查询词典 load up

Lead Ph Basic load rating Permissible load F P Nut mass Shaft mass Dynamic rating Ca Static rating C 0 a mm kN kN kN kg kg/m 10 30.7 79.3 5.26 10.65 Type using standard material Standard grease Standard seal Iron-based AFB-LF None Dimensions of the Ball Screw Nut Attached with Wiper Ring W and QZ Lubricator WW avail- ability QZ avail- ability Dimensions including WW L Length of protrusion with QZ attached QWL Outer diameer of protru- sion with QZ...

载荷钢球圈列数 DN值预压预压方法预压负荷 1row 2.50圈 70000 有定位置预压 1535 导轨型号丝杠轴加工方式球保持器轴的花键部分中空轴滚珠精密无无无轴承支撑座固定侧的推荐方式轴承支撑座支撑侧的推荐方式螺母种类螺纹方向间隔钢球 BK30，BK35，FK30 BF30， BF35， FF30 双螺帽右螺纹，左螺纹，左右螺纹无。。。

Lead Ph Basic load rating Permissible load F P Nut mass Shaft mass Dynamic rating Ca Static rating C 0 a mm kN kN kN kg kg/m 8 39.1 132.3 5.08 14.0 Type using standard material Standard grease Standard seal Iron-based AFB-LF None Dimensions of the Ball Screw Nut Attached with Wiper Ring W and QZ Lubricator WW avail- ability QZ avail- ability Dimensions including WW L Length of protrusion with QZ attached QWL Outer diameer of protru- sion with QZ...

载荷钢球圈列数 DN值预压预压方法预压负荷 1row 2.50圈 70000 有定位置预压 695 导轨型号丝杠轴加工方式球保持器轴的花键部分中空轴滚珠精密无无无轴承支撑座固定侧的推荐方式轴承支撑座支撑侧的推荐方式螺母种类螺纹方向间隔钢球 BK20，EK20，FK20 BF20， EF20， FF20 双螺帽右螺纹，左螺纹，左右螺纹无轴。。。

Lead Ph Basic load rating Permissible load F P Nut mass Shaft mass Dynamic rating Ca Static rating C 0 a mm kN kN kN kg kg/m 36 65.9 135 7.4 12.5 Type using standard material Standard grease Standard seal Iron-based Multemp HRL Grease RR Dimensions of the Ball Screw Nut Attached with Wiper Ring W and QZ Lubricator WW avail- ability QZ avail- ability Dimensions including WW L Length of protrusion with QZ attached QWL Outer diameer of protru- sion...

载荷钢球圈列数 DN值预压预压方法预压负荷 2列 3.80圈 160000 有定位置预压 3325 导轨型号丝杠轴加工方式球保持器轴的花键部分中空轴滚珠精密有无无轴承支撑座固定侧的推荐方式轴承支撑座支撑侧的推荐方式螺母种类螺纹方向间隔钢球 BK40 BF40 简易螺帽右螺纹无轴方向刚性螺纹条数防尘措施防尘罩形式 W清洁环。。。

Lead Ph Basic load rating Permissible load F P Nut mass Shaft mass Dynamic rating Ca Static rating C 0 a mm kN kN kN kg kg/m 10 27.6 63.3 2.75 6.51 Type using standard material Standard grease Standard seal Iron-based AFB-LF RR Dimensions of the Ball Screw Nut Attached with Wiper Ring W and QZ Lubricator WW avail- ability QZ avail- ability Dimensions including WW L Length of protrusion with QZ attached QWL Outer diameer of protru- sion with QZ at...

载荷钢球圈列数 DN值预压预压方法导轨型号 2列 2.50圈 70000 无无滚珠丝杠轴加工方式球保持器轴的花键部分中空轴轴承支撑座固定侧的推荐方式精密无无无 BK25，FK25 轴承支撑座支撑侧的推荐方式螺母种类螺纹方向间隔钢球轴方向刚性 BF25， FF25 单一螺帽右螺纹，左螺纹，左右螺纹无 680.0 螺纹条数。。。

Using this probabilistic load flow model, the probabilistic distribution of load flow and nodal voltage can be calculated, therefore the reasonable penetration level of wind power plant can be determined.

本文的方法能够求解含风力发电场的电力系统的线路潮流及节点电压的概率分布，因此可以确定风电场的穿透功率极限。

And parking braking load case combined with mechanical load case have relatively less effect on fatigue crack initiation at the rim of wheel plate hole.

机械载荷工况与停车制动工况的组合作用对车轮辐板孔边萌生疲劳裂纹的影响相对较小。

By establishing statistical function relationship between accelerations and strain signal with wheel load, this method can be used to measure customer load indirectly.

该方法将加速度和应变信号与车轮载荷之间建立统计函数关系，从而可间接测量用户载荷。

Taking one wheel moving load as an examples the stress state variation, principal stress axes rotation and the influence of load speed are analyzed.

以单个轮轴移动荷载为例；分析地基土单元的应力状态变化、主应力轴旋转以及荷载速度的影响。

Proposes a method for selecting optimal chiller unit configuration in design phase, in which the energy consumption of chillers is simplified to the function of actual cooling capacity and entering water temperature of the condenser, then the all-year building load frequency distribution under different outdoor wet-bulb temperature that determines the minimum entering cooling water temperature is obtained by dynamic load calculation, and finally, calculates the all-year energy consumption and energy consump...

提出一种在设计阶段对冷水机组方案进行优化配置的方法。首先，冷水机组的能耗计算简化为制冷机的实际制冷量和冷却水进口温度两个独立变量的函数。进一步，通过建筑动态负荷计算获得全年冷负荷频率特性以及相应的室外湿球温度分布，其中湿球温度决定了冷却水最低进口温度。最终，计算出各种冷水机组配置方案的全年以及不同冷负荷需求工况下的运行电耗，并得出最优化的节能方案。

The lack of a well-characterized in vitro model of load-induced cardiac hypertrophy has hampered further mechanistic investigation in this area, and little is known as to how mechanical load in initially converted into intracellular signals of gene regulation.

以往对心肌肥厚的实验研究基本上采用体内实验方法，然而，在体的实验研究由于受血液动力学、激素、神经反射的影响，不能恰当地反映一些因子或激素在心肌肥厚中的意义。

We have something to do in the new stage.

在这段崭新的时期中，我们有一些要做的。

The difference between tourism decision-making under uncertainty and risky tourism decision-making is indistinctive.

其中不确定性旅游决策和风险旅游决策的界线比较模糊，两者的区分是相对的。