查询词典 procedures

Any detectable levels of penicillin residue are considered violative because 21 CFR 211.176 indicates that a non-penicillin drug product must not be marketed if detectable levels of penicillin are found when tested according to procedures specified in The Procedures for Detecting and Measuring Penicillin Contamination in Drugs.

任何可检查水平都是不可接受的，因为21 CFR 211.176指明：依据特定的检测被污染产品中的程序检测，如果在非青霉素产品中发现任何水平的青霉素污染，则此产品不能销售。

Atan is codic algorithm of C procedures, including fixed-point and floating-point procedures, has been validated.

详细说明：是codic算法实现atan的C程序，包括定点和浮点程序，已经通过验证。

Sin is codic floating-point algorithm C procedures, including fixed-point and floating-point procedures, has been validated.

详细说明：是codic算法实现Sin的浮点C程序，包括定点和浮点程序，已经通过验证。

Good a binding genetic algorithm optimization procedures, a description of the procedures in detail to facilitate the development and use of seco...

很好的一个约束遗传算法优化程序，程序的说明很详细，方便二次开发和使用。

First of all, this paper concludes the general research routine and procedures in wireless mesh networks and introduces related research methods and results of different procedures: firstly, it makes classification and comparison of the classic routing protocols in mobile ad hoc networks; secondly, it introduces several ways in which the classic ad hoc routing protocols can be modified to be used in the wireless mesh networks; thirdly, it makes detailed explanations of some typical routing protocols in each way above.

首先本文总结了无线Mesh网络路由协议的一般性研究路线，并按该研究路线的各阶段分析和总结了相关的研究方法与研究成果：先对移动Ad hoc网络的经典路由协议进行分类和比较；在此基础上总结了将Ad hoc路由协议应用于无线Mesh网络的几种主流的改进思路；最后对各种改进思路的代表性路由协议进行了分析和讨论。

As showed in Fig.1, the diagrammed stress of short time endurance test forAs showed in Fig.1, the diagrammed stress of short time endurance test for500 hours at 565℃on welded-joint of T91-F12 is 240MPa. Considering the℃on welded-joint of T91-F12 is 240MPa. Considering thedispersity of±20％, stress of check test for 500 hours is 192MPa. The result±20％, stress of check test for 500 hours is 192MPa. The resultof short time endurance test for 500 hours at 565of short time endurance test for 500 hours at 565℃on T91-X20CrMoV121℃on T91-X20CrMoV121welded-joints is showed in Tab.5. The result shows that the short timewelded-joints is showed in Tab.5. The result shows that the short timeendurance stress of weldedendurance stress of welded-joints with two procedures at 565℃for 500 hours-joints with two procedures at 565℃for 500 hoursboth above 192MPa, and meet the requirement.both above 192MPa, and meet the requirement.

依据图1，对T91－F12 焊接接头 565℃温度下的短时持久性能 500 小时考核试验依据图1，对T91－F12 焊接接头 565℃温度下的短时持久性能 500 小时考核试验的图示应力值应为 240MPa，按照持久强度试验数据的±20％的分散度，取 500的图示应力值应为 240MPa，按照持久强度试验数据的±20％的分散度，取 500小时考核试验应力值为 192MPa.T91－X20CrMoV121 焊接接头 565℃、500 小时小时考核试验应力值为 192MPa.T91－X20CrMoV121 焊接接头 565℃、500 小时短时持久考核试验试验结果见表5 ，试验结果表明，两种工艺条件下的焊接接头短时持久考核试验试验结果见表5 ，试验结果表明，两种工艺条件下的焊接接头565℃温度下的短时持久性能，500 小时的持久断裂应力均高于 192MPa，结果符565℃温度下的短时持久性能，500 小时的持久断裂应力均高于 192MPa，结果符合要求。

The paper illustrates the problem from the angle of the expropriating procedures in the land-expropriating system, expounding the concerning procedures in the process of land expropriation from four parts. And based on the existing laws and regulations, the hypotheses have been put forward on the process of land expropriation and the improvement on the systems concerned.

本文从土地征收制度中的征收程序部分这一角度作为切入点，通过四个部分阐述了土地征收的过程中所涉及的程序的相关问题，并在现有法律法规的基础之上对土地征收程序及相关制度的完善予以设想。

If the experienced operators can finish the procedures from insetting the sheath into the artery to the end of CAG within 10 minutes, the procedures of CAG without heparinization are safe.

结论对技术熟练的术者，在10min内，非全身肝素化状态下完成从鞘管进入股动脉到CAG操作是安全的，可减少穿刺和非穿刺部位出血并发症的发生。

Land user who wants to continue shall put in application within 60 days before expiration, after approval, re-sign state owned land usage right remising contract, conduct state owned 1and usage right remising procedures, pay land usage remising fees and transact registration procedures.

需要续期的土地使用者应在期满前60天内提出申请，经批准后，重新签订国有土地使用权出让合同，办理国有土地使用权出让手续，支付土地使用出让金，并办理登记手续。

By analyzing the flow-style working pattern,the technical mechanism integrated with production step balance, manufacturing resource group construction, dynamic production priority was presented. Manufacturing resource group allocating algorithm was put forward, which can smooth the requirement differences among the procedures. Computational method of the number of work-in-progress between the procedures with different processing time was constructed. The dynamic algorithm of selecting priority of part and machine was built. And a scheduling system was built which was authenticated with realistic case.

通过对流水式连续生产模式的分析，提出了基于节拍协调、成组制造资源以及动态优先级调整等策略的技术思路；提出了面向连续生产节拍均衡的资源组分配算法、适应前后序加工时间差异的压件生产额度计算方法，以及工件和设备选择优先级的动态调整算法；开发了调度软件系统，并通过实例进行了技术验证，形成了一种新型的离散制造环境下的流水式连续生产模式。

If you were not , and OS X just booted normally, have no fear.

如果你没有，和OS X刚刚启动通常，没有恐惧。

I only want to preserve our all .

我只想保存好我们的一切