查询词典 solidified

Low cycle fatigue tests of a directionally solidified nickel base superalloy were conducted at elevated temperatures.

本文研究了一种定向凝固镍基高温合金的高温低周疲劳行为。

Pseudo- oriented solidification microstructures have been found in the rapidly solidified iron disilicide ribbons, and lead to textured structures in the bulk b-FeSi2 based alloys, which means there exists some orientation relationship between the a- and b-FeSi2 phase.

实验发现，快速凝固FeSi2合金薄片粉末中存在伪定向凝固组织，它导致了热压后的b-FeSi2基合金块体材料中的织构。这表明FeSi2合金的a相和b相晶粒之间存在特定取向关系。

The words meaning had ecumenic transfer after the shape was solidified.

四典故词语词演化出与典源具有明显差异甚至相反的意义。

Three components of peroxide in the activator amongwhich have the different decomposed temperatures made the Vinyl-ester resinsolidified heat discharge increased that gained a bigger solidified degree. Theactivator-adopted quantity can dramatically affect the casting samples performance:eg. When use 1.0-1.4 portions of activator, the casing sample can reach its maximumTensile strength and Bend strength; when use more activator, the polymeric meshworkcontracted which embrittle the casing sample and reduce the dynamic performance; Inthe Pultrusion processing, when CF composed of about 60vo1%, more demould agentcan bring the better processing but degrade the CFRP, normally use around 1.2 portion.

采用具有不同分解温度的三组分有机过氧化物引发剂，乙烯基酯树脂的固化反应放热量增加，固化程度提高；引发剂用量对浇注体的性能影响很大，在用量为 1.0~1.4 份时，浇注体拉伸强度剂弯曲强度达到最高，过多的引发剂使聚合网络减小，浇注体变脆，力学性能降低；在拉挤成型工艺中，碳纤维的体积含量一般为 60%左右，脱模剂增加使加工性能好转但会使复合材料性能下降，一般用量为 1.2 份。

He solidified his power base in 1171 when he overthrew the Fatimid dynasty, returning Egypt to Islamic orthodoxy and becoming sole ruler there.

他夯实了他的权力基础，在1171年时，他推翻了的法蒂玛王朝，回到埃及伊斯兰极端正统，并成为唯一的统治者。

The results showed that the growth of root tips in liquid medium was better than that in agar-solidified medium and solid-liquid two phase medium, for that increasing agar concentrations in medium will reduce the root growth; darkness was beneficial for Fraxinus mandshurica root tip culture in vitro; as the carbon sources, sucrose was better than glucose and maltose as the carbon ...

结果表明，不添加琼脂的液体培养基对根尖的生长较添加琼脂的固体培养基和固—液培养基好，原因是增加琼脂的量会抑制根的生长；暗培养比光培养更有利于水曲柳离体根尖的培养；蔗糖作为碳源的效果较果糖和麦芽糖好，其中以3%的蔗糖对离体根尖的生长效果最好。

The Solidification temperature range was defined as 110-200℃ by DSC analysis. More accelerant used can increase the casing samples dynamic performance, but more than enough accelerant can induce a severe solidified reaction that result in a smaller polymeric meshwork and reducing the sample's performance. Normally the Accelerant dosage can be 2 portions; The Epoxy resin CFRP has a obvious better performances than the Vinyl-ester Resin CFRP, i.e. had a Bend Strength of 1516MPa, LSS of 85MPa, also Tg raised to 195~C~ When used the end-carboxyl polyether to reinforce the epoxy resin, the casing sample's SS, BS and Crack Elongation all increased geminately. The CFRP performance also increased a little, that is because the performance of the CFRP mainly contributed by the CF. The reinforced resin improved the interface between the CF and resin that contribute to the little increasing.

通过DSC分析确定了该环氧树脂的固化温度范围为110~200℃，促进剂增加会提高浇注体力学性能，但过多的促进剂会使固化反应剧烈，聚合网络减小，使浇注体性能下降，一般用量为2份左右；以环氧树脂为基体的复合材料性能明显比以乙烯基酯树脂的性能提高，弯曲强度达到1516MPa，层间剪切强度达到85MPa，同时Tg也上升到195℃；用端羧基聚醚增韧环氧树脂后，其浇注体的拉伸强度、弯曲强度及断裂伸长都成倍增加，复合材料的性能也有所提高，但提高幅度不大，因为复合材料的力学性能主要由碳纤维承担，树脂增韧后改善了复合材料的界面性能。

Permeability of clay-solidified grouting curtain to leachate. The influence of components and their ratio of grouts, concentration and pH of leachate on permeability are studied with laboratory experiment, and the functional formula of hydraulic conductivity and content of clay and cement is brought up. Then the effects and the characters of CSGC anti-seepage to contaminant such as heavy metals and organic matter are studied.

对浆液配比、渗滤液浓度、pH值等对粘土固化浆液结石体渗透性能的影响进行了室内试验，首次给出了结石体渗透系数与粘土加量和水泥加量之间的函数关系式，研究了帷幕对不同污染物的抗渗效果和阻滞特征，并分析了其渗透性能变化的微观作用机理。

The changes of solidified structures of Sb-4.8wt.%Mn hypoeutectic alloy under uniform and gradient magnetic fields were examined.

研究了均恒磁场及梯度磁场条件下Sb-4.8%Mn亚共晶合金凝固组织的变化。

The microstructures of hypoeutectic and hyper-eutectic Al-Cu and Al-Si alloys solidified at high pressure (5 GPa) were investigated.

研究了亚共晶或过共晶Al-Cu和Al-Si合金在5 GPa压力条件下凝固的显微组织特征。

The French are not suggesting a new EU treaty, but they have plenty of other wheezes.

法国人并不是在建议签署一个新的欧盟条约，但他们有许多其他的阴谋。

This letter was written by my brother.

这封信是我弟弟写的。