查询词典 maximum element

Electrochemical measurements of the singler A2B7 and A5B19 phase alloy showed that, the activation properties of singler type A2B7 and AsB19 phase composition alloys were the same. The maximum discharge capacity (386.12mAh/g) of A2B7 type phase alloy was slightly higher than the maximum discharge capacity (371.38mAh/g) of A5B19 type phase alloy. The cyclic stability of alloy electrode of both A2B7 and A5B19-type phase alloy were all very well. The capacity retention rate of 100 cyclic was more than 85%.The high-rate discharge (HRD900=85%) of AsB19phase alloy was higher than the high-rate discharge (HRD900=76.6%) of A2B7phase alloy.

对较单一的A2B7与A5B19型物相合金进行电化学测试，结果表明：A2B7型相结构储氢合金的活化次数与A5B19型相结构储氢合金的活化次数基本相同，A2B7型物相合金的最大放电容量(386.12mAh/g)略高于A5B19型物相合金的最大放电容量(371.38mAh/g)。A2B7与A5B19型物相合金电极100个循环容量保持率都在85%以上，且差别不大。A5B19型相结构合金的高倍率放电性能(HRD900=85%)高于A2B7型相结构合金的高倍率放电性能(HRD900=76.6%)。

Maximum gallic acid yield ( 83.8%) was obtained after Escherichia coli was cultivated aerobicly in 100mL liquid culture medium with 7g/L tara tannin extract and 1g/L complementary urea on snaker (120 rpm) at initial pH 6.0 and 28℃for 28h, while maximum tannin reduction rate (43.6%) was obtained after 5g/L glucose was supplied instead of urea in the same degrading conditions above.

当塔拉单宁浸提物浓度为7 g/L、补充的尿素浓度为1 g/L、初始pH为6.0、250 mL锥形瓶装液量为100 mL、28℃振荡(120 rpm)培养28 h时，棓酸产率可达83.8%；当补充的葡萄糖浓度为5 g/L时，塔拉单宁降解率可达43.6%。

The results were showed as following:The work intensity of trunk muscles activities was different in forestry work conditions; work intensity of Erector spinae were the maximum,approaching over 30%Maximum Voluntary Contraction,and EMG amplitudes of Rectus abdominis and Oblique external abdominis were 10%MVC.

研究结果如下：在不同作业工况中，躯干不同肌肉的工作强度存在差异，背部竖脊肌工作强度为最大，均在最大用力的30%左右，其次为腹直肌与腹外斜肌均在最大用力的10%左右。

Results of pulling test reveal that the nominal strength ratio of corroded hot-rolled steel bar over uncorroded one is approximately equal to the ratio of maximum residual sectional area over the uncorroded one.And the rupture extension ratio of corroded hot-rolled steel bar is exponentially decreased with the maximum sectional loss ratio.The effect of stress concentration caused by corrosion pits has a significant influence on the decrease of rupture extension ratio but it is ignorable on the nominal strength ratio.

实验结果表明：锈蚀钢筋与未锈钢筋的名义强度比可近似取锈后钢筋的最大残余面积率，受锈坑应力集中的影响甚微；锈蚀钢筋的断后延伸率随最大截面损失率呈指数下降，受锈坑应力集中的影响显著。

It is found that the GRAPES model is able to reproduce the observed atmospheric kinetic energy spectrum, including the transition to k-5/3 dependence in the small-meso scale. Meanwhile, there exists a maximum effective time-step, when the time-step is smaller/larger than the maximum effective time-step, the simulated kinetic energy spectrum gradually decays/unphysically grows as the time-step increases.

文中使用基于半隐式半拉格朗日动力框架的全球/区域一体化模式GRAPES进行数值模拟试验，然后计算GRAPES模式的动能谱并与实际观测得到的大气动能谱比较，得到GRAPES模式能够很好地复制出实际大气动能谱的分布特征，包括从大尺度区域的E∝k-3关系向中尺度的E∝k-5/3关系的过渡特征。

Three typical diagnostic cut-off points were determined based on the maximum accuracy, the maximum Youden's index and the intersections of sensitivity and specificity.

