查询词典 queuing process

Through the analysis of the production process, four major operating conditions affecting the process most were selected for process optimization, which are stirring speed, feed fluid rate, heating profile and initial adding water volume.

通过实验对水解反应工艺的摸索，确定了四个影响较大的操作条件：搅拌速率，加料速率，加热速率及底水量。

In this paper, preliminary FDS fire chamber to simulate the flue gas generated through the corridor adjacent to the room near the migration laws, an analysis of indoor air flow field and the movement of smoke layer, and through the simulation of fire scenes, in a simple form of visual dynamic display of the entire process of fire, in the simulation process to obtain more accurate fire-related parameters such as temperature distribution, gas flow and heat radiation, and analysis of simulation results through the fire chamber of the flue gas migration characteristics, results showed that the chamber in the absence of fire smoke control measures, the process of the spread of smoke filled the first chamber is at the top, with the passage of time, the proliferation of slowly downward until the entire chamber is full, and then through the corridor smoke quickly spread to the nearby chamber.

本文运用FDS初步模拟了腔室火灾产生的烟气通过毗邻的走廊向附近房间迁移的规律，分析了室内空气流场和烟气层运动状况，并通过对火灾场景的模拟，以简单直观的形式动态显示出火灾发生的全过程，在模拟过程中获得较准确的火灾相关参数，如温度场分布，烟气流动及热辐射等，并通过模拟结果分析腔室火灾的烟气迁移特性，结果表明着火腔室在无防排烟措施的情况下，烟气扩散的过程是首先充满腔室顶部，随着时间的推移，慢慢向下扩散，直至将整个腔室充满，然后烟气通过走廊快速向附近腔室蔓延。

The process methods of tip-timing measured data are discussed in detail and a fire-new 5+2 fast algorithm is presented to analyze and process the asynchronous and synchronous vibration data, which improve the ability of real-time process signals.

详细分析了叶端定时测量数据处理的方法，提出了全新的5+2快速算法，解决了包括异步振动和同步振动测量数据的分析处理问题，提高了系统信号处理的实时性。

Synthesized all above, the heat and mass transfer of charge bed is discussed in detail. After choosing seriously the former study results in this field, a whole temperature range process model for firing iron ore pellets containing solid fuel is established as well as its software is edited. The main physical chemistry reaction process within pellets and the heat statement can be calculated exactly with the process as long as the physical and chemical parameters of raw material are obtained through basic experiments. After finding out the reason of"temperature hysteresis"and"heat inertia"of the experimental induration device, a new kind of experimental induration device is designed. The"temperature hysteresis"of hot gas flow in the new device is avoided.

综合以上对焙烧球团矿时球团矿内各种物理化学反应过程的分析与研究的结果，仔细地分析研究了球团矿料层中的传热质现象，认真筛选了前人对填充床的传热传质的研究结果，提出了全温度范围球团矿焙烧过程模型，并编制了相应的计算机软件，只要通过基础实验，获得原燃料的基本物性参数（如化学反应速度常数，矿粉、煤粉的粒度及此表面积以及球团矿的导热性等），利用这一软件就能准确地计算出焙烧球团矿时球团矿内各种物理化学反应过程和料层内的热工状态。

For these reasons, aiming at the low temperature separate method of light hydrocarbon recovery, the simple and accurate SRK state equation has been used to calculate the components thermodynamic characters of natural gas. This paper simulates the units process of the light hydrocarbon recovey process such as flow mixer/spilliter, flash, pump, valve, compressor, expander, distillation and heat exchange etc., and give examples to contrast calculation for each unit process.

为此，针对轻烃回收低温分离法工艺，以简单、准确的SRK状态方程为热力学计算基础模型，对轻烃回收工艺中的流股混合器、流股分割器、等温闪蒸器、绝热闪蒸器、泵、节流阀、压缩机、膨胀机、精馏过程及换热器等单元过程进行了模拟，并对各单元过程进行了实例对比计算。

In this paper, the relation between institution and urbanization is researched on the dimension of new institution economy: In the research of urbanization process, institution connotation, institution flux, institution function and classification are involved in, and then the mechanism how institution influences urbanization process and the flux and the institution system of urbanization process are put forward.

为此，本文从新制度经济学的维度，对制度和城市化的关系进行了研究，将制度的内涵、制度的变迁、制度的功能和制度的分类等制度理论引入城市化进程研究之中，提出了制度影响城市化进程的机制，城市化进程中制度的变迁、城市化进程中的制度体系等。

It was found that the thermal stress occurred in the cryopreservation process without CPA surrounded is much less than that of the other and the thermal stress during thawing process is larger than that in the freezing process.

其次，分别建立了两种不同保存方式过程中热应力的理论模型，并基于实际测量的各物性参量，获得了在降温和复温过程中温度和热应力的分布规律。

By analyzing the manufacturing process characteristics of boiler pressure vessels, this paper has proposed a part classification coding system , which can be used to design parts' group process and drive process.

通过分析锅炉压力容器的工艺制造特点，提出了一个应用于锅炉压力容器的零件分类编码系统，运用该编码系统可以进行零件的成组工艺设计和派生，提高了工艺设计的效率和实用性。

The upsetting process step was arranged: the current pre-forming process was modified to be half-closed extrusion process.

设置镦粗工序，将现有的开式预锻工艺改进为半封闭式的挤压工艺。

Hences, production process needs systems, which can detect, indicate and remove abnomal states of cutting tool and cutting process. In recent decades, much research work has been done in this area. Many monitoring and in-process detection methods and systems has been developed.

由于现代化的加工设备必须具备越来越大的柔性，并实现自动化运行，为了保证经济性，必须避免机床故障，因此，生产过程中需要能够检测、指示和排除切削刀具和切削过程异常状态的监控系统。

Don not attempt to do something which you can not to do.

不要企图做那些办不到的事情。

The expression of CTGF and TNF-αweredetected by immunochemistry and the number of Clara Cells was calculated.

光镜下观察肺组织的病理变化，采用免疫组化染色观察肺组织中结缔组织生长因子和肿瘤坏死因子-α的表达和Clara细胞的数量。