查询词典 strength

The strength of different rennets can vary, though usual strength varies between 1:10,000 and 1:15,000 ie one part rennin can coagulate 10-15,000 parts milk.

强度的不同rennets可以有所不同，但一般强度不等1：10000和1：15000的一部分即肾素可以凝聚10-15000部分牛奶。

The nanocomposite was superior to the pure polymer in thermal stability , tensile strength and right-angle tearing strength.

纳米复合材料的热稳定性、拉伸强度和直角撕裂强度均比纯聚乙烯醇有很大提高。

In the 5th chapter, the application of Multi-Agent technology in Concurrent Engineering is studied. With the shaft strength and rigidness analyzing agent and gear strength analyzing agent as examples, an agent model is studied and provided. A federated multi-agent infrastructure based on product assembly model and multiple analyzing agents is suggested. By this, cooperation under distributed and heterogeneous environment and efficient information integration among mechanical geometry product modeling system, assembly modeling system and analyzing system can be realized.

第五章研究了多代理（Multi-Agent）技术在并行工程中的应用，以转轴强度与刚度验算代理和齿轮强度验算代理为例子分析了代理的模型，研究并提出了一种基于产品装配模型和多分析计算Agent的联邦制体系结构，该体系结构能够支持异构分布环境下的协同工作，能够实现机械产品几何造型系统、装配建模系统、分析设计系统之间的有效集成。

In chapter 4, which is about the research of corrosion reliability analysis for mechanism, the paper improve the strength method into the reliability method, according to that the regular strength method about corrosion has been somewhat ripely but still doesn't formulate the related Reliability Method.

本文在第四章机构腐蚀可靠性研究，针对腐蚀的常规强度解决方法已较成熟，但还没有形成对应的可靠性研究方法，该章的研究内容为将强度解决方法发展至可靠性分析方法，是方法上特性类别的提高。

And introduces the establishment of a unified structural strength standard and a non-uniform roadbed structural strength standard.

介绍了统一结构强度标准的建立方法和非统一的基层结构强度标准。

So it usually needs to roughen the surface toimprove the bonding strength. But the coarseness was not used in this paper. The technique ofarc spraying zinc in advance and then arc spraying copper was put forward to solve the problemof bonding strength.

而本研究根据锌喷涂层具有较好的附着性，提出了在电铸层上先喷涂锌后喷涂铜的工艺路线，较好地解决了铜喷涂层与电铸层结合强度偏低的问题。

The result makes clear: CF surface acidity is luscious it is good to increase and increase effect of acid treatment of; thick saltpetre what round amount handles time as thick nitric acid to oxidize than air, when the time that handles CF when thick nitric acid is 20 Min, tensile strength of CF/TPI composite material and flexural strength rise respectively 10% with 14%, XPS shows CF surface active is right now luscious the group increases than was not being handled 35.89%.

结果表明：CF表面酸性官能团的数量随着浓硝酸处理时间的增加而增加；浓硝酸处理效果比空气氧化好，当浓硝酸处理CF的时间为20 min时，CF/TPI复合材料拉伸强度和弯曲强度分别提高10%和14%，XPS表明此时CF表面活性官能团比未处理增加35.89%。

To meet the requirements of workability and high early strength of the concrete, the mix proportion of the concrete for main girder is designed with set retarding, high pumpability, high early strength in low water/binder ratio through optimization of quantities of binder and fly-ash, and optimization of water/binder ratio and sand ratio.

以混凝土的工作性和强度特别是早期强度为设计依据，通过胶凝材料用量、粉煤灰掺量、水胶比和砂率的优化，确定了兼具缓凝、早强、高强、易泵的主梁混凝土配合比。

It provided the reference to improve the anti-cracking capability of high strength and high performance concrete from the point of view of constructional technology and curing requirement.The result shows that the more the binder material or sand rate, the more serious the shrinkage cracking. In the concrete with a low water-to-binder ratio, a bit of difference in the dosage of water will result in big difference on the strength and the anti-cracking capability. The occurrence of cracking is mainly at early age (before 1 day). If the surface is plastered again after 2 hours of casting, the anti-cracking capability will nicely improved.

研究结果表明：随着胶结料总量和砂率的增大，高强高性能混凝土的收缩开裂趋于严重；在水胶比较低的情况下，用水量的稍微差别对混凝土的强度和抗裂性能都具有很大的影响；掺入粉煤灰对抗裂有所改善，但是其掺量对抗裂的影响并不是呈定向规律，而是存在着最优掺量；高强高性能混凝土的裂缝主要发生在早期(1d前)，若在浇注后2个小时再次抹面可以很好地改善其抗裂性能。

The main contents of the course include: Traditional ship design method based on empirical classification rules; Modern ship design method based on the first principles approach. Structural loads, loads combinations and loading criteria; Ship structural components configuration and arrangements; Ship initial scantling calculation based on the new rules; Ship total strength assessment including yielding, buckling and ultimate strength analysis.

主要内容包括：基于传统的船级社半经验公式的船舶设计方法；基于第一原理的现代结构设计方法；结构设计载荷，载荷组合和载荷衡准；结构部件选型和布置；基于新规范的结构构件初始尺寸计算；船舶结构整体强度分析，包括：屈服，失稳和终极强度分析。

Eight cases of simple chordee of penis were adopted urethral extending.9 cases of severe simple chordee of penis were adopted primary urethroplasty.

8例单纯性阴茎下弯患者采取尿道延伸术，9例重度阴茎下弯患者采取切断尿道矫直阴茎一期尿道成形术。

She is a daintily dressed young lady.

她是个装饰娇艳的少女。