查询词典 polymerized

Butadiene was polymerized to some extent in the presence of binary catalyst system NdCl33iPrOHAlEt3 in toluene and the allylchloride was then added to the solution in order to cyclize the formed polybutadiene and cyclopolymerize the unreacted butadiene monomers.

采用NdCl3·3i－PrOH－AlEt3稀土催化剂进行丁二烯的顺式聚合，在聚合过程中引入烯丙基氯，进行分子内环化反应以及单体的环聚反应。考察了稀土催化剂用量、n／n（AlEt3）、环化时间、反应温度、单体浓度等对环化反应的影响，并对产物进行了红外光谱、核磁共振光谱的表

Under UV irradiation, ordered diacetylene molecules can be polymerized and form polydiacetylene vesicle.

有序排列的联乙炔分子，在紫外光照射下发生聚合。

After the oxidative polymerization of DMP,styrene was in-situ polymerized under the initiation of dibenzoyl peroxide and dicumyl peroxide,finally thermodynamically compatible PPO/PS alloy was prepared.When styrene content was 50 wt%,for the synthesized PPO/PS alloy the yield and the weight-average molecular weight were determined to be 95%and 1.7×10~5 for PPO,93%and 2.0×10~5 for PS,respectively.The influence of the concentration of DMP and catalyst,molar ratio of N/Cu, oxygen partial pressure,NaOH concentration and temperature on the initial polymerization rate(R_0) of DMP was studied.It was found that the initial polymerization rate of DMP increased with the concentration of DMP and catalyst. The initial polymerization rate increased with the molar ratio of N/Cu at first and then decreased.

通过测定DMP氧化聚合过程中氧气吸收量随时间的变化，研究了DMP和催化剂浓度、N/Cu摩尔比、氧气分压、氢氧化钠浓度及温度对水介质中DMP氧化聚合初始速率的影响，发现DMP氧化聚合初始速率与氧气分压的0.1次方成正比；DMP氧化聚合初始速率随DMP和催化剂浓度及温度的增加而增加；随氢氧化钠浓度和N/Cu摩尔比的增加DMP氧化聚合初始速率先增加后降低。

The UV and IR spectroscopic studies of the monomer films showed that the photoreaction ratio of monomer (about 50%) was higher than the corresponding photosensitive polymer (about 10%, PVCi). The polarized IR spectra proved that obvious anisotropic absorption was displayed in the irradiated photosensitive film. With polarizing microscopy method, we found that these kinds of photoalignment films exhibited good alignment ability, and the stability of the photoalignment film could reach about 100℃. 2 A photosensitive self-assembled monolayer was fabricated that contained photo-cycloadditable groups, such as, coumarin and cinnamate. The reaction process were detected by contact angle method because the IR absorption of monolayer was very weak. The photosensitive self-assembled monolayer promote uniform alignment of nematic liquid crystals by LPUV, and it thermal stability could reach about 130℃. 3 A cationic bolaform amphiphiles was synthesized that had two photosensitive double bonds, and can be polymerized by ultraviolet. A layer-by-layer self-assembled deposition film was prepared in aqueous solution by using this material and poly (sodium 4-styrenesulfonate). The UV-Vis. spectra proved that the multilayers film was uniform and layer-by-layer. When LPUV irradiated the film, the photopolymerizable double bond underwent [2+2] cycloaddition, and the production of the reaction distributed along the polarized direction of incident LPUV. Polarized UV-Vis. spectra indicated that the irradiated self-assembled multiplayer film was anisotropic, and the dichromic ration is about 0.09, it is higher than the spin-coating method of photosensitive polymer or monomer. We used this anisotropic film as alignment layer of nematic liquid crystals, and obtained a uniform and stability alignment result, the static contrast ratio is about 100, which is very close to application of liquid crystal device. This thesis is an instance that the photochemical material was used in the physics region of liquid crystals, the route that was from photosensitive monomer, self-assembled monolayer film to self-assembled multiplayer film was undergone, by this logical research method photoailgnment of liquid crystal was extended and consummated.

