查询词典 third boundary condition

Both the BIE and transmission condition are transformed into the third boundary condition.

在分析过程中，将传输条件和BIE统一成第三类边界条件形式。

The fundamental solution of the mixed problem with the third kind homogeneous boundary condition and that with the zero initial condition are given respectively.

分别给出具有第三类齐次边条件的混合问题基本解以及具有零初始条件的混合问题基本解。

The third thermal boundary condition equation joined with the degradation rate of interior wall was used to get the contour of interior wall vs. time under the condition of identical heat flux between fluid and solid in axis direction. The numerical simulation results agrees well with that of measurements.

在气流与固壁之间的热流量沿轴向一致的条件下，通过加入降解退移速率的第三类热边界条件方程，求解出不同时间管内壁面轮廓沿轴向变化情况，模拟值与试验结果基本吻合。

The results show that proper RRA heat treatment can improve SCC properties with retention of the high strength of T6 level. After preaging at 100℃for 24 h, retrogression at 200℃for 7 min, and reaging at 100℃for 24 h, the ultimate tensile strength, yield strength and elongation of the alloy are 795 MPa, 767 MPa and 9.1%, respectively. Meanwhile the failure time of the alloy applied to tensile strength of 210MPa in 3.0%NaCl+0.5%H2O2corrosion condition is longer than 720 h. The corresponding TEM observation shows that after retrogression for 7 min and re-aging treatment, the microstructure of grain boundary is similar to that treated in the T73 condition with coarsen and isolated distribution, and the microstructure inside grain is similar to that treated in the T6 condition with small and homogeneous distribution.

研究结果表明：在峰值时效T6状态下合金强度高，但抗应力腐蚀性能差；采用合适的RRA热处理工艺既能使合金保持T6状态下的高强度的同时，又能显著改善合金的抗应力腐蚀性能；经回归7 min RRA处理后合金的晶界类似T73态析出相聚集粗化，而晶内类似T6态析出相细小弥散分布，在拉伸应力为210 MPa和3.0%NaCl+0.5%H2O2腐蚀液中，其断裂时间大于720 h，相应的抗拉强度、屈服强度和延伸率分别为795 MPa， 767 MPa和9.1%，显示优越的综合性能。

The results show that proper RRA heat treatment can improve SCC properties with retention of the high strength of T6 level. After pre-aging at 100 ℃ for 24 h, retrogression at 200 ℃ for 7 min, and reaging at 100 ℃ for 24 h, the ultimate tensile strength, yield strength and elongation of the alloy are 795 MPa, 767 MPa and 9.1%, respectively. Meanwhile the failure time of the alloy applied to tensile strength of 210 MPa in 3.0%NaCl+0.5%H2O2 corrosion condition is longer than 720 h. The corresponding TEM observation shows that after retrogression for 7 min and re-aging treatment, the microstructure of grain boundary is similar to that treated in the T73 condition with coarsen and isolated distribution, and the microstructure inside grain is similar to that treated in the T6 condition with small and homogeneous distribution.

研究结果表明：在峰值时效T6状态下合金强度高，但抗应力腐蚀性能差；采用合适的RRA热处理工艺既能使合金保持T6状态下的高强度的同时，又能显著改善合金的抗应力腐蚀性能；经回归7 min RRA处理后合金的晶界类似T73态析出相聚集粗化，而晶内类似T6态析出相细小弥散分布，在拉伸应力为210 MPa和3.0%NaCl+0.5%H2O2腐蚀液中，其断裂时间大于720 h，相应的抗拉强度、屈服强度和延伸率分别为795 MPa， 767 MPa和9.1%，显示优越的综合性能。

The results show that proper RRA heat treatment can improve SCC properties with retention of the high strength of T6 level. After pre-aging at 100℃ for 24 h, retrogression at 200℃ for 7 min, and reaging at 100℃ for 24 h, the ultimate tensile strength, yield strength and elongation of the alloy are 795 MPa, 767 MPa and 9.1%, respectively. Meanwhile the failure time of the alloy applied to tensile strength of 210 MPa in 3.0%NaCl+0.5% H2O2 corrosion condition is longer than 720 h. The corresponding TEM observation shows that after retrogression for 7 min and re-aging treatment, the micro- structure of grain boundary is similar to that treated in the T73 condition with coarsen and isolated distribution, and the microstructure inside grain is similar to that treated in the T6 condition with small and homogeneous distribution.

研究结果表明：在峰值时效T6状态下合金强度高，但抗应力腐蚀性能差；采用合适的RRA热处理工艺既能使合金保持T6状态下的高强度的同时，又能显著改善合金的抗应力腐蚀性能；经回归7min RRA处理后合金的晶界类似T73态析出相聚集粗化，而晶内类似T6态析出相细小弥散分布，在拉伸应力为210 MPa和3.0%NaCl+0.5%H2O2腐蚀液中，其断裂时间大于720h，相应的抗拉强度、屈服强度和延伸率分别为795 MPa，767 MPa和9.1%，显示优越的综合性能。

The difference schema of the initial boundary value problem was converted to the step-by-step form,which was similar to the difference schema of the initial value problem.It is concluded that the difference schema satisfying the Von Neumann condition is a stable schema,and that,under the consistency condition,such stable schema is convergent.Moreover,with error estimate expression for the difference approximation to the classical solution,the linearity condition is unnecessary.

引入反投影算子将发展方程初边值问题的差分格式转化为与初值问题差分格式类似的逐步推进的形式，从而得出：满足Von Neumann条件的差分格式是稳定的格式；在相容条件下，差分格式若稳定(或满足VonNeumann条件)则格式收敛，且对古典解的差分逼近有误差估计式，不再需要线性的条件。

In the view of pragmatic implement, the theoretical framework of our proposed condition for spatial boundaries indeed can be reduced to the hybrid formulation of nudging filter, radiation condition taking account of ambient forcing, together with Dirichlet kind of compatible boundary condition to the observations prescribed in data assimilation procedure.

我们提出的空间边界条件的算法构架事实上是在数据同化过程中综合运用了张弛滤波、考虑外部强迫的辐射边界条件以及与观测相容的狄里希利边界条件。

Based on analysis of the factors affecting subgrade local scour along the river such as condition of stream,condition of bed form,geometric boundary condition of river,water depth and speed of every section,scour depth of parapet,the progress of scour and the form of stream near parapet were observed through the way of field model experiment.

在对沿河路基局部冲刷影响因素如水流条件、河床沙条件和河流几何边界条件等进行分析的基础上，通过野外模型试验，观测了河流各断面的水深、流速、护墙的冲刷深度和冲刷的发展过程及护墙附近的水流形态。

Second order differential inclusion; boundary condition; usc multivalued map; fixed point; monotone map; Yosida approximation; solution tube; upper-lower solutions; critical point; PS-condition; C-condition; Sobolev space

基础科学，数学，数学分析二阶微分包含；集值边界；上半连续集值映照；不动点；单调算子； Yosida逼近；解管道；上下解；临界点； PS-条件； C-条件； Sobolev空间

We have limited budget let me know if you can do this competitively.

我们有限的预算让我知道如果你能做到这一点竞争力。

We don't know how other critters breathe--lizards, for example.

我们还不知道诸如蜥蜴之类的动物如何呼吸。