查询词典 surface charge density

Turn on and in charge of trough in floor the board when constructing, it wides trough have to be de +10 mm deeply 1/2 of the de, Half pipeline imbed and in charge of trough, and with in charge of card fix in trough of inning charge of tube.

现在许多同行都认为：厨房地面都铺设瓷砖，清洁地在时不须用水冲洗，设置地漏意义不大，故厨房内可不设地地漏，这样既避免排水横支管进入邻户，又可增大厨房的使用空间。

"Chinese network is in charge of forum " it is by Chinese electron the Information Industry develops an academy sponsor," world of the member that the net is in charge of " the grand meeting of the annual network industry that magazine company undertakes, the theme of this second director forum is " the IT below the crisis reframes ","Chinese network is in charge of forum " establish 2005, had held 5 up to now, it has made intranet sth resembling a net the person in charge is annual have experience communication, learn network advanced technique, accept the authoritative platform of advanced management experience.

&中国网络主管论坛&是由中国电子信息产业发展研究院主办，《网管员世界》杂志社承办的一年一度的网络业界的盛会，本次主管论坛的主题是&危机下的IT重构&，&中国网络主管论坛&创办于2005年，至今已经举办了五届，它已经成为企业网络主管一年一度进行经验交流，学习网络先进技术，接受先进管理经验的权威平台。

Article 68 A user's charge and a service charge shall be paid for the use of civil airport and its navaid by a civil aircraft; the rates of user's charge and service charge shall be formulated jointly by the competent civil aviation authority under the State Council and the finance department and the competent authority of prices under the State Council.

第六十八条民用航空器使用民用机场及其助航设施的，应当缴纳使用费、服务费；使用费、服务费的收费标准，由国务院民用航空主管部门会同国务院财政部门、物价主管部门制定。

The main results of the investigation are as following:(1) Some important criteria for the design of multi-layer structure are acquired: the ratio of the layer thickness to the contact diameter should be controlled to a value about 0.8; increasing the number of the gradient layers and elasticity modulus of the top layer would benefit to the yield strength and the stress status at the interface.（2）By means of molecular dynamics simulations for a indentation and sliding process, it is discovered that dislocations of 45 direction to the surface occur in the surfaces layer, which is correspond to the direction of the plastic flows observed in the macroscopic continuous medium. The irreversible deformation caused by the dislocation and the atom piles at the surface are responsible for the irreversibility of the force response. They are also the main factors for the friction generation. The temperature and the indentation velocity have significant effects on the deformation behaviors of the material of the surface layer. The yield strength would increase obviously if the indentation velocity is greater than 10 m/s.（3）A method to evaluate the fracture toughness of coating by estimating the crack-density functionβof a Wicker''s indentation was proposed. Meanwhile a new surface treatment technology was developed using non-equilibrium plasma.（4）A MD-FE hybrid method and corresponding software was developed to analysis the tribological behaviors for multiplayer system.

研究主要内容和结果有：（1）得到指导梯度膜设计的几个准则：控制膜层厚度与接触半径比在0.8左右为宜；适当增加梯度层层数和顶层弹性模量，有利于提高抗屈服能力和改善界面处的应力状态；（2）通过对嵌入和滑动摩擦过程的分子动力学模拟，发现表层产生一个与宏观连续介质的塑性流动方向观测一致的45 方向位错；位错造成的不可逆变形和表面的原子堆积，是力的响应不可逆性的原因，也是构成摩擦力的主要因素；温度和嵌入速度对材料变形特性有显著的影响，当嵌入速度大于10 m/s时，屈服强度明显增加；（3）提出压痕裂纹密度系数β半定量判定膜层断裂韧性的方法；并开发出表面强化新工艺；（4）开发出分析表面摩擦学特性的MD-FE复合模拟方法和相应模拟软件。

The rules of fluid rate with different technical parameters: the increase of electromagnetic force causes the increases of the fluid rates at S/L interface and free surface, the decrease of skin depth, the increase of electric current density which will make the fluid at free surface flowing faster, while it doesnt affect the fluid rate at S/L interface. When the height of melt increases, the both of fluid rates will increase too. The increase of the width-thickness ratio augments the fluid rates along the wider edges at S/L interface evidently, while the rates along the narrow edges will have little change, and the rate at free surface has little change too. The increase of overheat degree minishes the range of mush zone, while the fluid rates at S/L interface and free surface will increase evidently.

