查询词典 pre reduction

In the one half part, according to the strontium nature, thermodynamic calculation of correlative reaction and the principle of the vacuum aluminothermy reduction process, with the laboratory findings of preparation strontium by vacuum aluminothermy reduction compared and analyzed in different parameter conditions, a variety of factors which effect the decomposition rate of SrCO_3 and the percent reduction of strontia are gotten out. The factors include that the decomposition rate of SrCO_3 is influenced by different addition and pressure. They also include that the percent reduction of strontia is influenced by excess coefficient of reducing agent aluminium powder, the particle size of raw material or reducing agent, the pressure of barbecuing, temperature and reduction time. According to those, we can draw the conclusion as follows:(1) Decomposition temperature of SrCO_3 is decreased by adding carbon and alumina in different degree.(2) With quantitative carbon added under the vacuum condition, the decomposition temperature of SrCO_3 is decreased obviously, which can fall 150℃ compared with atmospheric pressure.(3) In keeping 1150℃ of 2.5h, under the 5Pa vacuum condition, the decomposition rate of SrCO_3 nearly keeps in 99% steadily.

在前半部分的真空铝热还原法中，根据锶的性质、相关反应的热力学计算及真空铝热还原法原理，通过对不同参数条件下的真空铝热还原法生产金属锶的实验结果的分析比较，得出了影响SrCO_3的分解率和氧化锶的还原率的种种因素，具体因素包括不同添加剂、不同气压对SrCO_3分解率的影响，还原剂铝粉的过量系数、原料与还原剂的粒度、制团压力、温度和还原时间等对氧化锶还原率的影响，得出具体结论如下：(1)添加碳和Al_2O_3能不同程度的降低SrCO_3的分解温度；(2)真空条件下加入一定量的碳可显著降低SrCO_3的分解温度，比之常压下可降低150℃之多；(3)在1150℃恒温2.5h、真空度达到5Pa的条件下，SrCO_3的分解率几乎保持稳定在99％；(4)氧化锶的还原率随还原剂过量系数的增大而增大，但是趋势越来越小，当过量系数超过25％后，氧化锶的还原率几乎不再增加；(5)氧化锶的还原率随原料与还原剂的粒度的变细而增加；(6)氧化锶的还原率随制团压力的增加而增加，但超过一定值后，氧化锶的还原率反而会下降；(7)氧化锶的还原率随还原温度的升高而增加；(8)氧化锶的还原率随还原时间延长而增加，在本实验条件下，超过2.5h趋于稳定。

A new concept of turning line of reduction parameters and its determination method is put forward in this paper for analyzing the isopleth diagram showing the relationship between reduction degree and reduction parameters in reduction of compressed scale lump containing carbon, and the method of optimal selection for reduction parameters is obtaine

应用文章提出的还原参数界线概念及其确定方法对铁鳞配焦压块还原过程中反映还原参数与还原指标关系的等高线图进行分析，得出还原参数优化选择的具体方法。

The results show that Fe0.13[Co20Ni80]0.87 alloy fibers are characterized with thin diameters between 0.3 and 2.0 μm, with high aspect ratio, dense and smooth surfaces. The crystalline size of the alloy fibers are mainly influenced by the thermal reduction temperature and are in the range of 20 to 50 nm with a corresponding reduction temperature range of 300 to 700 ℃. The magnetic properties of the alloy fibers are largely affected by the carbon content and crystalline sizes of the alloy fibers. With increasing thermal reduction temperature, the coercivity decreases while the saturation magnetisation value of the alloy fibers dramatically increases at lower reduction temperatures. The alloy fibers prepared at reduction temperature of 700 ℃ have a saturation magnetisation value of 120 Am2/kg and a coercivity value of 10.4 kA/m, respectively.

结果表明：Fe0.13[Co20Ni80]0.87合金纤维的直径为0.3~2.0 μm，表面光滑、长径比大；组成合金纤维的晶粒大小与还原温度密切相关，当温度为300~700 ℃时，晶粒尺寸由约20 nm增加到约50 nm；该合金纤维显铁磁性，其矫顽力主要受合金中C含量及晶粒大小的影响，随制备温度的升高而降低；饱和磁化强度则主要与合金的组分相关，随还原温度的升高和合金纯度的提高而增大；经700 ℃热还原后，合金纤维的饱和磁化强度 m s为120 Am2/kg，矫顽力 H c为10.4 kA/m。

Compared to open surgery, patients in the study who underwent laparoscopic surgery experienced 80 percent reduction in the odds of respiratory tract infection, 69 percent reduction in bloodstream infection, 59 percent reduction in wound infection, 39 percent reduction in urinary tract infection and a 48 percent reduction in other types of nosocomial infections across hysterectomies, cholecystectomies and appendectomies.

同开放性手术相比，研究中行腹腔镜外科手术子宫切除术、胆囊切除术及阑尾切除术的病人呼吸道感染可能性降低80%，血流感染降低69%，伤口感染降低59%，泌尿道感染降低39%，其他院内感染降低48

Some reduction methods in titanium metallurgy ,such as the manganese reduction process,the calcium reduction process,the natrium reduction progress,reduction of titanium by electrolyzing of molten salt,etc were introduced.

