查询词典 opening

If you have ever looked up your opening moves in the chess opening books then Chess Opening Trainer will change the way you study the openings.

如果您有任何时候都期待您的开放举措，在国际象棋开放的书籍，然后开放的国际象棋教练将改变您的研究挖掘。

If you have ever looked up your opening moves in the chess opening books then Chess Opening Trainer will change the way you study the openings.

如果您曾经期待您的开幕式将在国际象棋然后翻开书本开幕国际象棋训练将改变您研究的开口。

The program has an opening book capability, which means that anyone can optimize the program by adding his/her own opening moves data in the respective folder Huo Chess Opening Book (which should be in the same directory with the executable).

该项目有一个开放的书的能力，这意味着任何人都可以优化加入他/她自己的棋赛在各自的文件夹中打开火象棋图书资料（应在同一目录中的程序的可执行文件）。

Special localized cutting communication with the customer; 2.5 If not available notched hole diameter less than 60 mm hole, can be used to be relatively enlarger for the opening; After opening 2.6 backplane approach, starting with the opening negative, positive exposed bit sharp, nated from the positive control (both sides maintain collapse teeth); 3 connected corner of the corner of the 3.1 connection method, identify three Kok code on the middle and lower (50 mm poured from top to bottom. Another try a) 3:00 even in the corner of the counter and cross wooden cabinet on the sideboard; 3.2 corner of the Outer Limits with a shutter-ping; 3.3 In accordance with the drawings corner of the size, will have a fixed angle of the black reinforce the lower corner with 3:00 counters even

特殊局部地方的切割必须与客户沟通； 2.5如割口不大可用圆孔、直径小于60mm孔，可用相对应的扩孔器进行开孔； 2.6后背板开孔方法，先从反面开孔，正面露出钻头尖时，再从正面往里操作； 3 转角条的连接 3.1转角条的连接方法是，找出三个角码，上中下（上下50毫米往里，另居中一个）三点连在与转角柜交叉柜体的侧板上； 3.2转角条的外沿与门板一平； 3.3按照图纸转角条尺寸，将已固定的转角条用黑钉上中下三点与转角柜连

Fans and pumps are the mechanical properties of square torque characteristics, pump run-time,* the opening of the valve regulating the flow to meet water supply requirements, working conditions and the fan is similar to,* adjusting damper, duct or valve opening tailgate degrees to adjust the blower air volume, pumps flow methods, known as cutting regulation, regulation on cost-cutting process, the fan or pump the inherent characteristics of the same, only * small throttle clearance, baffle or valve opening, artificially increase line resistance, which increases the loss of pipeline system is not conducive to fan, pump energy-saving operation.

风机和水泵的机械特性均为平方转矩特性，水泵运行时，*阀门的开度调节流量来满足供水要求，工况与风机相似，*调节风门、风道档板或阀门的开度来调节风机风量，水泵流量的方法、称为节流调节，在节流调节过程中，风机或水泵固有特性不变、仅仅*关小风门、挡板或阀门的开度，人为地增加管路的阻力，由此增大管路系统的损失，不利于风机，水泵的节能运行。

The most popular during the Shang Dynasty was the "bird and beast" design,hu,(long-necked and small opening, deep-bellied with round base, some with overhanging handle),you (elliptic opening, deep-bellied with round base, has a lid and overhanging handle), lei (some round and some square, openings vary in size, short neck with square shoulders, deep bellied, with curling feet or round base, and has a lid), fou and the like are wine vessels, jue (deep-bellied, tri-pedestal, can be heated on top of fire, protruding grooves at the top for easy pouring), gu (the most common wine-drinking utensil, more often used in combination with jue, which is bigger, opening is shaped like a bugle, long neck, thin waist, tall curling feet), zh(similar to the zun in shape but smaller, some with lids), gong (oval belly, has an outer edge for flow of wine, short handles, bottom has curling feet, lid is in the shape of the head of a beast, some has an entire body like a wild animal, with small spoon as accessory), bei, zhen is to drink from.

尊（鼓腹、敞口、高颈，底有圈足，形制较多，商代以鸟兽形尊最为流行）、壶（长颈、敛口，有的有盖，深腹圆座，有的有提梁）、卣（椭圆口，深腹圆座，有盖和提梁）、罍（有圆形和方形，口大小不一，短颈方肩、深腹，圈足或圆底座，有盖）、缶等是盛酒的器具，爵（深腹、三足，可在火上加温，上端有伸出的沟槽以倒酒）、觚（最常用的饮酒器，多与爵相配使用，比爵小，口呈喇叭状，长颈、细腰、高圈足）、觯，觥（椭圆腹，有流酒的外沿和短提把，底为圈足，有兽头形盖，也有整体为兽形的，并附有小勺）、杯、盏是饮酒的器具。

The existence of unsteady flow during opening sluice gate and during a long time after opening sluice gate was proved through studying the flow in the process of opening sluice gate by using physical model.

利用物理模型对闸门开启过程中水流进行研究，证明了闸门开启过程中和全开之后一段时间内非恒定流的存在。

Under the ratios of various initial cracking relative length,height and volume of gas concrete beam,the whole curve of opening displacement s at several testing points about fracture toughness,fracture energy,and in the area of load,cracking-tip-opening-displacement,cracking tip opening displacement cracking-tip-area are researched systematically.

在本研究中对加气混凝土梁在不同初始裂纹相对长度、不同高度以及不同体积比例等情况下的断裂韧性、断裂能以及载荷—裂纹口张开位移—裂纹尖端张开位移—裂纹尖端前沿区若干测点张开位移全曲线进行了系统研究。

Results: Everyone's center of gravity was distributed in A zone while they were in seat. At standing with opening eyes and closing eyes, the center of gravity in A zone were in 429 subjects( 96.4%) and 436 subjects( 98.0%). Most parameters have significant difference in the women and the men, opening eyes and closing eyes, left-foot standing and right-foot standing, different age groups. The stability in closing eyes was better than in opening eyes, right foot standing was better than left foot standing.

男女、睁闭眼和左右脚比较多个指标有显著差异，闭眼双脚站位的稳定性要较睁眼时好，右脚单脚站位的稳定性较左脚好，各年龄段比较，除睁眼双脚站立左侧内外偏移幅度外，其他指标均有显著差异，20～39岁的平衡功能最佳，60岁以后出现衰退。

Please not that a 250 mm wide die opening will produce a film or sheet with less width since you have a "neck in" effect when you pull out the melted resin from the die before it reaches the surface of the chill roll. the width you can achieve depends on the melt strength of the resin as well as the distance between the die lip opening and the chill roll. but in general, about 80% of the die opening width can be achieved.

注意：250毫米宽开口的模头只能获得小于此宽度的薄膜或片材，因为当熔体树脂被从模头拉至冷辊上时会产生&颈缩&效应，最终获得的实际宽度依赖于树脂的熔体强度以及模唇开口同冷辊之间的距离，但总而言之，可获得模头开口宽度80%的产品宽度。

Yet, Edith says, there was always money in the bank.

但是Edith说，她的银行户口里面总是有钱。

We have created a series of files that resolve this problem--one for each day of the 40 days of purpose.

我们制作一系列的档案去解决这问题---一个为标竿40天中的每一天。