查询词典 stove drying

Through drying the methyl chloride drying tower, analyzing the bed temperature profile on regeneration process and comparing the theoretical cycle and actual cycle , this paper gave the proper operation cycle and improving suggestions for drying tower operation.

通过对氯甲烷干燥塔的干燥、再生工艺过程的床层温度分布曲线分析以及干燥塔理论周期与实际使用周期比较，总结出干燥塔的合理使用周期，并对干燥塔的工艺操作提出改进建议。

The paper introduced the principle ,the test conditions and the operation steps of dry-ing the pyrethrum flower ;The four drying methods :drying the air flow ,far infrared ray ,sunsh-ing and vacuum were described ;The drying conditions ,the moisture of tile dry flower and extrac-tion.

本文主要介绍了除虫菊鲜花的真空冷冻干燥技术的原理、条件和操作步骤。

In experiments, performances of the chamber density, the cooling speed of cold trap, and the efficiency of heat exchanger are all better than the contrast machine, so do the results of drying volume of the experimental machine, water capture of cold trap, drying efficiency, and electricity consumption in drying experiments of water.

在实验中发现腔体的气密度、蒸发吸附盘管降温速率及热交换器的效率皆比市面上对照机台佳，且在水的乾燥实验中，实验机台的抽水量、蒸发吸附盘管捕水量、抽水效率及耗电量皆优於对照机台。

Accounting for the characteristics of freeze-drying of granular material, a theoretical heat transfer model of atmospheric freeze-drying in spherical geometry was developed. The temperature distribution and movement distance of sublimation interface were calculated, then the speed of drying process can he deduced. Theoretical analysis was done on influence factors such as bed temperature, material size and adsorbent diameter.

以粒状物料为例，建立了球坐标下常压冷冻干燥的传热过程理论模型，计算了物料干燥过程中的温度和升华界面的移动距离，并对床温、物料尺寸和吸附剂粒径等影响因素进行了理论分析。

The results of tests showed that even the Sugi square lumbers ware difficult to be dried, the better drying quality especially with less checks will be reached if some special pre-treatment methods were taken before the RFN drying, such as, steaming and superheated-steam pre-treat on Sugi lumbers; another, make kerf along the length direction of lumber before the drying.

结果表明，柳杉髓心方材虽难干燥，但在高频真空干燥前对木材进行合理的处理，例如：蒸汽和过热蒸汽预处理：沿木材长度方向制作一定深度和宽度的切口等，都可有效地提高干燥质量，尤其可减少开裂产生。

The results showed that there existed variation among eucalypt families in wood physical-mechanical properties and wood chemistry. There were significant differences among E.pellita families、E.grandis families and E.urophylla譋.grandis clones in wood colors as well as between Strains and within trees.The variation of the surface wetability of wood between E.grandis families and E.urophylla譋.grandis clones were significant.Even in the same families level or clones level,there still existed the same regulation. The degree of collapse of eucalypt had a large relation in the amount of tylosis in vessel and vestured pits on the cell wall of vessel. The more rich tylosis and vestured pits in vessels,the more probability to occur collapse for eucalypt.The biggest moment collapse was probably the critical point of the drying degrade.During the fomulation of drying technology,it is necessary to adopt moderate condition to make the vessels which had formed the biggest moment collapse at the biggest moment collapse resume,especially to prevent the permanent set.At the normal temperature level,the main factors which influenced residual collapse were the contents of ray parenchyma and axial parenchyma .Nearly all the cells joined the course of forming the moment collapse and biggest moment collapse.Interval drying was fit for eucalypt plantation which was easier to make collapse.

研究表明：桉树不同家系间木材物理力学性质和化学组成存在差异；粗皮桉家系间、巨桉家系间、尾巨桉无性系间材色存在显著差异，株间、株内木材材色存在变异；桉树木材表面润湿性在巨桉家系间、尾巨桉无性系间存在着显著差异，在同一家系或同一无性系中，株间和株内也存在着相同的变化规律；桉材皱缩程度与其导管中侵填体的多少和导管壁上纹孔具有的附物多少密切相关，侵填体含物越丰富，纹孔附物越多，桉材越容易皱缩；最大瞬间皱缩是能产生更大干燥降等的临界点，在制定干燥工艺时，必须在最大瞬间皱缩发生时，采用温和条件，使已产生最大瞬间皱缩的细胞尽可能多的恢复，尤其不能使其产生永久变定；在常温条件下，影响残余皱缩的主要因子是射线薄壁细胞和轴向薄壁细胞含量；而对于瞬间皱缩和最大瞬间皱缩，几乎所有细胞都参与它们的形成过程；对于易皱缩的桉树木材，间歇干燥是最有前途的干燥方法。

In order to find the reasonable methods to control latex migration, factors that had effect on latex migration were studied, including co-binder carboxy methyl cellulose (CMC and starch , properties of latex, type of pigments and ratio of different pigments, coating solids content, coating weight, hot air drying compare to infrared drying and drying temperature.

为了探讨合理的控制胶乳迁移的方法，本文对胶乳迁移的主要影响因素进行了研究，包括辅助胶粘剂羧甲基纤维和淀粉、胶乳的性能、颜料种类和配比、涂料固含量、涂布量、热风和红外两种干燥方式以及干燥温度。

The energy sources to operate the drying room are 692 m3 Natural Gas and 19,3 KW/h Electricity for one drying cycle (dryingon 19.11.01 read off by Herby Dunn or refer Appendix VIII, Embodied Energy Rapid Wall, drying room).

运行一个干燥工序的干燥室的能源是692 m3 的天然气和19，3 KW/h的电（01年11月19日的干燥，由荷尔比·顿读取或参照附件VIII，速成墙体现能，干燥室）。

Calcium lignosulphonate would reduce drying shrinkage, the influence of superplasticizer on drying shrinkage is related strongly to the water cement ratio of mortar. When the water cement ratio is lower (0.3 or 0.4), superplasticizer would increase drying shrinkage, which increases with water cement ratio decrease.

本论文采用固定砂浆中单位体积用水量、浆体体积含量和骨料量的方法，研究了化学外加剂和矿物掺合料对砂浆干缩性能的影响，并通过微观分析和压汞测孔的方法探讨了其对干缩性能影响的机理。

Drying experiment of pelleted corn seed was conducted through three factor and three level orthogonal experimental design, its drying characteristic curve was obtained as an index curve, and the effects of various experimental factors on drying property were analyzed....

采用正交试验的方法，对玉米丸粒化种子进行了 3因素 3水平的干燥试验，得出其干燥曲线为指数曲线，并分析各试验因素对干燥特性的影响。

After oxidation, pH value of the surface of carbon black has a specific relation with the volatile content.

氧化后炭黑表面的pH值与挥发分之间有一定的关系。

Knowing that such a person is warped and sinful; he is self-condemned.

因为知道这等人已经背道，犯了罪，自己明知不是，还是去做。