查询词典 rotational speed

So in this paper based on the characteristics and the optimum state theory of the vehicle, some kinds of control schemes are compared and discussed, and the fuzzy PID control scheme is adopted at last. The relation between air-cushion pressure and fan rotational speed on the optimum driving state is studied. The cushion pressure is used as controlled variable and the fan revolution is used as regulated variable. And transducer and fan motor are actuators.Based on the structure and operating properties of half-tracked air-cushion vehicle, the control system scheme and structure are presented. A control scheme using the self-tuning PID fuzzy logical controller is adopted. Fuzzy rules are set up and some researches have been done for fuzzy tuning method. At the same time the real-time measurement scheme by computer control is proposed, and electric circuits are designed. In the control system of half-tracked air-cushion vehicle cushion pressure P〓 is used as controlled variable and the fan speed n〓 as regulated variable.

因此本文以半履带式气垫车的特性和最佳工作状态理论为指导，通过对各种控制方法的比较与探讨，提出采用模糊PID控制方案，并且研究了在最佳工作状态下垫压及风机转速的关系，提出气垫压力作为控制参数，变频器和风机电机为执行机构，风机转速为调节量；主要进行了自整定模糊PID控制器的设计，研究了自整定PID模糊控制器的实现方法，编制了模糊控制规则，制定了模糊控制参数查询表，并分析了影响自整定模糊控制器相关的影响因素，确定了模糊控制表；为了实现半履带式气垫车的自动控制，还提出了计算机模糊控制系统的原理与结构，设计了相应的测量电路与控制软件。

The effects of acidity, reaction temperature, feeding mode, and rotational speed of the stirrer on the particle size of AC blowing agent were studied. The optimal conditions were obtained as follows: the catalyst composed with m:m(V2O5)=1:1 equal to 1%-2% ratio of the reagent''s mass,reagent reacts at 50℃ under pH=3-4 for 25min with 350～360r/min of the stirrer speed, and the NaClO3 solution must be added from burette.

研究了酸度、反应温度、加料方式、搅拌器的转速对AC发泡剂粒径的影响，最佳工艺条件为：催化剂m：m(V2O5)=1：1的质量约为反应物质量的1%~2%，反应体系的pH值3～4，反应温度控制在50℃左右，氯酸钠溶液(质量分数20%)采用通管滴加的方法加入，整个反应时间约为25min，搅拌器的转速一般控制在350～360r/min。

Head in the disk rotational speed and the speed of operation remain unchanged, the same time, head-to-disk can visit some of the region.

在磁盘转速和磁头的操作速度不变的情况下，相同的时间内磁头所能访问到磁盘的区域是一定的。

A large number of simulation experiments of regenerating the hybrid vehicle's inertial energy are done on the experimental equipment adopting the single neuron self-adaptive PID algorithm to control the brake speed, torque and power, and a large number of simulation experiments of regenerating the hybrid vehicle's gravitational energy by constant rotational speed are also done.

研究设计了可以模拟车辆串联混合传动系统驱动、制动和坡道行驶工况的二次调节综合实验台，建立了实验系统的数学模型；采用单神经元自适应PID控制算法在二次调节综合实验台上进行了车辆串联混合传动系统转速控制制动、恒扭矩制动和恒功率制动回收车辆惯性能的模拟实验，进行了恒转速控制回收车辆重力能的模拟实验，通过实验验证了理论分析的正确性。

Features: the series is hard backing horizontal dynamic balancing machine, using the wheel backing, universal coupling to drive, the popular style is two-speed electric - driven,"A" is variable-frequency electromotor plus inverter speed, industrial control computer data processing, color screen real-time shows the value of the amount of unbalance ,phase and real-time rotational speed, bases have adopted the overall foundry, stability is good.