围绕上述思路开展了如下工作：1合成了三种可进行光二聚反应的光敏小分子单体，LPUV 辐照制作了光控取向膜；用紫外-可见光谱法和红外光谱法分析了薄膜中的光化学反应，发现小分子的光反应程度可达到50%以上，至少比光敏高分子高出5倍；薄膜的偏振红外光谱证实，经过LPUV 辐照后薄膜出现了明显的各向异性；将小分子光控取向膜制成液晶器件，在偏光显微镜下观察看到均匀一致的液晶取向；并且热稳定性达到100℃左右，接近实用化要求。2制备了含肉桂酸、香豆素基团的自组装单层膜；采用接触角的方法监测自组装反应的动力学过程；紫外-可见光谱证实了自组装单层膜在石英基板表面形成；自组装单层膜经LPUV 辐照后能诱导液晶均匀取向，而且热稳定性可达130℃，热稳定性进一步提高。3合成了含有光敏双键的双季铵盐，在水溶液状态下将它和聚乙烯基苯磺酸钠沉积生成layer-by-layer 自组装多层膜，紫外-可见光谱证实这是一个逐层均匀的沉积；在LPUV 照射下，自组装膜中的光敏双键按照偏振方向发生[2+2]环加成反应，形成取向膜，用二向色性值评价的分子取向度高于高分子及小分子光控取向膜的水平；实验证明用自组装多层膜制成的液晶器件亮暗态均匀，静态对比度约为100，达到实用化器件的水平。

The poly- 2-(dimethylamino ethyl methacrylate-b- potassium polyacrylate (PDMAEMA-b-PPA) with pH and temperature response was polymerized by Reversible Addition-fragmentation Transfer.

具体的过程与结果如下：通过可逆加成-裂解链转移法(Reversible Addition-fragmentation Transfer，RAFT)制备嵌段聚合物PDMAEMA-b-PPA，分子量为24500 g／mol，分布为1.10。

Dimethylamino)ethyl methacrylate was polymerized using PS-CH_2Cl as macroinitiator and CuCl/ 2,2 '-Bipyridyl as catalyst in toluene to acquire amphiphilic brush-type copolymers of PS-g-PDMAEMA.

再以氯甲基化的聚苯乙烯(PS-CH_2Cl)为大分子引发剂，在CuCl和2，2′-联吡啶(2，2′-Bipyridyl，bpy)存在下，以甲苯为溶剂，进行甲基丙烯酸N，N-二甲胺基乙酯2-(Dimethylaminoethyl methacrylate，DMAEMA的ATRP聚合，得到两亲性的梳状共聚物PS-g-PDMAEMA。

Surface enhanced Raman Scattering spectrum is a sensitive technique which is very useful in the study of conducting polymers electrochemically polymerized onto metals.

表面增强拉曼光谱是一种极其灵敏的表面测试手段，非常适合于用来研究电极表面生成的导电聚合物。

Specifically, itcontains 8 chapters.In chapter 1, the formation, structures, properties and the futureprospect of liposome were thoroughly reviewed;In chapter 2, the stibility and permeability of phopholipid -eleostericacid liposome were studied together with the effect of polymerizationof eleostearic acid. This membrane system was very sensitive to 〓,the effect of 〓 was clarified to increase the aggregation/fusion ofliposomes and made the permeability of mixed liposomes much higher;In chapter 3, two polymerizable conjugated diyne bolaamphiphiles were synthesized. They could form very stable mixed liposome, andthe diyne could be polymerized by UV light in bilayer liposomes, as aresult, the stability of mixed liposome against solvent or surfactantafter polymerization were enhanced. In chapter 4, two kinds of amphiphilic amino acids were synthesized andstable liposomes were formed therefrom After the condensationpolymerization of amino acid in bilayer liposomes, stable polypeptide liposomes were obtained, which had lower phase transition temperatureand higher permeability.In chapter 5, four kinds of glycolipids were synthesized and theiraggregation behavior in water was comparied. When incorporated intophospholipid bilayer membranes, they could increase the phase transitiontemperatures and inhibit the aggregation and fusion of mixedliposomesat lower temperature.In chapter 6 and 7, three kinds of steroidal bolaamphiphiles withdifferent chain lengths were synthesized. Incorporation of steroidalmoiety to the center of lipid bilayer membrane obviously increased themobility of lipid membrane and shifted Tc to lower temperature side incomparasion with cholesterol. The bolaamphiphile which was shorter thanthe hosted lipid bilayer membrane thickness influenced the lipid packingmore obviously.

