查询词典 management layer

Use Layer, Set Layer Properties, Set Layer Format, Protect Object, Protect Document, Introduction to ShapeSheet

图层的使用，设置图层属性，设置图层格式，保护对象，保护文档，ShapeSheet 简介

Based on experience and harvest obtained home and abroad, pavement structure of asphalt overlay is studied out by forecasting future traffic capacity. Mid-layer of overlay structure is the most adverse layer in the whole structure by mechanics analysis, so the material composition design of mid-layer is considered as emphasis.

借鉴国内外已有经验成果的基础上，通过对旧路面状况调查，结合未来交通发展的需求，进行了加铺层的结构组成设计，并从力学角度分析了中面层为加铺层结构的最不利层，因此对其材料组成设计进行重点研究。

It aims at providing unified and transparent service to the user by organizing all the computing resource of the campus in an efficient manner and hiding the internal heterogeneousness and dynamic. The whole campus grid is a three-tier system, which is composed of grid portal layer, grid middleware layer and computational resource layer.

将校园网内的各种计算资源以有效的方式动态的组织起来，隐藏其内部异构性和动态性，形成一个可相互利用、相互合作、对用户相对透明的高性能计算环境，为科研教学提供高效可信的协同计算服务。

In this dissertation, we optimized the thinkness of each layer of TFEL devices using the layered optimization method to obtain ZnS: Ce〓 TFEL devices. Accoding to the energy level structure of Ce〓, two criteria for distinguishing the EL of Ce〓 were found out, from which it was conduded that the TFEL of ZnS: Ce〓 comes from 5d→4f transition of Ce〓. The measurement of brightness waveform showed that the TFEL of ZnS: Ce〓 was the luminescence from independent centers. and there were the field induced-delocalization in this process anf it〓s the cause of low TFEL efficiency of ZnS: Ce〓. In this dissertation, different influence factors on TFEL of ZnS: Ce〓 were sdudied. The influence of different host lattice is different: The blue/green ratio of ZnS: Ce〓 in hexagonal system of ZnS is larger than that in cubic system of ZnS, and the TFEL peaks in hexagonal system of ZnS moves toward longer wavelength compared with that in cubic system of ZnS. The adding buffer layer was used in this stage. The solubility of Ce〓 in ZnS was small and it was another limit to TFEL brightness of ZnS: Ce〓 device. The solubility of Ce〓 increased ten times when using Li ions as flux, so that the TFEL brightness of ZnS: Ce〓 was enhanced. It was found that the appearing of ZnO in active layer improves the TFEL of ZnS: Ce〓: the brightness and the wave range of ZnS: Ce〓TFEL were enhanced.

本文采用TFEL的分层优化方案，优化组合了各膜层厚度，选择最佳制备条件，得到了ZnS：Ce〓的TFEL；根据Ce〓的能级结构，找到了判别Ce〓的EL的两个简单依据，并据此断定ZnS：Ce〓的TFEL的两个发射峰分别属于Ce〓的〓和〓跃迁；亮度波形测量表明ZnS：Ce〓的TFEL属于分立中心发光，分析认为在此过程中存在着较严重的场致离化，这也是ZnS：Ce〓的TFEL效率较低的一个原因；本文考查了影响ZnS：Ce〓的TFEL的各种因素，发现：基质的晶体结构对ZnS：Ce〓的TFEL有所影响，在六角相ZnS中Ce〓的TFEL优于立方相ZnS中Ce〓的TFEL：发射峰的蓝-绿比相对较大，且光谱向短波方向移动，在此项研究中本文采用了在发光层前增镀过渡层的办法，过渡层为六角晶相的ZnO；限制ZnS：Ce〓的TFEL器件亮度的一个原因是Ce〓在ZnS中的溶解度低，本文用Li离子作助溶剂增大了Ce〓的溶解度，增大幅度为一个量级，并且ZnS：Ce〓的TFEL亮度明显提高；从ZnS：Ce〓的TFEL光谱来看ZnS：Ce〓的TFEL波长覆盖范围较小，亮度也不高，达不到做为白色TFEL材料的要求，需要寻找新的白色TFEL材料；在研究ZnS：Ce〓的TFEL中还发现：发光层中ZnO的出现有利于ZnS：Ce〓的TFEL：发射峰变宽、亮度增大。

The anatomical study deepens the knowledge of G-type conducting cells: 1 It proves the theory of two depositional process for secondary wall (Bierhorst, 1960): the discontinuous cellulose layer is laid down before the continuous lignified layer; the former layer is prone to be broken down, while the latter is highly decay-resistant; 2 It suggests that the cellulose primary and secondary walls of tracheids are not perforated. Instead of longitudinal pits (Li, 1992), the lignified tracheid secondary wall of Hsüa possesses irregular simple perforations; 3 In Hsüa reflexa and Huia gracilis, the perforation casts may represent the thickness of lignified secondary wall; 4 The wall structure of G-type tracheid is diversified. At the genus level, the secondary wall structure differs in the distribution, internal shape and structure of the perforations; 5 Perforations of some G-type tracheids combine the characters of S-type tracheids in their distribution, density and diameter.