特点：该系列是硬支承卧式动平衡机，采用滚轮支承，万向联轴节驱动，普通型为双速电机驱动，"A"型为变频电机加变频器调速，由工业控制计算机进行数据处理，彩色屏幕实时显示不平衡量值，相位角和实时转速，床身均采用整体铸造，稳定性好。

In the design of the road test, a reflectional infrared sensors is used to detect the black line on the road to judge the trolley's position; on trolley's speed controlling, the control system uses PWM technology to control the rotational speed of electric motors, and complete the speed real-time control to electric cars in d

在路面检测设计中，小车采用反射式红外传感器来检测其行驶路面上的黑线，以判断小车行驶的位置；在控制小车行驶速度上，系统利用PWM技术控制电动机的转速，通过程序完成对电动小汽车在不同路段的行驶速度实时控制；最后采用双电源供电，用以保证系统的运行更加稳定，可靠。

The agitation power consumptions in boiling systems decrease uniformly with the increase of agitation speed, whereas the relative power demand (RPD-the ratio of agitation power input of HEDT for gassed system to that for ungassed system and under the same agitation speed) can maintain at a high level for high gas loadings even when the impeller is operating with a high impeller tip speed. The gas hold-up in the boiling system is much lower than that in the cold gassed system, and the gas hold-up in boiling system increases at first and then decreases with the increase of the agitation power consumption per liquid mass P(subscript m. It implies that the boiling three-phase system has a maximum gas hold-up point. The changes of nucleation site of vapour bubble and the character of suspension of the solid particles with the rotational speed of the impeller are responsible for those behaviors mentioned.

在沸腾条件下，搅拌功率消耗随着搅拌转速的增加有所下降，但HEDT桨具有较高的载气能力，即使在高叶端线速度下，相对功率消耗仍能保持在较高的水平；沸腾体系的气含率随单位质量流体输入功率的增加表现出先增后减的规律，即存在气含率的极大值，蒸汽成核位置和固体颗粒悬浮特性随搅拌功率增加而改变是造成上述行为的主要原因；沸腾体系中的气含率远远低于常温通空气体系。

The relative leakage flow coefficient decreases with the increase of the rotational speed, and the leakage flow rate of the labyrinth seal at the high rotational speed of more than 6 000r/min decreases by 5.1%.

采用标准k-ε紊流模型和三维RANS方程求解方法，数值研究了密封间隙、压比、转速对典型迷宫密封泄漏特性的影响规律。

Compared the voltage negative feedback wire-feeding speed regulation system supported by current positive feedback with the rotational speed negative feedback regulation system, the equivalent condition of the two systems is obtained. Then, a wire-feeding speed regulation circuit for the CO_2 welding machine is designed based on TL494 chip, which has the self-protective function under the condition of current overloading.

通过对电压负反馈配合电流正反馈的送丝调速系统与转速负反馈调速系统的比较，得出了这两种调速系统的等效条件，并采用电压负反馈配合电流正反馈技术，设计了一种以TL494为核心的具有过电流截止保护功能的CO_2焊机送丝调速电路。

NJWGY3665 bacterial strain is inoculated in a glucose nutrient culture medium to carry out the slant culture, the culture temperature is 28 to 37 DEG C and the culture time is 2 to 6 days;(2) seed culture: a spore which is cultured on a slant is produced into a single-spore suspension by using sterile water, which is also inoculated in a seed culture medium for culture, the temperature is 28 to 32 DEG C, the rotational speed is 200rpm and the culture lasts for 2 to 6 days;(3) fermentation culture: the seed liquid is inoculated in a fermentation culture medium for culture, the temperature is controlled at 28 to 37 DEG C, the pH is controlled at 6.0 to 9.0, the rotational speed is 180 to 220rpm, the fermentation lasts for 5 to 9 days, so as to obtain the Streptomyces sp., methanol or ethanol is used for the extraction and separation of mycelium through the method of centrifugal separation, then the resin method is adopted for carrying out refining, so as to obtain the peptide antibiotics enramycin.

NJWGY3665菌种接到葡萄糖营养培养基中，进行斜面培养，培养温度28-37℃，培养时间2-6天；(2)种子培养：用无菌水将斜面上培养的孢子制成单孢子悬液，并接种到种子培养基中培养，温度为28～32℃，转速为200rpm，培养2-6天；(3)发酵培养：将种子液接种到发酵培养基中培养，温度控制在28-37℃，pH控制在6.0-9.0，转速180-220rpm，发酵5-9天，得到链霉菌，采用离心分离的方法将菌丝体用甲醇或乙醇进行提取分离，再采用树脂方法进行精制，获得多肽类抗生素安来霉素。

What are your goals and strategies for growth?

你的成长目标和策略是什么？

And unto the angel of the church in Sardis write; These things saith he that hath the seven irits of God, and the seven star I know thy works, that thou hast a name that thou livest, and art dead.

3：1 你要写信给撒狄教会的使者，说，那有神的七灵和七星的，说，我知道你的行为，按名你是活的，其实是死的。