查询词典 process control

The result indicated that, gathers in advance the emulsion water resistance and mechanics performance which in the body preparation method the one-stage process obtains is good, but two steps obtain the emulsion stability is good; The neutralizaing agent triethylamine amount used should enable to achieve neutral between x-y, to gathers in advance the body disperser and the emulsion stability only then is advantageous; The water affinity chain extendor DMPA content to the emulsion viscosity, stable and the emulsion cellophane water resistance has the remarkable influence, its amount used general control between x-y; Hard section isocyanogen diethylene glycol dinitrate primary control paint film degree of hardness, module, anti-avulsion, wear-resisting and so on performance, the soft section low-molecular polymer polyols primary control paint film elasticity, hydrolisis performance and so on bears the low temperature and bears

结果表明，预聚体制备方法中一步法得到的乳液的耐水性和力学性能较好，而两步法得到的乳液的稳定性好；中和剂三乙胺的用量应使中和度达到x-y之间，对预聚体的分散和乳液的稳定性才有利；亲水扩链剂DMPA的含量对乳液的粘度、稳定性及乳液胶膜的耐水性有着显著的影响，其用量一般控制在x-y之间；硬段异氰酸酯主要控制涂膜的硬度、模量、抗撕裂、耐磨等性能，软段低聚物多元醇主要控制涂膜的弹性、耐低温和耐水解等性能

In the process of compliant force control, the chose of control strategy is affected by the knowability of environment parameters and influent the performance of control.

柔顺力控制过程中，环境参数的已知与否对系统控制策略的选取有很大影响，并直接影响到控制的效果。

The thesis analyzes the factors that bring the change of process quality, presents some basic criterion for determining the quality control line. On the base of which, analyze control line and two misdeem probability, presents the amending means of control line.

本文分析了引起工序质量变动的因素，并提出了在制定工程建设中工序质量控制界限时所应遵循的一些基本原则，在这个基础上分析了控制界限与两类错判概率，并提出了控制界限的修正方法。

Control factors of VRLAB in manfacturing process were discussed, and the reasons for control the factors were analyzed. The results show that iron in lead should be control in 0.000 7%, oxidizability of lead should be controlled in ±5% require...

通过查阅文献并结合生产实际，对VRLAB生产过程中需要控制的因素加以论述，并论述了控制这些因素的原因，指出铅粉中铁杂质含量宜控制在 0 。0 0 0 7%以内，铅粉的氧化度应控制在要求指标的± 5 %以内，灌酸密度应控制在技术要求的± 0 。0 0 5g/cm3 以内。

We claim all sidedness and entirety and procedure of cost control, and the text put forward that cost prediction and cost planning and cost control in the cost process control should take turns as well as a rolling closed loop movement.

要求成本控制的全面性、整体性和过程性，提出了成本预测、成本计划和成本实施控制在成本过程控制中既是依次进行时，又是周而复始的闭环运动。

Lastly, in accordance with the actual situations of the prototype structure of mosque pagoda, based on the similar relation of model experiments, a model structure of mosque pagoda with a similar coefficient of 1/10 is designed and fabricated. Earthquake simulating shaking table tests are performed on the model structure of pagoda in the cases the AB type passive control system with SMA dampers is erected or unerected. The leading earthquake responses like the relative drift at the top of the main tower and the small tower, interstory drift ratio, acceleration, and cracking process of the pagodas body etc. are studied. The operational behaviors involving the deformation capacity and energy dissipation capacity is tested for passive control system with SMA dampers under the earthquake excitation, and the corresponding control mechanism and regularity is also analyzed. Furthermore, the performance changes and protection effectiveness is comprehensively evaluated while the model structure of pagoda is seismically protected or not.

最后，根据光塔原型结构的实际情况，以模型试验的相似关系为基础，设计并制作了一个相似系数S，为1/10的光塔模型结构，并先后进行了未安装和安装A、B型SMA阻尼器被动控制系统光塔模型结构的地震模拟振动台试验，研究了模型结构在3种不同工况下，主塔顶部和小塔顶部的相对位移、层间位移角和加速度以及塔体开裂等光塔结构的主要地震反应，测试了SMA阻尼器被动控制系统在地震激励下的变形能力和消能能力等工作性能，分析了相应的控制机理和控制规律，并从总体上评价了光塔模型结构抗震保护前后的性能变化和保护效果。

In the process of adaptive control, to compensate the bad effects of actuator unmodeled dynamic and improve the system tracking performance, a pseudo-control hedging based control structure is introduced, at the same time the convergence of all the signals in the close system is guaranteed.

考虑作动器未建模动态对自适应控制的不利影响，采用基于伪控制减缓的思想改善了存在输入动态时系统的跟随性能，并证明了整个闭环系统的稳定性。

Company's production process control mainly uses IS09001: 2000 standards, product quality control standards mainly bulletin 2001 Uster 5% level of control.

公司对生产过程的控制主要采用IS09001：2000标准，产品质量控制标准主要采用2001乌斯特公报5%水平控制。

Embaying the subject matter on attacking the key part of the target,The main results and contributions of this paper are as follows:First, it studies the structure of the air-to-air missile's guidance control system,introduce the process of guidance control system and analys the characteristics and mechanism of the guidance control system;The second, the proportional navigation have been analytical studied, the modified proportional navigation is given,that based on apprimimate conditions have been predigested.

围绕导弹末端修正控制达到杀伤目标要害部位这一主题，本论文的主要工作及贡献有以下几方面的内容： 1。给出了空空导弹制导控制结构、基本框架，介绍了空空导弹的制导过程，制导系统的典型结构图，讨论了制导系统的结构方框图及其特点。

The text is about working process and control demand for a control system of removing dust electrically. The control system of removing dust made those company who need to obviating dust take the reins of mature technology, and the efficiency, automatic level have a great elevated.

本文介绍电除尘除灰控制系统的工作流程和控制要求，电除尘除灰系统的应用使得国内电厂等需除灰尘的企业掌握了成熟的除尘技术，除尘的效率、工艺水平及自动化水平有了很大提高。

When this condition occurs, inbound replication with the source partner is stopped on the destination domain controller and event ID 2042 is logged in the Directory Services event log.

计算机密码学是研究计算机信息加密、解密及其变换的科学，是数学和计算机的交义学科，也是一门新兴的学科。

Instructions: click on the thumbnails to see a larger image, then use the left-right arrow keys to scroll through the slideshow.

使用说明：滑鼠点在小图上即可放大观赏。开启后键盘左右键可用来换照片。