查询词典 sensitivity threshold

The threshold side beam's sensitivity was calculated in detail model by Hypermesh software, and compared the result with the sensitivity that was calculated in conception model by Nastran.

在HyperMesh软件计算了详细模型中门槛侧梁的灵敏度，并与在概念车身模型中求得的灵敏度进行了比较，结果证明，在概念设计阶段研究梁截面对车身刚度的影响是可行的。

Methods Compare the area under ROC curve of proportional odds model and its standard errors with of common methods, such as binormal model; evaluate the goodness of fit for the parametric models using the sum of square of residuals of sensitivity and determination coefficient between actual sensitivity and estimated sensitivity.

比较比例优势模型与双正态模型等经典方法所计算的ROC曲线下面积及其标准误；采用灵敏度残差平方和与决定系数两指标评价参数模型的拟合优度。

Measurements of sensitivity showed that the films annealed at 500℃ had high ethanol sensitivity (67%), the sensitivity of butane is not high in the temperature around 225℃.

退火温度500℃的样品在工作温度225℃时，对乙醇有较高的灵敏度，灵敏度达67%，对丁烷的灵敏度不高。

The results showed that: 1 reinders' redox buffers were used to study the redox properties not only for latent image centers but also for sensitivity centers; 2 The redox potential of Ag2S sensitivity centers was less negative than －220 mV with respect to the saturated calomel electrode in our experiment and the redox potential of latent image centers was between －220 mV and －190 mV; 3 The redox activities of latent image centers were much higher than that of sensitivity centers.

实验结果表明：1Reinders的氧化还原缓冲液的方法，不仅可用于研究潜影中心，也可用于研究敏化中心；2本实验条件下的硫化银敏化中心的氧化还原电位约略负于－220 mV，潜影中心的氧化还原电位值是介于－220 mV与－190 mV之间；3潜影中心的氧化还原活性较敏化中心大得多。

In view of practical problem during Sulige gas field development, this paper complete follow study content. Study material balance theory of two district compound gas reservoir. Carry out stress sensitivity experiment on matrix rock and labor created fracture core from Sulige gas field with America Core Company high pressure high temperature flow experimental instrument to study stress sensitivity change rule of different permeability matrix rock and created fracture core at the condition of time and again switch on and off well and different drawdown pressure. Carry out depletion experiment on matrix rock of different permeability serial combination with different kinds of allocation, using double core clamper serial connected experimental apparatus, to study gas well production performance of bi-zonal compound low permeability reservoir during low pressure production stage. At the basis of experimental study, establish single well simulation model to analyze development index infection caused by stress sensibility and production performance infection rule caused by inner formation and outer formation of bi-zonal compound gas reservoir permeability variation while considering stress sensitivity.

针对苏里格低渗气田开发中存在的实际问题，完成以下研究内容；研究了两区复合气藏物质平衡原理；利用美国岩芯公司高温高压流动实验仪，对取自苏里格气田基质岩芯和人工造缝岩芯进行应力敏感实验，研究不同渗透率基质岩芯和造缝岩芯在多次开关井和不同生产压差条件下的应力敏感变化规律；采用双岩芯夹持器串联实验装置，对不同渗透率串联组合的基质岩芯进行各种配产条件下的衰竭实验，研究两区复合的低渗储层气井在低压生产阶段的生产动态特征；在实验研究的基础上，建立单井模拟模型分析储层应力敏感性和非均质性对开发指标的影响，研究考虑应力敏感时两区复合气藏储层中内区和外区渗透率变化对开发动态的影响规律。

Furthermore, the compression-sensitivity of CFRC, which suffers three-direction-pressure is studied.Thirdly, present method of carbon fiber treatment is summarized. Treat the surface of carbon fiber with GLBE, the influence of surface-treatment of carbon fiber on the distribution and compression-sensitivity of CFRC was studied. According to the contrast of the compression-sensitivity before and after surface treatment, as well as the contrast of the distribution of carbon fiber in cement mortar, it is found that GLBE is able to improve the dispersiveness of carbon fiber.

再次，总结现有碳纤维的表面处理方法，选用液相气相双效法对纤维进行表面处理，并研究碳纤维的表面处理对纤维分散性和CFRC的压敏性的影响，通过对表面处理前后试块的压敏性和碳纤维在水泥浆体中的分散性的对比，发现碳纤维的液相气相双效法表面处理可以改善纤维的分散性，而且在循环荷载作用下还发现用这种表面处理的纤维制成的碳纤维混凝土对应变变化感应的稳定性和重复性得到有效提高。

Results:The spective sensitivity value of cTnI,CK-MB and Mb were 93.3%,86.7% and 78.3%;the spective specificity value were 100%,100% and 88.0%;the sensitivity and specificity value of both cTnI and Mb were 96.7% and 88.0%;the sensitivity and specificity value of all cTnI,Mb and CK-MB were 98.3% and 88.0%;the positive and negative expectative value were 95.2% and 88.0%.

结果：患者入院后24 h内cTnI、CK-MB和Mb对AMI的敏感性分别为93.3%，86.7%和78.3%，特异性分别为100%，100%和88.0%；同时检测cTnI和Mb时AMI的敏感性为96.7%，特异性为88.0%；同时检测cTnI、Mb和CK-MB时AMI的敏感性为98.3%，特异性为88.0%，阳性预期值为95.2%，阴性预期值为88.0%。

As the sensitivity matrix got by numerical differentiation in elastoplastic problem can not ensure the efficiency and stability in back analysis computation, an integration formula of sensitivity matrix is presented, in which sensitivity matrix can be obtained analytically.

针对弹塑性反分析差分敏度矩阵计算的效率和稳定性难以保证的情况，通过对弹塑性反分析敏度矩阵计算的全面分析和探讨，给出了弹塑性状态下反分析敏度矩阵的积分表达式。

In order to compare the convergence of the importance sampling based reliability sensitivity analysis and Monte Carlo based reliability sensitivity analysis, the variance and variation coefficient of the reliability sensitivity assessment are derived in this contribution.

为了比较重要抽样与直接Monte Carlo方法在分析可靠性灵敏度时的收敛性，推导可靠性灵敏度估计量方差和变异系数的计算公式，近似计算重要抽样可靠性灵敏度估计量在给定置信度下的置信区间。

The analysis of the mechanical sensitivity and the density indicated that the system which contained the F rubber, ceresin and graphite had a very good effect on shaping performance and mechanical sensitivity. Both the friction and impact sensitivity were 0. When the pressure reaches to 900 kg/cm2 the density ratio could achieve 99.2%.

对机械感度和压制药柱密度的测量和分析，研究结果表明在九种粘结-钝感体系中，F橡胶、蜡类钝感剂、石墨组成的粘结-钝感体系成型性能和机械感度最为优越，其摩擦和撞击感度都为0.00，900比压时可压系数可达到99.2%。

After explaining total design of automated test system for microcircuit , the thesis introduces GPIB standard .

文章在说明了微电路模块自动测试系统的总体设计后，对GPIB标准进行了介绍。

He interceded in my behalf.

他替我说情。