查询词典 radius angle

There are two ways to accomplish transitions between flatbottom and included surfaces; either round, with a perfect radius, or banked, with a tighter transition curve; the walls height determines the transition, but the angle should never exceed 50 degrees.

有两种方法来完成flatbottom之间的过渡，包括曲面；要么轮，以完美的半径，或存留，以更严格的过渡曲线；的沃拉语的高度确定的过渡，但角度应不会超过50摄氏度。

Based on the simulated multispectral and multiangular satellite measurements, we analyzed the sensitivity of different wavelength and satellite view.angle to the retrieval of the aerosol optical thickness and effective radius.

2利用Mie散射和大气辐射传输模式模拟了一个给定条件下的卫星多视角、多波长的辐射观测，分析了各通道之间可用于气溶胶光学厚度和粒子有效半径反演的敏感性。

The results of research indicates: the shorter the radius is, the greater influence of the noncoincidence of the torsion center and gravity center for torsion angle will be.

研究结果表明，曲率半径越小，剪心和形心分离对扭转角的影响越大。

Then calculates clearances in radius direction for all kinds of nonparallel degree between input shaft and output shaft, and presents conditions of adjustability. Applies the experimental device, which is developed for this paper research, as example, introduce calculation formulation of overlapping coefficient and pressure angle while the distance between two centers is uncertain, in this way, we get the range of the center distance.

以本论文的实验研究装置为例，引入了中心距不确定状况下的重迭系数、压力角等计算公式，以两齿轮啮合时的分度圆不能相割为最小中心距，以两齿轮啮合的重迭系数不小于1为最大中心距，从而得到相应的中心距范围。

The effects of some parameters, such as mandrel ball numbers, mandrel extension length, bending angle, lubrication condition of pressure die, relative bending radius and material, on ovalization have been investigated by experimental method, and the effective methods to reduce the ovalization are proposed.

文章采用实验法，研究了芯头个数、芯棒伸出量、弯曲角度、压块润滑状态、相对弯曲半径、材料等因素对截面畸变的影响；并提出了减小截面畸变的有效措施。

The results show that increasing the ball numbers and mandrel extension length may reduce the ovalization, but leads to more remarkable wall thinning; the ovalization becomes more severe with the larger bending angle; the smaller the relative bending radius, the larger the ovalization is; the ovalization and wall thinning degrees are both smaller in the case of pressure die with dry lubricant; and under the same bending condition, the ovalization of LF2M tube is larger than the one of 1Cr18Ni9Ti tube.

结果表明，增加芯头个数与芯棒伸长量都能减小弯管的截面畸变，但两者都导致弯管壁厚减薄量增大；随着弯曲角度的增加，截面畸变越严重，相对弯曲半径越小，无芯棒与芯头支撑段弯管的截面畸变愈严重；在压块无润滑情况下，弯管的截面畸变和壁厚减薄量都小，并且在同等弯曲条件下，1Cr18Ni9Ti弯管的截面畸变小于LF2M弯管。

Objective To summarize our experience of treating unstable fractures of distal radius by fixed-angle volar plates combined with Kirschner-wires.

目的 探讨固定角度掌侧接骨板结合克氏针治疗不稳定挠骨远端骨折的临床效果。

Fixed-angle volar plating combined with Kirschner-wiring can achieve satisfactory effects in treatment of unstable fractures of distal radius.

固定角度掌侧接骨板结合克氏针固定治疗不稳定挠骨远端骨折，可以获得满意的临床效果。

Methods Nineteen patients with unstable fractures of distal radius were treated by fixed-angle volar plate fixation combined with Kirschner-wires.

2005年1月至2007年12月对19例不稳定挠骨远端骨折采用切开复位固定角度掌侧接骨板结合克氏针固定治疗，随访临床效果。

It is concluded that the above forces' values are mainly effected by finally bending angle of bead, fillet radius of bead and bead groove

其结果是：上述两种力的大小主要受板料对筋的最终包角、筋及槽的圆角半径3个因素影响。

There are different types of personal loans available.

有许多不同类型的个人贷款优惠。

The above mentioned teaching model of spiral rising can be used to avoid rigidness in teaching.

上述螺旋式上升的教学模式，可以避免教学形成模式後的僵化现象。