查询词典 resulting

Local causes of uterine atony is the twins, fetal macrosomia, polyhydramnios, etc., uterine muscle fibers over-extended, over-expansion of the uterus, resulting in reduced post-partum resumption of non-performing.

宫缩乏力的局部原因就是双胎、巨大胎儿、羊水过多等，子宫肌纤维过度伸展，子宫过度膨胀，造成产后缩复不良。2、如果生第二胎，同样的事情未必会发生。

Applying LMI technique, quadratic stability theory, and H〓 control theory, three methods of robust stability analysis and robust controller design for uncertain fuzzy systems are proposed respectively. Among them, LMI based technique can analyze the uncertainties raised in the premises and in the consequent of fuzzy systems. The resulting stabilizing state feedback controllers have maximum stability margins for both kinds of uncertainties. Quadratic stability theory based approach can apply LMI technique and other methods to design fuzzy controllers. H〓 control theory based design can get H〓 controller with constant disturbance attenuation for each local subsystem. Using the given stability criterion of generalized systems, the robust stability of fuzzy systems can be checked.

其中，基于LMI的方法可分析由模糊系统的前件或后件引起的不确定性，得到的稳定的状态反馈控制器对这两类不确定性具有最大的稳定裕度；基于二次稳定理论的方法可应用LMI技术和其它方法设计模糊控制器；基于H〓控制理论的方法可得到各局部子系统具一定干扰抑制性能的鲁棒H〓控制器，而全局系统的鲁棒稳定性可应用所给出的稳定条件进行检验。

The level of attrition resulting from this system is both high and costly.

起因于这个系统的损耗的水平是高和昂贵的。

Another approach in enhancing the light extraction efficiency of AlGaInP LED was accomplished using a surface roughening process. In this process, the Au(170 nm)/AuBe(260 nm)/Au(170 nm) ohmic contact layers were first deposited on the GaP window layer. After the alloy annealing process (480°C for 10 min), the Be atoms will diffuse into the GaP top layer and form non-uniform clusters. The LED samples were then immersed into a mixture 3H3PO4:1H2O2:1H2O solution for 6 min, resulting in a rough GaP surface. The luminous intensity of the AlGaInP LED can increase from 42 to 50 mcd, that is, an 18% enhancement can be achieved via the present non-photolithography surface roughening process.Keywords: LED, AlGaInP, Cu substrate, Reflector, Surface roughening

在实验的第二部份是开发磷化镓窗口层之粗化制程，我们是藉由正面金/铍欧姆接触电极之熔合制程，使铍扩散至磷化镓层，同时利用铍渗入磷化镓造成之特殊组成，可形成不均匀之蚀刻阻挡，而在磷化镓表面形成粗化，我们发现480℃、10分钟的熔合制程，加上浸泡磷化镓蚀刻溶液6分钟，可将四元发光二极体之发光亮度由42 mcd 提升到50 mcd，经由此无光罩粗化制程可将亮度提升18%，明显提升磷化铝铟镓发光二极体之外部量子效率。

In audio, a very low frequency oscillation often resulting from a positive feedback path in an amplifier system .

在音响设备中出现的振荡频率极低的低频振荡，常因放大系统的正反馈回路引起。

By means of augmented Lyapunov functional and free-weighting matrix approach,a delay-dependent sufficient condition is presented,which can make the resulting closed-loop systems asymptotically stable and satisfy a prescribed H∞ norm-bounded constraint.

利用增广Lyapunov泛函并结合自由权矩阵方法，得到使得闭环系统鲁棒渐近稳定且具有给定的H∞性能的时滞相关充分条件。

Initial random imperfections of composite panels are assumed to be Gaussian random fields and simulated numerically from their mean and autocovariance functions. Lindstedt-Poincare's perturbation technique is employed to solve the resulting nonlinear equation in the vibration analysis of imperfect composite panels. Monte Carlo analyses are performed for detailed numerical calculations.

层板之随机性几何缺陷以高斯随机场来描述，并利用其平均值函数及自方差函数来做数值的模拟；以Lindstedt-Poincare微扰方法来处理缺陷复合层板之非线性运动方程式，并使用蒙地卡罗法来做详细的数值分析。

But sometimes the immune system can't tell the difference between self and oneself, resulting in autoimmunity.

但是免疫系统有时不能说出自已和细菌之间的差别，造成自体免疫。

This was resulting from autolysis; i.e. active yeast cells consuming other yeast cells.

这是由于自解，就是活酵母吃其他酵母细胞(如果是由于葡萄上过量的硫导致，那么会有明显的臭鸡蛋味儿)。

If the integrated motion sensor can be adjusted such that shut-off will not occur within 15 minutes or automatic reset to sensing mode will not occur within 24 hours of a manual override or testing operation, special product packaging language is required that provides a range of settings that will resulting the fixture complying with the specification.

如果集成移动传感器能够调节，而使其在 15 分钟内不能自动熄灯，或者在 24 小时的手动控制或测试过程后不会自动重设感应模式，那么就要求有特定的产品包装文字，来说明达到某指定效果所对应的设定参数范围。

I hope that this success is just the first in a long series.

我希望这只是成功的开始。

Three dimensional stresses on the interface of tire and soil, tire deflection and soil sinkage are measured.

测试轮胎——沙土界面上的三向应力、轮胎变形和沙土沉陷；建立考虑剪切应力对沙土承载特性产生影响的车轮牵引性能预测模型；分析车轮作用下土壤的纵向稳定性。