查询词典 minimum condition

It is shown that the porous particles are less energyconsuming to fluidize and, with their contents varying from 5%～25% in the riser, the minimum fluidization velocities based on gas stream are from 0.87×10-3 m/s to 2.2×10-3 m/s, while the critical transport velocities are from 1.0×10-2 m/s to 1.6×10-2 m/s for the operation with no liquid circulation or from 5.2×10-3 m/s to 7.1×10-3 m/s for the condition with liquid circulation.

例如，流化床电极、造粒、砂滤、结晶、浮选、聚合、煤气化、费-托合成[1]等。废水处理中三相流化床的应用得益于生物工程中的生物膜法和化工操作中的流态化技术的成功结合，主要优点为宏观混合程度高，固相内扩散阻力低，液体和固体外部传质阻力小，微生物浓度高。

For a given geometric parameter there exists a boundary condition, which gives a minimum value of the total exergy loss rate for a unit volume, and vice versa.

该结论对优化设计换热器及对给定边界条件的换热器优化选取具有一定的指导意义。

BP neural networks have been widely used in mode recognizing, image processing, system control etc A lot of study has been done on the training algorithm of BP neural networks But there are still many short comings To complete the training of the weights of a BP neural network, the key problem is how to overcome the staying at the local minimum points as well as how to increase the training speed based on this condition This paper comes up w...

BP神经网络被广泛应用于分类模式识别、图像处理和系统控制等领域人们对BP网络算法进行了许多的研究，但尚有其不足之处为完成其权的训练，问题的关键在于如何避免陷入局部极小及在此前题下如何提高学习速度为此，就如何选取学习率η和动量矩α提出了改进方案，并应用于数字识别，得到了较为满意的结果

The guitars is in near mint (9.25) condition with just the bare minimum of finish checking on the top and back and two very small surface chips, one on the top bass edge (3/16 inch) and the other on the lower edge (5/16 inch) near the strap button.

附近的吉他薄荷（9.25）的条件是只有在完成检查的顶部和背部和两个非常小的芯片表面，在顶部低音边缘（3 / 16英寸）和较低的边缘另一个最低限度（ 5 / 16英寸）接近带按钮。

To have at least one sheep constituted an irreducible minimum, a sufficient condition for the activity to occur.

至少要有一只羊构成不可减少的最小值，这是事件发生的充分条件。

The results show that there are optimal damping coefficient leading to the minimum response of the primary core-tube, and that the dynamic response is not sensitive to the lesser damper stiffness, and that the optimal value affected by inter-story drift ratio of the suspended floors as constraint condition and setting reasonable structural parameters could meet the optimization objectives and the inter-story drift ratio limit of the suspended floors.

结果表明：存在最优阻尼器的阻尼系数，使得主体核筒的响应最小；当阻尼器的刚度较小时，可以忽略其对结构动力响应的影响；悬挂楼面的层间位移角作为约束条件，影响结构参数的优化值；通过设置合理的参数才能够同时满足优化目标和悬挂楼面的层间位移角限值。

The conversion boundary of self-incompatibility was researched by sowing by stage. Sunshine of day and temperature was studied critically by investigating leafage and researching traits indoors. The results showed that the daily minimum temperature was the principal factor of affinity conversion and the affinity conversion boundary was 16.5~18.1℃.HE97 was primarily regard as self-incompatible line in this research. The method was by inbreeding and sib HE97, Half the silk of HE97 and Zheng58. Inbreeding and cross have been done simultaneously. The extending condition of pollen tube was observed by dying the silk after pollinating 4 hours. The individuals with pollen tube were observed having seeds, while the individuals without pollen tube were observed having few seeds or no seeds. So this study regard HE97 as sporophytic self-incompatibility .The planting ration of female parent HE97 and male parent 87-1 was 4:1.The nature cross-pollination was studied by the theory of endosperm xenity, the study show that the setting percentage of HE97 was 625%, in which the seed in self was 70% and the seed in hybrid was 30%. This was consistent with the study of silk anatomy structure, then come to the same conclusion: compatible pollen germination and fertilization can stimulate the self-incompatible pollen germination and fertilization in the same corn cob.

通过分期播种，进行了光温敏自交不亲和材料HE97亲和性转换区间的研究，依据田间跟踪调查叶龄及室内考种研究了HE97亲和性转换区间的光温临界值，结果表明：1日最低温度是影响HE97自交不亲和性的主要原因，亲和性转换区间在16.5℃～18.1℃之间。2通过HE97自交和姊妹交以及将HE97与郑58作为双亲，各自的花丝一分为二，分别正反交，授粉后4个小时分别取其花丝进行固定、染色，观察花粉管的伸长情况，根据结实率与花粉管伸长的对应关系，结果发现观察到花粉管的对应植株收获到了种子，而没有观察到花粉管的对应植株结实率极低或没有结实，本研究把HE97初步划为孢子体自交不亲和类型。3以HE97为母本，87-1为父本，按4母：1父行比，通过花粉直感效应研究天然异交率，结果母本HE97结实良好(62%)，其中自交粒占70%，异交粒占30%，结合花丝切片观察表明，亲和花粉的萌发及受精会导致落在同一果穗柱头上不亲和花粉的萌发不再受抑制。

Based on the full three-dimensional numerical simulation for the centrifugal pump, an optimal mathematical model of blade curve is set up. In this model, the object function is the minimum length of the blade curve; the constraint condition is no recirculation atr=0.5. This model makes the design of optimum blade curve efficient.

在对离心泵内部流场进行全三维数值模拟的基础上，建立了叶片型线优化设计的数学模型以叶片长度最短为目标函数，叶轮相对半径，r=0.5处无回流为约束条件，讨论了该模型优化计算的方法。

2TheMax GPX750 PSU for the desktop computer features total output of 750W, rated supply voltage of 115V to 230V auto range, rated mains frequency of 47 to 63 Hz, rated input of 115V at 10A or 230V at 5A, efficiency of 85% minimum at typical load, holdup time of 16.6ms at nominal line under full load condition, power good signal between 100ms to 500ms, over current protection at 110% to 150% individual output power, over voltage protection for +5V is between 5.8V to 6.3V,+12V from 14V to 17V, 3.3V from 3.6V to 4.2V, air flow by DC fan, operating temperature of 0°C to 50°C and operating humidity of 20% to 90% non-condensing.

2themax gpx750电源为桌上型电脑的功能总产量750瓦特，额定电源电压115v到230v汽车范围，额定工频47至63赫兹，额定输入的115v在10 A条或230v在5 ，效率85 ％，最低在典型负载，持的时间16.6ms的名义在网上下，满负荷条件下，电源良好信号之间的100 ms到500ms ，过电流保护在110 ％至150 ％个别的输出功率，过电压保护，为5 V是之间的5.8 V至6.3v ，+12 V的从14v至17v ，电压为3.3 V从V到3.6 V至4.2 V ，空气流量由直流风扇，操作温度0° C到50 ° C和运作中的湿度为20 ％至90 ％，非冷凝。

Because of the relaxation and cooperation action of other loads, the controlling condition is the minimum value.

由于膜材的松弛特性和其他荷载联合作用，给出的控制条件是防止膜结构积水的最小值。

"Second Life is remarkably easy to work with, and is very popular,"

"第二次生命是显着容易的工作，并且很受欢迎，"

For example, we usually assume that materials are homogeneous and isotropic and free of internal defects or flaws.

为了得到适合有限元分析的模型，我们必须经过如图2所示的简化步骤。