查询词典 input current

Ffset voltage at the input of an operational amplifier is comprised of two components, these components are identified in specifying the amplifier as input offset voltage and input bias current.

P的失调电压有两个主要的来源，输入偏置电流和输入失调电压。

These two pairs exhibit different offsets and bias currents, so when the applied input common-mode voltage changes, the AMPLIFIER input offset voltage and input bias current does also.

由于这两个差分对有不同的失调电流和偏置电流，因此加到输入共模电压变化，放大器的输入偏置电压和输入偏压电流也跟着改变。

The input offset voltage is fixed for a particular amplifier, however the contribution due to input bias current is dependent on the circuit configuration used. For minimum offset voltage at the amplifier input without circuit adjustment the source resistance for both inputs should be equal.

对于一个给定的OP，输入失调电压就已经给定了，但是由输入失调电流所带来的失调电压与所采用的电路结构有关系为了减小输入偏置电流所带来的失调电压，应该使得使得同、反相输入端对地的直流电阻相等，使得由于偏置电流在输入电阻上压降所带来的失调电压相互抵消。

S1 is then changed to position 1. The voltage stored on C1 is inserted between the output and inverting input of the amplifier and the output of the amplifier changes by VIN to maintain the amplifier input at the input offset voltage. The output then changes from (VOS + IbiasR2) to (VIN + IbiasR2) as S1 is changed from position 2 to position 1. Amplifier bias current is supplied through R2 from the output of the amplifier or from C2 when S1 is in position 2 and position 1 respectively. R3 serves to reduce the offset at the amplifier output if the amplifier must have maximum linear range or if it is desired to DC couple the amplifier.

接着 S1 拨到位置 1，使 C1 的电压加在放大器的输出端和反相输入端之间，(由于电容端电压不能突变，所以)输出端的电压将产生大小等于 VIN 的变化，使放大器输入端维持输入失调电压，即当开关 S1 从位置 2 拨到位置 1 时，输出端电压将从(VOS + IbiasR2)变为(VIN + IbiasR2)。S1 处于位置 2 时，放大器的偏置电流是由输出端经电阻 R2 提供的，当 S1 转向位置 1 时则由 C2 提供。R3 的作用是降低输出失调电压，如果要求放大器具有最大的线性范围，或者采用直流耦合，就应该使用该电容。

Therefore, the exact relation between the unbalanced input voltage and the noncharacteristic harmonics of the output voltage in the 12-pulse rectifier system is obtained. In addition, the relation between the input current and the imbalance of the input voltage is obtained, which could help to choose the filter elements and exactly analyze the characteristics of the no controlled rectifier circuit.

利用精确的开关函数，推导了多脉波整流系统输入不平衡电压与输出电压非特征谐波的精确关系，进而得到电阻、电感负载时系统输入电流与输入电压不平衡度的关系，为精确地选择滤波元件做了有意义的探索。

Because the primary source of noise in an amplifying IC is its input stage, you can assume that the standard deviation of the random component of output current of the paralleled-N voltage-to-current converters is σNI=σI×, where σI is the standard deviation of the random component of output current of a voltage-to-current converter.

由于放大器噪声的主要来源为输入端，假设N个并联电压电流转换器输出电流的随机器件标准差为σNI=σI×，σI为电压电流转换器输出电流的随机器件标准差。

AMPLIFIER input bias current, a function of TRANSISTOR current gain, is also a function of the applied input common-mode voltage.

放大器的输入偏置电流，晶体管的电流放大作用，也具有加到输入共模电压的作用。

SN75LBC184 series is high withstand voltage, low noise stabilized power supply with reduced reactive current at low input voltage and small input / output differential voltage 0.2V at 40mA output current.

1第1页，本页显示记录1-19，共19条记录分1页显示SN75LBC184系列高耐压，低噪音稳定在四十○毫安输出电源电流，降低无功电流，低输入电压和小的输入/输出电压0.2V的差分。

With voltage measurements, the input current is ideally zero; thus, any input current represents an error.

对电压测量来说，理想的输入电流应为零，所以，一切输入电流都代表误差。

Input offset current can be determined by capping the input connector and selecting the lowest current range.

输入偏置电流可以通过盖上输入连接器并选择最低的电流量程来决定。

Many will continue to choose to live in duality and in conflict.

许多人将继续选择活在二元对立性和冲突中。

I find that students of the University of Physical Education all wear sportswear at first sight.

我发现：体育大学的学生乍一看，都是穿运动衣，大家都一样