉出血而门静脉压力无显著增高，保证了肝脏灌注；与外科分流术相比适应证广、损伤轻、术后恢复快，不易遗漏曲张静脉；肝功能分级、曲张静脉程度、门脉血流方向和残存侧支血管对食管胃曲张静脉转归有影响；门脉高压性胃病对复发出血时间有影响；门体分流和曲张静脉转归对生存时间有影响。

Pass to count to Wisterch parameter , and the steel wire is different from the molding tool get in touch with the length, and settle the path the research taking the length work the stabber angle to get under differently pull to stir the term, mold core adoption of best severally why size, combine the best work stabber of research the Cape, and settle the path to take the length nextly steel wire is in the molding tool of have fever to measure, air inside dispel-heat calories, winding dispel-heat on the coil-canister , and its molding tool dispel-heat calories of, and cause the steel wire the temperature difference pass in and outing the molding tool to influence steel wire machine function, under the experiment inside pull to stir the term according to the same race different work stabber Cape half of adoption the Cape(7 degree,10 degree,12 degrees, the best mold Cape, experience mold Cape) settle the path to take the length(2-3 mm,3-4 mm,4-5 mms, theories length, experience length) to proceed to experiment, and get the conclusion, work stabber the Cape then is more big the steel wire get in touch with the length with

通过对Wisterch参数，钢丝与模具接触长度、定径带长度、工作锥角度的研究得到了在不同拉拨条件下模芯采用的最佳几何尺寸，并研究最佳工作锥角、定径带长度下钢丝在模具中的发热量、空气中散热量、卷筒上的散热量及其模具散热量的不同，导致钢丝进出模具的温度差别对钢丝机械性能的影响，在实验中根据同种拉拨条件下采用不同工作锥角半角、定径带长度进行试验，得出结论，工作锥角越大则钢丝与模具接触长度越短，钢丝变形越剧烈，在模具中发热量就越高，导致钢丝出模温度高，使钢丝强度、硬度升高，弯曲、扭转次数降低，并且降低模具使用寿命。在其它条件相同的情况下，定径带越长则钢丝与定径带简壁磨擦增大，使钢丝发热量加大，从而使钢丝强度、硬度略升高，弯曲扭转次数略降低但定径带的增大减小了钢丝变形产生的弹性后效使钢丝出模直径比较稳定。

The high is the water surface to pump impeller center line of the vertical distance, it allows a high degree of suction on the vacuum can not be mixed up, pump product specifications or nameplate allows a high degree of vacuum suction on the pump inlet section refers to the vacuum value, and Standard chemical pump is a standard atmospheric pressure, water temperature 20 degrees Celsius case, trial and determination to come by.

这个高度是指水源水面到水泵叶轮中心线的垂直距离，它与允许吸上真空高度不能混为一谈，水泵产品说明书或铭牌上标示的允许吸上真空高度是指水泵进水口断面上的真空值，而且是在1标准大气压下、水温20摄氏度情况下，进行试验而测定得的。

The degree distribution and stationary average degree distribution of the model are investigated.

利用Poisson过程理论对这类网络进行了分析，获得了度分布的解析表达式。

The 3320 is capable of 0-degree (straight-out) or 90-degree laser output for constrained spaces.

在3320能够在0度或90度的激光输出的限制空间。

It's rather showy.I'd like something plainer.

赶花了，我想要素净些的。

The Kremlins Spassky Tower and passers-by are reflected in the wet cobblestones of Moscows Red Square on Feb.

克里姆林宫的斯巴斯克塔和旅客的身影倒映在潮湿的鹅卵石墙上。