查询词典 threshold friction

By designing and selecting oils that minimised friction between the moving parts of the engine, it is possible to minimise the power and friction losses in an engine.

通过设计和选用适当的润滑油，可以减小发动机活动部件之间的摩擦，就可以降低发动机中的功率和摩擦损失。

In order to analyze force easily,we simplify the model of FA cyloid,taking no account of friction,supposing that there is the maximum of distortion in the largest arm of force,but in fact,friction must be exist and there is not always needle tooth in the largest arm of force.

为了便于分析受力，传统齿形简化FA针摆传动模型：不考虑摩擦因素、假定在摆线轮最大力臂处产生最大变形等，而实际上摩擦一定存在、在线轮最大力臂处未必有针齿存在。

The paper folding machine also consists of air-breathing into the paper and friction type feed two, the best selection of air-breathing into the paper-folding machine, because friction type feed easily damaged, as good as a digital business card printing and membership card making prints.

折页机的给纸部分又分为吸气式进纸和摩擦式进纸两种，最好选择吸气式进纸方式的折页机，因为摩擦式进纸容易损坏已印好的数码制卡和会员卡制作印品。

Firstly, saltating sand grains in various height layers mostly rotate clockwise; the rate of counterclockwise rotation changes from 16.7 to 33.3% for three different friction wind speed (u*= 0.67, 0.83, and 0.87 m/s). However, their mean rotational speeds were not significantly different, irrespective of whether the grains rotated clockwise or counterclockwise. The mean counterclockwise rotational speeds of sand grains for friction wind speed u*= 0.67, 0.83, and 0.87 m/s were 427, 519, and 604 rev/s, versus 429, 522, and 609 rev/s, respectively, in the clockwise direction.

首先，风沙流中各高度层内跃移沙粒旋转均以顺时针方向为主，逆时针方向旋转的沙粒数仅占总数的16.7-29.5%，但是无论逆时针还是顺时针旋转的沙粒，它们的平均旋转速度几乎没有差别(如u*＝0.67 m/s时，分别为427 rev/s和429 rev/s；u*＝0.83 m/s，分别为519 rev/s和522 rev/s；u*＝0.87 m/s，分别为604 rev/s和609 rev/s)；不同摩阻风速条件下各高度层内沙粒的旋转速度均服从Lorentzian分布。

The effect of the friction moment of bearings on performance is researched. The forming mechanic and influence factors of the friction moment of ball bearing are analyzed. Suitable clearness and groove radius of ball bearings are obtained by experiment and calculation. The relationship between starting moment of ball bearing and various lubricants is analyzed. The measure for reducing the starting moment of ball bearing is put forward, it is the theory basis and reference for ball bearing design of small power unit system.The system is an unstable system when the 24-station ball pen tip production machine is running because of various interferences. It is too hard to describe the system by linear method, so the nonlinear formulation must be used.

研究了小动力头系统轴承摩擦力矩对运转性能的影响，分析了球轴承摩擦力矩的产生机理及影响因素，采用实验和计算的方法得到了动力头球轴承的合理间隙及球轴承沟曲率半径，分析了各种润滑剂与球轴承启动力矩的关系，并提出了减小轴承启动力矩的措施，为小动力头系统的轴承设计提供了理论依据及实践参考。24工位笔头加工机械在笔头的生产加工过程中，由于受到各种因素的干扰是一个不稳定系统，其稳定性会发生一定变化，而且很难用线性方法表述。

Compact pentroof combustion chambers and high-strength pistons that are resin-coated to reduce friction, low-tension piston rings and a low-friction valve train that uses roller rocker arms also are important features of this engine, as is an Acoustic Control Induction System that changes the length of the intake manifold runners based on engine speed and throttle opening.

紧凑pentroof燃烧室和高强度的活塞是树脂涂层以减少摩擦，低张力活塞环和低摩擦气门，使用滚子摇臂也是这个引擎的重要特色，是一种声学控制感应系统这改变了进气长度发动机转速和节气门开度为基础的多方面的选手。

The friction plate produces friction damping on the rope wheel under the influences of centrifugal force. The gear speed change helps the rope wheel produce balanced damping torgue when people descend.

利用离心使磨擦块在绳轮上产生磨擦阻尼，通过齿轮变速，使阻尼距与人下降时在绳轮上形成的主力距相平衡，以实现匀速下降，从而保证了被救者的安全。2。

Two pairs of chutes and holes on the cleaning base and the brushes form the double chute swing mechanisms by the connection of an axis and cause the brush to cling to the wall surface to clean by the friction feedback, thus achieving effective cleaning when walking error occurs and the pipe section changes, furthermore, the larger the friction on the wall surface is, the larger the forward pressure on the wall surface is, therefore, the dirtier the wall surface is, the higher the cleaning efficiency is.

清扫底座与刷子夹上的两对滑槽和孔通过轴的连接形成双滑槽摆动机构，并通过摩擦力反馈使得刷子能够紧贴壁面进行清洗，从而在出现行走误差和管道截面变化时都能够有效清洗，并且壁面摩擦力越大刷子作用在壁面上的正压力越大，因此壁面越脏时清扫效率越高。

A two-component mixed friction model is used to express the friction force in servo mechanisms.

伺服机构中的摩擦力是采用一种&两维混合摩擦模型&来描述的。

Determine (1)the angle acceleration of the tub wheel,(2) the tensile force of the rope,(3) the reaction forces at point O on the bearing,(4)the friction force between the cylinder and the inclined plane (neglecting the rolling friction).

在图示机构中，沿斜面向上作纯滚动的圆柱体和鼓轮O均为均质物体，各重为P和Q，半径均为R，绳子不可伸长，其质量不计，斜面倾角，如在鼓轮上作用一常力偶矩M。

When I started coding, I had problems with the ASF file writer.

当我开始编码，我曾与ASF文件作家的问题。

I know that in one of the schools the boys have risen up in the classroom and enlisted in a mass.

如果你们也和他们一样，是集体自愿的话，你们的老师将是多么地光荣啊。