查询词典 lithography

Research on the large field projection lithography lens［J］.

大视场投影光刻物镜的研究［J］。

For example: four p's degree 16 open, with pS do text using K100, sent to distributing center told black and there is no nano-imprint lithography, which is the location of the black and the other on the color separation is in order

举例：四个p的大度16开，用pS做的，文字用K100，送到发片中心告之黑字没有压印，也就是黑字的位置在其他色版上是镂空

The deep UV lithography is also studied by using corrected Fresnel diffraction model.

进行了深度紫外光刻模拟，并对模拟结果进行了实验结果验证。

The experiments of UV proximity lithography show that the corrected Fresnel diffraction model could get more accurate results than that of the Fresnel model.

同时计算机模拟和实验结果都说明尺寸越小的微结构，所能够得到的光刻深度越小，需要的曝光剂量越大；光刻所得微结构的中间会比较宽。

Four types of arrays of single carbon nanotubes, with field emitter diameters of 1μm, 0.6μm, 0.4μm and 0.2μm, were fabricated, respectively, by combining conventional ultraviolet lithography and the recently-developed technique of "aperture reduction via varying glancing angle".

通过普通的紫外光刻工艺，结合"变倾角缩口"新技术，研制了不同发射单元尺寸的碳纳米管阵列阴极。扫瞄电镜分析表明，随着缩口尺寸的依次减小（从0.6μm到0.4μm，最后到0.2μm），发射单元内CNTs的根数也不断减少。

Sometimes put gradienter into monlchamus tuhung roll and bucket roll, check whether the monlchamus road and sea and nano-imprint lithography drums of oxial parllel.

有时还给把程量仪放到墨斗辊和水斗辊上，查抄墨路和旱路是否与压印滚筒的轴线交错。

Based on lithography technology,the electrochemical lamella machining by high frequency group pulses was experimentally studied.

进行了基于光刻技术的高频群脉冲微细电化学薄片加工试验研究。

Graphic technology - Process control for the production of half- tone colour separations, proofs and production prints - Part 3: Coldset offset lithography on newsprint

印刷技术。网目调分色片、样张及印刷成品的生产过程控制。第3部分：新闻纸的冷固型胶版印刷

Delivery chain from the last row of nano-imprint lithography drum on paper, and hand-over each other drum as paper.

收纸链排从末了一个压印滚筒上存纸，和其它滚筒之间彼此移交纸张的请求不同。1。

The third type of formula can only meet the occipital hobber didn't go to an offset printing press for offset press since hobber in regulating rubber roller roller and nano-imprint lithography, clearance between the plate cylinder and penetrated the rubber roller is no need for regulation, walk for offset printing presses in the hobber business card printing and membership card making paper thickness greater than 0.10mm the above with a formula for the calculation and adjustment.

第三栽筹算公式只能满意不行滚枕的胶印机，而行滚枕的胶印机由于在调度橡皮滚筒与压印滚筒之间的间隙之后，印版滚筒与橡皮滚筒之间的间隙必须举行调度，那行滚枕的胶印机在制卡和会员卡制作纸张的厚度大于0.10mm以上不离用第二栽公式举行筹算与调度即可。

Do not gum up the work by telling mother what we are going to do .

别告诉母亲我们要干的事，那会把事情搞糟的。

In recent years, application of the partial prestressed concrete beam s is developed.

近年来，随着部分预应力砼梁应用的推广，发现我国规范所采用的名义拉应力法的计算结果不稳定。