查询词典 laser disk

Barium nitrate crystal was grown by the aqua-solution cooling method with the size of 48 mm×10 mm×10 mm.When the pump laser energy is 65 mJ,the output energy of first Stokes laser(563 nm) and that of second Stokes laser(599 nm) were measured as 21 mJ and 16 mJ respectively.

在泵浦源达到65 mJ时，获得21 mJ一阶斯托克斯光，输出波长为563 nm，以及16 mJ的二阶斯托克斯光，输出波长为599 nm，受激拉曼散射SRS最大的整体转换效率(包含一阶、二阶斯托克斯光之和)为56.3%。

In the high accuracy diffraction measurement of laser for a tiny wire,polarization direction of laser,laser beam property,and deviation of the beam center from the wire center have an effect on the measuring result.

在丝径的激光高精度衍射测量中，激光的偏振方向、光束的几何属性和光束中心对衍射体对称中心的偏离都会影响测量的结果。

It is found that the output mirror transmissivity of the two cavities keep a certain relation when the beam radii of pump laser, 1064 nm laser and 946 nm laser in the Nd: YAG crystal are well matched.

结果表明，当Nd：YAG晶体中抽运光，1064，946 nm激光的光束半径达到合理匹配时，两个子腔的输出镜透过率之间有确定的关系。

A compact super-radiant optically pumped D2O gas Terahertz laser was developed, it consisted of pumping source, laser cavity, measurement and vacuum system, and the length of laser cavity could be changed in the range of 80-150cm.

实验中使用了范围在80-150cm的可变长度的THz激光工作腔，实验得到了波长为385μm(对应频率约0.78THz)，脉冲宽度为100ns，峰值功率百瓦量级的THz激光脉冲信号输出。4。

A compact super-radiant optically pumped D2O gas Terahertz laser was developed, it consisted of pumping source, laser cavity, measurement and vacuum system, and the length of laser cavity could be changed in the range of 80-150cm.

实验研制了一种紧凑型工作腔长可变的超辐射光泵重水气体THz激光器系统，激光器系统由泵浦源TEA-CO2激光器、D2O气体分子THz激光工作腔、测量系统以及真空系统组成。

In this paper the experimental results of laser multiphoton ionization of background gases (mostly oil-vapor) in the vacuum chamber for laser produced plasma study are presented by using high power laser irradiation.

本文报道了在高功率密度激光辐照下，激光等离子体研究用的真空室中背景气体(主要是真空系统中的油蒸气)的多光子电离的实验研究结果。

To suppress the noise which caused by the fuzzy character of XLPE sample, the size of the photodetector was determined based on the analysis of the light intensity distribution in the spatial frequency plane when the laser beam passing through the sample was collected by lens. A series of detectors were designed to eliminate the time response decreasing effect caused by the increasing of the detector size. The developed laser system could resolve defects of 40 um diameter in XLPE tape with the 120um diameter and 400Hz scanning laser beam. after above results was used.

为了消除由于XLPE材料光弥散效应引起的信号噪声对信号幅度测量的影响和提高测试速度，研制了阵列组合式光电探测器，理论分析和实验验证都证明了该探测器有较好的频响特性和较低的噪声水平，应用这两项成果组成的信号系统及微机数据采集电路可在400Hz扫描频率下，扫描宽度所限制的120μm光束直径下获得40μm的测量分辨率。

Materials and Methods: From January 2005 to December 2006, patients diagnosed with keloid were selected to receive six doses of pulsed dye laser therapy. Clinical assessments were evaluated before and 1 month after the laser therapy. Keloid tissue samples were also collected before and 1 month after laser therapy. Laboratory analysis included immunohistochemical staining of TGF-β and phosphorylated Smad2, and real-time PCR of Smad2 mRNA.

材料与方法：在西元2005年至2006年间，10个有keloid的病人在签署同意书之后，接受6次染料雷射的治疗，在雷射治疗前以及之后一个月，接受临床表现的评估和部分keloid组织切除，执行TGF-β和Smad2蛋白的免疫染色分析，和Smad2的mRNA定量分析。

The plasma ignition threshold of metal is got through experimental and numerical study. The vapour and plasma ignition times of the target are got based on the equation of heat conduction and cascade model. We suppose that the plasma is ignited when generations of new electrons are born in vapour generation time. The influence of temperature on the thermodynamics and optics parameters of material also have been considered in the model. The resulting theory has good agreement with the experiment and overseas report. A blade method to measure the laser spot is given in this paper with validation and error analysis. The plasma threshold of metals in atmosphere and water ambients both are diagnosed with the light deflection and piezoelectric transducer. A Q-switched pulsed Nd:YAG laser operating at infrared (1064nm), visible(532nm) and ultraviolet (355nm) wavelengths has been used. Al、Fe、Cu are used as targets and get a similar results with both method. Theoretical and experimental analyses are applied on the influence of wavelength on the threshold have been done, both of which have shown that the plasma threshold of metals decrease as the laser wavelength increases; The plasma threshold of metals are higher in water than in air and the pressure of the shock wave in water is five times higher than in air .

从热传导方程和雪崩电离机制出发，假设当电子增值210倍时，考虑了温度对材料热力学和光学参数的影响时，得到了气化和等离子体点燃的时间，利用该模型进行计算得到的结果与国内外报道及自行通过实验测得的阈值基本一致；提出了利用刀刃法测量激光光斑面积的方法，并通过实验进行了验证和误差分析；利用光偏转装置和压电换能器分别对空气和水中金属等离子体点燃阈值进行了实验诊断，激光器均为调Q－YAG激光器（波长1064nm，532nm，355nm，脉宽10ns），靶材分别为Al、Fe和Cu，两种测试方法得到的等离子体点燃阈值基本一致；本文从实验和理论计算两个方面讨论了波长对等离子体点燃阈值的影响，均得到了等离子体点燃阈值随著波长的增加而减小的结论；对空气中和水中不同环境下金属等离子体的点燃阈值进行了比较研究，得到了金属在水中的等离子体点燃阈值比空气中的大，且水中产生的冲击波的压强是空气中的5倍左右的结论。

Section 1 discusses the advantages of medical film printer and USB, and put forward one elementary design scheme of the system. The principle of laser printer and the holistic design scheme of system are presented detailedly in Section 2, while Section 3 expounds the technology of USB. Section 4 discusses design scheme of transfer system of the laser printer - includes the development of USB device and CPLD. The test of holistic laser printer and effect picture of medical image are presented in Section5. In the end, a review of this system and some bugs are put forwards at present.

本文主要分为六个部分，第一部分讨论了医用胶片打印机和USB总线技术的特点和发展趋势，并提出了系统的初步设计方案和研究意义；第二部分描述了医用激光胶片打印机的背景、工作原理和系统的各个组成部分；第三部分描述了通用串行总线2.0版(USB2.0)的通信原理；第四部分详细介绍了打印机数据传输系统的设计——包括USB设备的开发和CPLD的硬件和软件设计，并对这个传输系统的性能进行了分析；第五部分介绍了整个打印机的测试结果和实际打印医学影像的效果图；最后对本文做出总结并提出了不足之处和参考价值。

Mr. Putin said there were signs of genocide against the Ossetian people.

普京说，有迹象表明对南奥塞梯人进行了种族清洗。

What I'm trying to say, Tristan is...

特瑞斯坦。我想说的是。