查询词典 shear angle

In this paper,one contrast reinforced concrete short column and three reinforced concrete short columns strengthened with concrete and exterior steel plate were tested to investigate their shear behaviors,based on experiment results,it is revealed that complex strengthening with concrete and exterior steel plate can impactful improving shear bearing capacity of reinforced concrete short column.

进行了1根对比钢筋混凝土短柱和3根用混凝土和外包钢板复合加固钢筋混凝土短柱的受剪试验研究，试验结果表明，用混凝土和外包钢板复合加固可有效提高钢筋混凝土短柱的斜截面抗剪承载力。

Misplacement of the shearing tool produces invalid bond shear failures, the shear force readings of which must be excluded from analysis.

因剪切刀头放置位置错误而产生的读数是无效的，不应供分析使用。

Based on series of models, the dynamic characteristics of frame-shear wall structure with variable shear wall stiffness are studied.

通过计算大量的算例模型，研究了不同的剪力墙刚度对高层框架-剪力墙结构动力特性的影响。

It is very important to control the shear wall structure's quantity and layout, too many shear walls can not only increase the earthquake effect, but also be less economic.

2剪力墙结构设计中，控制剪力墙数量和布置是一项重要工作，过多的剪力墙不仅增大了地震作用，且更不经济。

A stress-strain diagram can be plotted using shear stress and shear strain.

应力-应变图可以用来表现剪切应力与剪切变形。

The only strain is a shear strain and the dilatation is zero, these waves are called shear waves

唯一的应变是剪应变而没有膨胀，这种波叫剪切波。

And the planes of maximum shear stress and shear strain are at angles about 50° and 140° with respect to the sliding direction.

轮轨接触表面附近的最大剪应力和剪应变平面与滑动方向所成夹角约为50°和140°。

The purpose of this study is discussing the shear stress and strain rate relation under different silt allocated proportion and different water content, and the viscosity coefficient and yield shear stress are estimated.

本研究旨在探讨模型材料在不同的泥砂配比及不同的含水量下剪应力和应变率的关系，并推估其黏滞系数和降伏剪应力。

The problems in current manufacturing and research of the national flying shear have been presented with the prospect for the application of the flying shear in the steel rolling production line.

指出了目前国内在飞剪机生产和研究过程中存在的问题。展望了飞剪机在轧钢生产线上的应用前景。

The principle of the hydraulic shear system, the change of the shear force in the steel bar cutting-off process, and the structure and action principle of the buffer of the cylinder were analyzed at first in the paper.

文中首先分析了液压剪切系统的原理、钢筋切断过程中剪切力的变化以及液压缸缓冲的结构和作用原理。

Connectors are lines that can be anchored to particular places, called glue points , on the graphic object.

连接符，可固定在图形对象的特定的地方的线条。

Another way of putting it, too many agents have a say in each other's work, and bureaucratic rigor mortis sets in.

另一种表达是，太多的作用物在彼此的工作里都有话语权，官僚的僵尸开始抬头。