查询词典 primary axis

The traction arm includes: a first supporting plate slidably connected to a beam of the bench; a second supporting plate pivotally connected to the first plate for the rotation of the base about a first axis that is substantially horizontal and substantiallty at right angles to the front plane of the first plate for appllying the base to the repair bench; a third supporting plate pivotally connected to the second plate for the rotation of the base about a second axis that is substantially at right angles to the first axis; and pivoting elements for the rotation of the base about a third axis that is substantially at right angles to the second axis.

牵引杆包括：一可滑动地连接于修理台梁的第一支承板；一枢接于第一板、用于使底座绕一大体上水平且大体上垂直于将底座装在修理台的第一板的前平面的第一轴线而转动的第二支承板；一枢接于第二板、用于使底座能绕一大体上垂直于第一轴线的第二轴线转动的第三支承板；以及用于使底座能绕一大体上垂直于第二轴线的第三轴线转动的枢接件。

The result of optimization and analysis show: 1 across-axis sensitivity is smaller, less than 2% of the primary axis sensitivity; 2 the first mode is dominant at primary axis, which reduce intersectional coupling; 3 when damp ratio is between 0.3 and 0.7, accelerometer has better dynamic characteristic.

分析结果表明此种结构的具有：1横向灵敏度小，X、Z方向的横向灵敏度均不到敏感方向的2％；2在敏感方向上，一阶模态起主导作用，其它模态的影响较小，有利于减小交叉耦合的影响；3当阻尼比毛为0.3—0.7时，传感器具有较好的动态特性。

At the same time, some properties of rough Set in quotient ring are given and proved. The fifth chapter is Rough Primary Ideals and Rough Fuzzy Primary Ideals in Semigroups, the concept of rough primary ideals and fuzzy rough primary ideals in semigroups are introduced. Under the condition of the complete congruence relation, a rough set of a primary ideal in semigroups is proved to be its primary ideal.

同时，在商环中讨论了粗糙集的一些性质，并给出这些结论的严格证明；第五章是半群中的粗准素理想和粗模糊准素理想，首次提出了半群中的粗准素理想与粗模糊准素理想的概念，证明了在完备同余关系下，半群中准素理想的粗糙集是准素理想。

Others desynchronized with 5－90 Hz primary depth electrographic after-discharges;(2) primary electrographic after-discharges were driven by primary unit after-discharges in the anterior dorsal HPC;(3) primary unit after-discharges were induced by brief primary electrographic after-discharges; and (4) plasticity of primary electrographic after-discharges and inhibition of single neuron firing were induced by repetitive ATPDH.

非同步性后放电的深部电图癫痫样电活动具有宽频带特征(5－90 Hz)；(2)原发性单位后放-后抑制效应可以引发低频原发性电图后放电，长时程爆发式单位放电可以诱发高频原发性电图后放电；(3)短束原发性电图后放电也可以诱发原发性单位后放电；(4)原发性电图后放电和神经元单位放电的抑制效应具有明显可塑性特征。

Combining with the practice of curriculum setting in our primary command vocational education academy at moment, according to the guidance, course and policy of vocational education from headquarters at high level, theory of education target assorting, principle of Thaler, degree theory, category and sequence, means of differentiation and plan are applied comprehensively, and the principle of curriculum setting and curriculum system structure in primary command vocational education academy are pointed out, and the target of vocational education in primary command academy, the principle , contents and methods of curriculum target setting are circumstantiated through investigation and consultation, theoretic analysis and general comparison; the process of curriculum setting in primary command vocational education academy is defined; the curriculum system of vocational education in primary command academy is devised innovatively; with regard to the implementation and optimization of curriculum in military primary command academy, general requirements and basic principles and standards are proposed after pointing out the influencing factors and implementation process.

通过调查咨询、理论分析研究、综合对照比较，结合当前我军初级指挥院校任职教育课程设置的实际，以军委总部关于任职教育的指导思想、方针和政策为政策依据，综合运用了教育目标分类理论、泰勒原理、学历论、范畴与序列、分化与统整等原理和方法，确立了军队初级指挥院校任职教育课程设置的原则；具体设想了适应军队初级指挥院校任职教育的课程体系架构，说明了初级指挥院校任职教育目标与课程目标确立的原则、内容和方法；阐述了初级指挥院校任职教育课程设置的程序；创新提出了初级指挥院校任职教育模块式的课程体系方案，并具体研究提出了合训分流学员的教育内容设置；就军队初级指挥院校任职教育课程实施，分析了影响因素，提出了总体要求，探讨了课程实施过程中主要环节的质量控制。

