查询词典 lower

Our factory's surcharge is very low,we have no rent,and the workers are close-by inhabitant,it must reduce the price of products,lower price at same quality,we are not only emphasize on price but also reputation,we can produce the same quality mass product with samples,it is the key for our living and development,we have our own designer,we can make sample according to buyer's requirements until to buys are satisfied with the sample,and we are welcome design/make samples and processing on order,we can assure our offer is much lower than other.

我厂自身附加费用低，无厂房租金，，工人均为附近居民，这样必然降低产品的整体成本，同等质量的产品价格低，我厂不仅注重价格，更注重信誉，所做大货与样品一致，绝不偷工减料，这是我们生存和发展的法宝，我厂拥有专业的设计人才，可协助客户设计制作产品，满意为止，而且可单独承接设计，打样，来料加工，价格均为行内最低价。

What's more you could receive lower rates and lower closing cost.

何况你可以接受较低的利率和较低的成本闭幕。

The lower back, also known as the lumbar region is made up of five vertebrae, the sacrum and coccyx, and is found in the lower third of the spine.

下背部，又称为腰地区成立五腰椎，骶尾骨，发现在较低的三分之一的脊柱。

The friction performances of carbon face were investigated with an inertia friction tester. The torque curve of carbon face was ideal, the coefficient of static friction was lower than that of dynamic in 0.28 MPa, the friction coefficient of static and dynamic decreased with the braking pressure increasing. To the fiber face, the coefficient of dynamic friction of carbon face was more stable in cycle braking process, the wear rate was lower, and it was efficient to protect the couple plate not to be worn.

结果表明：碳质层的摩擦力矩在制动初期上升较快，中间过渡区平稳，尾部翘起较小；在制动压力小于0.28 MPa时静摩擦系数小于动摩擦系数，且动、静摩擦系数均随制动压力增加而减小；相对纤维层而言，采用碳质层摩擦时摩擦力矩曲线形态更好，连续制动时摩擦系数波动较小，磨损率低且能够有效保护偶件，是1种静/动摩擦系数比较低且适用于高载荷工况条件下使用的摩擦材料。

In architectural terms, the lower performance ARM cores command a lower license cost than the higher performance cores.

在架构上而言，较低效能的 ARM 内核比较高效能的内核拥有较低的授权费。

We establish a relation between μ and the stucture of the group G, and obtain the lower bound of the ratio by the mininal prime divisor of the order and commutator of the group G, and give a necessary and sufficient condition under which this lower bound is attained.

第一部分，记有限群G的阶与不可约特征标个数的比值为μ，我们研究了一般的非交换有限群G的结构和μ之间的关系，通过群G的阶的最小素因子和换位子群G′的最小素因子得到了μ的一个下界，同时给出了达到下界的一个充分必要条件。

The variation of the microelement Ni, V, Sc, Rb, Ba and Sr was analogous to the change of the Ce anomaly from the Wufeng Formation to the basal Longmaxi Formation at the Goujiaya and Datangkou sections, and 5 cycles, separately corresponding to the lower and upper part of the Dicellograptus complexus Zone, the lower Pacificograptus pacificus Zone, the upper pan of P.pacificus Zone to the Normalograptus ojsuensis Zone, and N.

在苟家垭和大塘口剖面五峰组-龙马溪组底部，Ni，V，Sc，Rb，Sr和Ba等微量元素丰度以及稀土元素Ce异常的变化具有相似的规律性，可划分成5次旋回，分别对应于D.complexus带下部，D.complexus带上部，P.pacificus带下部，P.pacificus带上部至N.ojsuensis带，以及N.persculptus带至P.acuminatus带。

For a given compound rule, if the upper bounds of both confidence and support minus their corresponding lower bounds are less than a given constant, the measurements of the rule are definite; if the the lower bounds of both confidence and support are greater than their corresponding thresholds, the existence of the rule is certain.

对于一个复合型分类关联规则，如果规则的支持度和置信度的下界都分别超过支持度阈值和置信度阈值，则称该规则的存在性是确定的；如果规则的支持度和置信度各自的上界与下界之差小于一个给定的常量，则认为规则的度量参数是确定的。

The results show that when the porosity of sample was higher, compressure rate was higher and resilience rate was lower, however resilient rate of sample with higher porosity were increased notably when pressure was increased, and it tended to accord with of sample with lower porosity. The friction coefficient was higher when porosity of paper-based friction material was higher, and the friction coefficient tended to reduce and stabilize when braking pressure was increased. The friction coefficient of sample with high porosity tended to reduce and stabilize in continuous braking cycles.

结果表明：在相同载荷下，随着孔隙率增大，材料的压缩率增加而回弹率降低，随着载荷增加，高孔隙率材料的回弹率先明显增大，而后趋于稳定；在相同比压和转速下，孔隙率越高，材料的摩擦系数越大，随着比压增加，孔隙率高的材料摩擦系数逐渐降低，且不同孔隙率材料的摩擦系数逐渐趋于一致；在连续循环制动时，高孔隙率材料的摩擦系数逐渐降低并趋于稳定。

Some parameters such as Indoor radiation heat transfer, convective heat transfer, MRT, OT, radiation heat transfer coefficient, convective heat transfer coefficient, and PMV-PPD were calculated under a steady condition. From the result, we can conclude, when operation under the combination system and worst-case test, if floor temperature is about 21℃, supply air temperature is 21℃, air velocity is 1m/s, the equlvalent coefficient of heat transfer between floor temperature and OT is 13.6w/m2k, where 5.68w/m2k is equlvalent coefficient of radiant heat transfer, 9.48w/m2k is convective heat transfer coefficient. And when air velocity is higher, supply air temperature is lower, the radiant heat transfer between floor and others is lower. In the whole experiment, the floor temperature was keeping above the indoor air dew point, and condensation was not appeared.

通过分析计算，在复合式系统运行中，最不利室外环境下，当地面温度维持在21℃左右，送风温度21℃，送风风速1m/s，此时地板对作用温度的当量综合换热系数为13.6w/m2k，其中当量辐射换热系数为5.68w/m2k，对流换热系数为9.48w/m2k，并且送风速度越高、送风温度越低，地板与其他壁面的辐射换热量有一定程度的降低，但总供冷量增加；在整个实验中地板温度始终高于地板上层空气的露点温度，并未发现有结露现象；室内空气温度梯度能满足0.1m-1.1m的温差小于3℃的要求，并且适当提高送风温度可以进一步提高人体的热舒适性。

I was just taking her hand, to help her out of a car, and I knew it.

我只是握着她的手，扶她下车，但我知道这一切。

China and South Korea have excoriated Japan over its approval of new school books which they say whitewash the atrocities committed during Japanese occupation, and anti-Japanese protests have been held in Chinese cities. The lingering bitterness over Japan's past imperialism still threatens to mar relations between the big East Asian powers

中国和韩国强烈谴责日本通过新的中学历史教科书，他们认为这一教科书掩盖了日本在其占领期间所犯下的残酷暴行，反日抗议活动在中国数座城市发生，历史上日本帝国主义制造的痛楚无法被忘却，这有可能破坏东亚强国间的关系。