流速的大小随各种不同工艺因素的变化呈现出一定的变化规律：随电磁力的增大，固液界面以及自由表面处的流速都会增大；集肤层渗入深度变薄，电流密度增大，会导致自由表面上流动的加强，但对固液界面处的流动速度影响不大；熔区高度的增加，也会使固液界面及自由表面处的流动增强；宽厚比增大时，固液界面上沿宽面方向的流动显著增强，但窄面方向流速变化不大，同时自由表面上流速变化也较小；过热度及温度梯度的增大，使糊状区减小，导致固液界面及自由表面处的流速显著增大。

The new opinion and mechanism that the simultaneously adsorption of complex pollution of both organic and heavy metals will be achieved on soil modified with amphoteric surface modifying agent, which have both charged group and organophilic group on one ASMA molecule, were proposed at first time, and its rationality was testified at the same time; The 50% was the critical CTMAB modifying ratio of soil CEC at which the organophilic bond modifying mechanism was emerged; The thermodynamic characteristics of adsorption of OPT and HMP on OMS were discovered ; The study revealed the surface peculiarity of OMS that the modifying agent were distributed at uneven scatter mode and multi-characters surface were coexisted on surface of OMS, revealed the adsorption peculiarity of OMS that multi-mechanisms were coexisted, confirmed the unequal charge amount modifying mode of OMS in which dual-modifying mechanism of both ion exchange and OPB were processed at the same time, and confirmed that the adsorption hobby to CTMAB was higher than that to Ca2+ on Lou soil.

首次提出了用两性表面修饰剂对土壤进行修饰改性，利用两性表面修饰剂所具有的荷电基团和疏水基团达到对土壤中有机、重金属污染物同时吸附的思路和机理，并通过实验证实了所提设想的合理性；发现了土壤CEC值的50%修饰比例是CTMAB开始显现以疏水键机制对土土样表面进行修饰的临界点；揭示了有机修饰改性土对有机物、重金属吸附过程的热力学特征，填补了该项研究工作的空白；阐明了修饰剂在改性土表面呈分散态的非均匀分布，改性土表面具有不同性质表面共存的表面特征和对污染物多机制共存的吸附特征，确定了阳离子表面修饰剂在土表面的修饰是一种离子交换和疏水键结合两种机制相伴并行且为非等电荷量交换的修饰反应模式，以及土具有对CTMAB的吸附偏好性远大于对钙离子吸附偏好性的特征。

Some important questions are discussed, such as, the common characteristics and distinctions of the surface ripples on the (001) surfaces of the carbides, the effects of the surface ripple on the surface energy and the surficial charge distribution, the change trends of the cohesive energy and surface energy of the carbides and their surfaces, an...

讨论了不同碳化物表面褶皱的共同特征和相互差别、碳化物表面褶皱的产生对表面电子分布情况和表面能的影响、碳化物的结合能和表面能的变化趋势、以及表面能与结合能之间的关系。提出了块体结合能和表面褶皱程度两种因素共同影响和决定IVB和VB过渡族金属碳化物(001)表面能的观点。

Functional requirements of habitat for these two species, expressed as habitat suitability and marginal density efficiency, and factors reflecting human disturbances such as the weighted road density and buildup density, were used in the calculation of a cost surface for Least Cost Analysis.

因此挑选杂食性的台湾黑熊及草食性的台湾长鬃山羊为目标物种，利用物种对於两个栖地因子（栖地适宜度、边际密度效应）及人为干扰因子（道路加权密度、建物密度）的反应强弱，制作成本曲面图。

The laryngeal lymphatic system is characterized by regional differences in lymphatics density with the highest density in the larynx surface of epiglottis and lowest density in the vocal folds.

喉各分区淋巴管分布具有显著差异，其中以会厌喉面分布密度最高，声襞淋巴管的分布密度最低。

The Polarization Vector P and the Effective Charge Density and Surface Charge.

极化向量 P ，有效电荷密度与表面电荷。

The French are not suggesting a new EU treaty, but they have plenty of other wheezes.

法国人并不是在建议签署一个新的欧盟条约，但他们有许多其他的阴谋。

This letter was written by my brother.

这封信是我弟弟写的。