To dec.2002 were analysed by means of wounding tract and fracture.results during 24 cases of gunshot wound, wounds of 20 cases healed without event after primary debridment and sewing wounds,3 cases healed and l case infected in 4 cases of primary debridment without suture,and 4 cases of primary internal fixed fracture had no osteomyelitis.the injury of soft tissue and contamination of wound track were serious in explosion wound than in gunshot wound,10 cases healed without event and 4 cased infected in l4 cases of primary closed explosion wounds,and 2 cases of primary inernal fixed fracture had no osteomyelitis.conclusion it is suggested that the management of firearm wound in cold and dry region may be delayed moderately in time of debridement.the firearm wound may be treated by internal fixation of fracture and primary closing of tract after early debridment when the soft tissue injury was light in peacetime, which decreased the infection,disability and promoted rehabilitation of patients.

结果 24例枪伤中，20例一期缝合伤口，均一期愈合，另外4例只清创未一期缝合的伤口，3例愈合，1例感染；4例骨折内固定均愈合良好，无骨髓炎发生。16例炸伤病人局部软组织损伤及污染比枪弹伤重，14例一期缝合伤口中，10例一期愈合，4例感染，骨折内固定2例，均愈合良好，无骨髓炎发生。结论寒冷干燥地区火器伤早期伤道清创时限可适当延长，在平时火器伤的救治中，对软组织条件较好的创面，早期清创后可一期闭合伤口和骨折内固定，这样可减少感染和伤残，促进康复。寒冷干燥地区；火器伤；早期救治

It comprises an in-put shaft hinged to its yoke through one axis, and an out-put shaft also hinged to its yoke through another axis, and these two yokes (13) were combined together by only one axis position, perpendicular to that two yoke axes like a cross, so that this combined axis will bend just like the angle bisector of that two shafts to maintain its constant velocity by a few methods, firstly, by using a section of gear teeth mesh at both ends of the shafts' teeth were so polished so that it can turn longitudinally as usual gear, and also sideways, to provide a larger solid angle of turning from ordinary 45 degrees into 60 or even more.

它包括输入轴，其通过一根轴铰链连接于叉形支架，和输出轴，其通过另一根轴也铰链连接于其叉形支架。并且这两个叉形支架(13)只需用一根相对垂直铰链轴相连而组合在一起，使得这种组合的轴总能形成这两个轴的角平分线，以通过少数几种方法保持其恒速，首先，通过用啮合在轴的两端的一段齿轮齿抛光为以能够像普通齿轮一样纵向转动，并且还能够侧向转动，以提供较大的转向立体角，从通常的45度变成60度或更大。

It points out that it is no more application of the basic solution of elastic problems in the misalignment of material main axis and coordinate axis to orthogonal anisotropic body and puts forward the coordinate translation methods to solve the problems of the misalignment of material main axis and coordinate axis by using Boundary Element Method to solve the problem.

指出了对于正交各向异性体，当材料主轴与坐标轴不重合时，关于弹性问题的基本解不再适用，为了解决这一问题，特提出坐标转换的方法，以求应用边界元法解决材料主轴与坐标轴不一致的问题。

Based on the prior art, the optical engine according to the invention has the improvements that, three optical axis steering components are respectively introduced into red, green and blue light illumination systems, and an optical axis lengthening structure is introduced into the green light illumination system, so that optical axes of the red, green and blue light illumination systems, each of which is from an LED resource to the optical axis steering component, are counterclockwise rotated for 90 degrees, parallel with each other, parallel with an optical axis of a projection lens, arranged in a same plane and positioned under the projection lens, luminous faces of three LED luminous chips of the red, green and blue light illumination systems are in a same plane, and the three LED luminous chips can be mounted on a same heat-radiating plate, therefore, the heat-radiating system has a simplified structure, and the optical engine has reduced size.

在背景技术所述的光学引擎的基础上作以下改进，在红、绿、蓝光照明系统中引入三个光轴转向器件和在绿光照明系统中引入光路加长结构，旨使：红、绿、蓝光照明系统各自的从LED光源至光轴转向器件部分的光轴朝逆时针方向转动90°、互相平行、与投影镜头的光轴平行、居同一平面和位于投影镜头的下方，红、绿、蓝光照明系统的三个LED发光芯片的发光面居同一平面，三个LED发光芯片可安装在同一块散热平板上，散热系统的结构简化，所述的光学引擎的尺寸减小。

The bar axis is at an anThe bar axis is at an angle to the central axis and spins around it.gle to the central axis and spins around it.

磁磁棒棒条的轴与中心轴成一角度，并围绕它旋转的轴与中心轴成一角度，并围绕它旋转。。

If you were not , and OS X just booted normally, have no fear.

如果你没有，和OS X刚刚启动通常，没有恐惧。

I only want to preserve our all .

我只想保存好我们的一切