全文共分8章：第一章对脂质体的形成、结构、性质及展望进行了较为详细的文献综述；第二章研究了磷脂-桐酸脂质体的稳定性，通透能力及桐酸的聚合对这些性质的影响；磷脂-桐酸混合脂质体为一类对〓灵敏的脂质体，〓的作用首先是使脂质体集聚然后使脂质体融合，并加速内包荧光物的释放；第三章通过合成两种可聚合共轭双炔双极性双亲分子DDCA，DDOL，研究了共双炔分子在双分子层脂质体膜上的聚合及对脂质体性质的影响，聚合可以提高脂质体相对于溶剂及表面活性剂的稳定性；第四章合成了两类氨基酸为极性基团的双亲分子，它们均可以在超声下形成稳定的脂质体结构；氨基酸基团可以在脂质体上进行缩聚反应，若聚合后脂质体表面仍有足够的亲水能力，则可得到稳定的多肽型脂质体；聚合后脂质体的相变温度降低，通透能力增加；第五章合成了四种亲水基团为单糖基的双亲分子GL-l，GL-2，GL-3， GL-4，研究了它们在水中的分散情况、集合体形态与分子结构的关系；在DMPC双分子层膜中加入糖脂分子可以使脂质体的相变温度提高，阻止脂质体在低温放置时的集聚与融合；第六章-第七章合成了三种不同碳链长度的双极性含胆甾环双亲分子 CL-1，CL-2，CL-3；它们可以象胆固醇一样与磷脂混合形成稳定脂质体，胆甾环基团位于脂质体双分子层膜的中间；与胆固醇的作用相反，它们可以增加磷脂双分子层膜的流动性，降低混合脂质体的相变温度；三种分子的作用与其碳链长度和磷脂双分子层膜的厚度有关，比膜厚度短的分子影响最大。

Second, investigations were made in the effects of polymerization of HRP on its catalytic activity in the excess of H〓O〓 by the use of fluorogenic hydrogen donors of HRP. The results showed that some HD, e. g. homovanillic acid could indicate the activity differences between HRP and polymerized HRP.

其次，为建立辣根过氧化物酶标记的调制型荧光免疫分析研究了用荧光供氢体代替显色供氢体指示聚合前后辣根过氧化物酶在高浓度H〓O〓中活性的差异。

The glycidol is protected by ethyl vinyl ether first to form 2,3-epoxypropyl-1-ethoxyethyl ether, then polymerized or copolymerized with EO by initiation with the mixture of diphenylmethylpotassium and triethylene glycol to give the well-defined poly.

得到的聚合物用甲酸水解去保护，并在二氧六环和甲醇的混合溶剂中用氢氧化钾溶液皂化后，得到了聚合物链的侧端挂有羟甲基官能团的线形聚醚linear Polyglycidol和poly。

Go to your desktop and right click in a blank space.

请到您的桌面，然后右击一个空白。

Tara appears in Buddhism, Jainism, and particularly, Tibetan Lamaism, as a complex array of manifestations: goddess of ascetism and mysticism, mother creator, protectress of all humans as they cross the sea of life.

度母出现在佛教，耆那教里面，尤其是西藏的喇嘛教，作为一系列的陈列阵容；神秘的女神，创世之母，人类横过生命之海洋的女性保护者。