未来钛冶金的发展方向是用还原二氧化钛为基础的连续式生产技术代替间歇式的Kroll法生产技术，并大力降低原材料和生产的成本。

For supracondylar fracture of humerus with obvious displacement,it is easy to make reduction,but the fixation and the maintenance of reduction is not easy; manual reduction with plaster or splint immobilization,though as the first-chosen method,has such shortcomings as infirm or loosening fixation of plaster or splint which may cause injury to blood vessels or nerves; open reduction may lead to further trauma to soft tissues and tissue adhesion,and to joint stiffness; the closed reduction with cross Kirschners wires under C-arm X-ray can avoid the above mentioned shortcomings and it is easy in operation.

移位明显的肱骨髁上骨折，复位容易，但固定及维持复位困难，手法复位石膏或夹板外固定虽是首选治疗方法，但石膏或夹板固定不牢固，易出现松动甚至可造成血管及神经损伤，而切开复位更易进一步造成软组织创伤，组织粘连，最终导致关节僵直功能障碍。本组C臂下闭合复位交叉克氏针治疗移位明显的肱骨髁上骨折避免了上述缺点，而且方法简单。肱骨髁上骨折；经皮克氏针固定；儿童；闭合复位

At the same time, the cooperation of the multi-layer frame structure is researched with FEA when the pre-stressed threads are stretching, and the relationship between the beam of stretching layer and the beams of nearly layers is discussed. The layout effect of regular reinforcement in the beam on the pre-stressed effective quantities is also analyzed, and the elementary estimation formula of pre-stressing loss on the multi-layer frame is also deduced according to the pre-stressing loss of one-layer pre-stressed frame structure.

同时文中还运用有限元对多层框架结构在预应力张拉过程中，某层梁预应力的张拉与相邻层梁的影响关系和结构各构件的整体协同工作做了研究，分析了非预应力筋在梁中的配置对框架梁预应力有效量的影响；并且在一层框架梁侧限预应力损失的基础上，扩展了多层框架结构中侧向约束引起梁的预应力损失值的初步设计估算公式。

In the method of the invention, a baseband signal is pre-processed to realize nonlinearity compensation. The pre-processing method comprises the following steps: the filter coefficient and the multinomial coefficient of the high power amplifier are extracted; corresponding gain is calculated for the amplitude value of each point input into the sequence of the baseband signal, and the phase compensation value is calculated according to the amplitude gain; the phase compensation value and the gain which are corresponding to each point are synthesized into re-gain, a pre-processing value pi is obtained, and pre-processing output sequence is formed; the pre-processing output sequence is output into the high power amplifier directly or through a inverse filter.

本发明方法是将基带信号进行预处理来实现抵偿非线性，预处理方法是：提取出高功率放大器的滤波器系数和多项式系数；对输入基带信号序列中的每一点的幅值计算对应的增益，根据幅度增益计算出相位补偿值；每一个点对应的相位补偿值与增益合成复增益，得到预处理值p i ，构成了预处理输出序列；将预处理输出序列直接或经过反向滤波器后输出到高功率放大器中。

In this paper,the effect of pre-stress on peen-forming is studied by experiments,the results show that pre-stress can change the relationship between pre-deformation and pre-stress shot peen deformation,and that 0.05%～0.1%pre-strain is comparetively suitable to improve the spanwise rectilinearity of shot peen-forming configuration surface.

文摘：对预应力喷丸成形进行了试验研究，指出预应力可以改变其对应的预变形与预应力喷丸变形之间的大小关系，在以改善喷丸型面纵向直线度为主要目的的预应力喷丸成形中，预应变取值0.5/1000～1/1000较为适宜。

We also use rank sum test to analyse the differe- nce between the light pre-eclampsia group and the severe pre-eclampsia group (P=0.000),the early onset pre-eclampsia group and the late onset pre-eclampsia group (P=0.003). All of the results give the same conclude that the differences within the three groups are significant (P.05). Conclusion: We conclude that HLA-G proteins are normally expressed in invasive trophoblasts and HLA-G proteins expression is defective in most pre-eclamptic placenta.We propose that trophoblasts lacking HLA-G proteins are vulnerable to attack by the maternal immune system.

结论HLA-G分子特异性分布于胎盘EVCT的胞膜及胞浆中，生理妊娠组、子痫前期组间差异性存在表明其表达量的下降与子痫前期的发病相关；轻、重度子痫前期组间显著差异表明HLA-G分子表达量的下降与子痫前期病情严重程度相关，早发型重度子痫前期患者胎盘组织中HLA-G分子的表达明显低于迟发型组，提示我们HLA-G分子表达的降低程度还与发病早晚有关。

I'm not an actor. I'm a professor of paleontology.

我不是演员，我是古生物学教授

Spider Network Web site that is a very image of the name.

网络蜘蛛即Web Spider，是一个非常形象的名字。