查询词典 printer error

In the same way,the error of understanding results in the error of the way of study.

因此，可以总结发现，学习的认知对于有效的学习是非常重要的。

This error is referred to as an indicator error, and it is indeterminate.

这个误差被称为指示剂误差，而这个误差是不确定的。

Error index—Associates an error with a particular object instance.

错误索引——使一个错误与一个特殊的对象实例相联系。

The error of SIF is discussed too. Then an index to estimate error of SIF is advised. The analysis shows it is a feasible and correct parameter.Size effect, Numerical analysis, Statistical theory, Energy theory, Fractal theory

8在对应力强度因子的计算方法进行评述的基础上，对应力强度因子的计算误差进行了分析，提出了一个使用有限元方法求解应力强度因子的误差指标参数。

The error estimation inequation of Wachspress interpolation indicates that the error of Wachspress interpolation decreases with the reduction of polygonal element size.

利用wachspress插值形函数的性质和二元函数的Taylor展开式的向量形式，给出了wachspress插值的误差估计不等式。

Based on error analysis, the influence of error sources on strapdown inertial navigation system s is discussed.

通过误差分析，讨论了各种误差源对捷联惯导系统的影响。

When the size of initial error is close to that of model parameter error, they both contribute to the predictability limit of Lorenz system.

在后两种情况下，在考虑初始误差对可预报性影响的同时还必须考虑参数误差的作用。

At last, we used the initial error decay theory to conclude that the initial mean ensemble is capable of reducing the error in climate simulation studies.

文中还利用初始场作用衰减的理论探讨了如何解释初始场集合预报能够减少模拟结果误差的现象。

Test and simulation shows that the method can eliminate the unsmooth shortcoming caused by subsection low order interpolation with its inherent feature, and can meet the vision effect in inner capacity reconstruction. Further more the volume measurement error are reduced after interpolated by cubic spline without increasing any calculation, and the measurement relative error could reach 2‰ required by the system.

实验和仿真结果证明：该方法能够克服直接累加和传统的分段低次线性插值方法由于函数本身的特性，在各次间歇测量点处产生的衔接不光滑性，满足了变径内腔内表面容积重建中的视觉需求；同时在不增加计算量的前提下使得插值后容积的测量精度得到了提高，且满足2‰测量误差的要求。

The measurement error of phase shifting method is calculated.It is concluded that if 5 frames are used per time, in order to achieve 0.3° precision inphase measurement, phase shifting error must be limited in± 0.1° plus at least 60dBsignal to noise ratio.

同时，还进行了相移检测法的初步误差分析和模拟研究，结果表明：采用5幅图像的方法，要实现0.3°的检相精度，就要求相移误差在±0.1°以内，信噪比为60dB以上。

Chimborazo and Cotopaxi, took me by the hand.

越过琴博腊索山和科托帕克西山。

This car is in a good condition.

这辆车的状况很好。