解剖学的研究加深了对G-型输水管胞的认识 1）验证了管胞次生壁分两个阶段形成的理论（Bierhorst，1960），即先后形成不连续的纤维质层和连续的木质化层，前者易被分解，后者抗侵蚀性强；2）证明管胞纤维质的初生壁和次生壁不具穿孔，Hsüa管胞的木质化次生壁具有不规则的简单穿孔，而不是纵列的纹孔（Li，1992）；3）Hsüa reflexa和Huia gracilis的穿孔铸体可代表木质化次生壁的厚度；4）G-型管胞壁层结构具多样性，植物属一级的分异主要表现在次生壁穿孔的分布、孔腔形状和结构的不同；5）某些G-型管胞的穿孔在其分布、密度和孔径方面可兼有S-型管胞的特征。

Silicon nitride passivation layer existed in standard CMOS process is used as hydrogenous ions sensitive layer, ISFET with multi-layer floating electrode structure works as the sensing unit.

介绍了一种基于上华0.6μmCMOS工艺实现的pH值传感器集成电路的设计和研究，它采用标准CMOS工艺提供的Si3N4钝化层作为氢离子敏感层，并以多层浮栅结构的ISFET作为传感单元。

Common-and air-cushion type comparison: when it comes to air cushion layer, air cushion layer is in a State of managers'change granula, it is made of synthetic elastomer and is indicated by a particle, microparticulate, interlamination of air compression layer by air cushion rubber compounds bubble and decided that blanket surface treatment is divided into three, the first coated paper: use sulfuration to form the process of polishing.

普通型与气垫型对比：谈到气垫层，气垫层是处于封闭式颗粒之状态，它由合成弹性体和微粒组成，微粒内含空气，层间的压缩性由气垫层气泡和橡胶化合物决定，橡皮布表面处理分为三种，第一种涂铸：使用硫化纸张形成表面抛光的过程。

Calculating the pavement fragment adoptioning contradicting -cleft -glue and glass fiber grille ,deal with the existing crevasse, at kaminaka surface layer install rubber asphalt water proof adhesive layer , at the same time guarding against water coming into nakashita surface layer、enhanced interlamination bonding ...

论文进行橡胶沥青混合料的主要试验内容有：1、根据京秦高速公路管理处提供的石料进行目标配比设计；2、进行混合料马歇尔击实及相关性能试验确定最佳油石比。3、根据冷料配比进行热料仓筛分，确定热料仓配比；4、根据热料仓配比进行马歇尔击实试验。4、进行混合料的路用性能试验，分析橡胶粉的掺入对沥青的高低温性能、弹性性能、抗老化性能的改善情况，分析橡胶粉的掺量、目数、胶源、加工工艺和基质沥青对橡胶沥青性能改善的影响程度。

For single-layer fabric, weaves are re-grouped for the purpose of mathematical description, and they fall into three groups: regular weaves, pre-regular weaves and irregular weaves. And then the mathematical models of every group are established, the parameters and the qualifications of weaves automatic generation are offered too. For multi-layer fabric, Kronecker product and yarn grouping of different layers according to the arrangement ratio are combined together to explore the mathematical model of weaves automatic generation. The qualifications of forming the multi-layer weaves are also discussed.

对单系统织物组织类别，首先根据数学描绘的需要进行了重新划分，分为规则组织、准规则组织和非规则组织，接着分别建立了各种类别组织的数学模型，并对组织自动生成的参数和组织构成条件进行了归纳和总结；对于多系统组织的重组织和层组织，结合不同系统纱线按排列比的分组法和矩阵的Kronecker叉积运算建立了组织结构矩阵自动生成的数学模型，并对多系统组织构成条件的数学模型进行了分析。

In chapter 4, by analyzing the interchange of seepage water between overburden layer of weak permeability and sandy gravel bed, a short computer program for adopting weighting soil layer on the landside of dike is put forward, the optimal design schemes about combination weighting soil layer with inverted drainage works are studied.

第四章 通过分析堤基弱透水覆盖层与下卧砂砾层之间的渗流关系，创建了堤防背水侧盖重压渗的快捷计算模型并研制了相应的计算软件，提出了盖重压渗与反滤导渗相结合的优化设计方案。

The receding calculations and experiment analyses in this subject are built on the blood cast of pig tongue.

本研究课题的前期工作是采用猪舌血管铸型模拟人舌而进行的数值计算与实验分析。

"Each human infection constitutes an opportunity for genetic modification of the virus through reassortment, mutation, or both...."

&每一次人类的感染都暗藏着一次基因修改的机会，无论是通过病毒的整合、突变或者兼而有之。。。。&