临床医师及大多数研究者以SUV =2或2 5作为鉴别肿瘤良恶性的分界点[2 6 ] ，但计算SUV的感兴趣区大小却不一致，有的是病灶区具有最大值的单个像素，更多的是在病灶区主观勾画某一大小的ROI计算均值[1 ，7 9] 。

The DRe differences among plants could be well differentiated by TP. The DRe., i.e. water retention, represented by TP, was used as a major index to identify the ability of plant drought tolerance. It was showed that C.arborescens Ecotype Wu was generally the most drought tolerant one except lower than C.arborescens Ecotype XJ which was the maximum in May, bore comparison with Zygophyllum xanthoxylum by estimating seasonally; C.latens Ecotype NX was significantlly lower than C.arborescens Ecotype Wu, the result was contrary to being known; C.arborescens Ecotype Kerqin was significantlly lower than Wu; XJ, the maximum in May, showed no else great difference to NX; C.lanata was high in April and not high afterwards, however its phenological phase presented visible changes as compared with the original life patterns in western America.

结果表明，华北驼绒藜(C.arborescens Ecotype Wu)总体上表现出最强的耐旱性；宁夏驼绒藜(C.latens Ecotype NX)耐旱性显著低于华北驼绒藜；科尔沁驼绒藜(C.arborescens Ecotype Kerqin)耐旱性显著低于华北驼绒藜；新疆驼绒藜(C.arborescens Ecotype XJ)5月耐旱性表现最强，其他时间与宁夏驼绒藜差别不大；北美驼绒藜4月拐点很高，4月以后耐旱性降低，其物候期与原分布区相比发生了很大变化。

This article puts forward the partial least squares regression and the maximum entropy risk analysis model for the first time on the basis of analyzing the disadvantage of the traditional methods and anatomizing the advantage of the partial least squares regression method and the maximum entropy method.

作者在分析传统风险评价方法的优缺点、剖析偏最小二乘法和最大熵法优势的基础上，首次提出了偏最小二乘－最大熵风险分析模型。

The results show that the concentration of displacement and stress in surrounding rock intensifies with the increase of excavation steps. The maximum compression and tension stress reach 54 MPa and 3.9 MPa, which are close to the peak strength of surrounding rock. When the tailings are backfilled, the magnitude of floor heaves reduces about by 5 mm, and the maximum compressive stress drops to 32 MPa. Distribution of both stress and displacement fields are improved and the stability of stopes can be ensured during the mining process.

研究结果表明：随着开挖逐步推进，围岩位移不断增大，应力集中现象明显，最大压应力达54 MPa，最大拉应力达3.9 MPa，接近围岩的极限强度；在尾砂回填后，底鼓量下降5 mm，最大压应力降至32 MPa，表明应力场和位移场均得到改善，能确保回采期间采场的稳定。

As the same section is concerned, near the bottom the maximum value of frequency appear within 1mm of bubble size, towards the water face this value tend to decrease, yet the corresponding size turns to increase; in the same time, the frequency is concentrated near the bottom and deconcentrated near the water face; under the experiment condition, the maximum frequency of the total section approximately appear at 0.5mm size; mean bubble size access 0 at bottom and increase acceleratively towards water face where tend to be infinite; total number increase during developing of aeration, and become steady when reach wholly developed area; on the same section, the total number in unit time tend to increase at first and decrease then, along the water depth.

对于同一断面，靠近槽底的测点气泡个数分布最大值出现在气泡尺寸小于1mm的范围内，朝水面方向各测点气泡个数分布最大值呈减小趋势，而其对应尺寸则呈现变大趋势；在靠近槽底，个数分布表现得比较集中，而在水面附近气泡个数分布曲线表现得低而平缓；实验条件下，整个断面上的气泡个数分布的最大值大体上出现在尺寸为0.5mm的地方；气泡平均尺寸在槽底处接近于0而朝水面方向迅速增大，且越接近掺气水流的水面，增加速度越快，最终趋于无穷大；气泡总数在掺气发展区内是沿程增加的，当掺气水流发展到一定程度后气泡总数就基本保持不变了；在同一断面上，各测点单位时间内的气泡总数随高度呈现出先增加后减小的趋势。

"Second Life is remarkably easy to work with, and is very popular,"

"第二次生命是显着容易的工作，并且很受欢迎，"

For example, we usually assume that materials are homogeneous and isotropic and free of internal defects or flaws.

为了得到适合有限元分析的模型，我们必须经过如图2所示的简化步骤。