查询词典 increasing directed set

For situations of self-rational agents, Inter-Multi-Agent-Contract was formulated to describe the negotiation status of distributed planning and scheduling. Monotonously increasing voidance and violence penalties were defined to facilitate reciprocal cooperation. Negotiation protocol was designed based on bidding and bargaining theory. Commitment mechanism that permits non-immediately effective commitments and enforces monotonously increasing voidance penalty was defined to promote the efficiency of negotiation.

在个体理性条件下的分布计划和调度问题研究中，定义了多代理间合约来描述协商状态，提出通过单调递增的失效和违约惩罚机制来促进代理间的互利协作；基于投标、讨价还价理论建立了合约协商协议，提出通过非即时生效和失效函数单调递增的承诺机制来提高合约协商效率；针对问题域的时间限制定义了协商停止问题，提出了若干解决上述问题的方法。

The break elongation of vulcanizate was increasing with chlorine content. When the chlorine content was higher than 16%, the tensile strength was gradually decreased with the chlorine content. The break elongation was increasing with the content of chlorinated EHL, while the tensile strength was decreased.

硫化胶的扯断伸长率随着氯含量的增大而增大，当氯含量大于16%时，拉伸强度随着氯含量的逐渐增大而降低，并且扯断伸长率随着添加量的增加不断增加，而拉伸强度有所降低。

Experiment shows that both the dry plate pressure drop and the wet plate pressure drop increase with the increase of the kinetic energy factor in plate hole but have no influence of the height of cap. The wet plate pressure drop linearly ascends as the clear liquid height increases. Liquid lift-up increases at first then decreases with the increasing of the kinetic energy factor in plate hole, increases with the clear liquid height increasing and the height of cap decreasing, but as the kinetic energy factor in plate hole increased, the influence of height of cap will gradually decreased.

实验表明干板压降、湿板压降均随板孔动能因子的增大而增大，不受罩体高度变化的影响，湿板压降随清液层高度的增大而增大，成正比关系；液体提升量随板孔动能因子的增大先增大后减小，随清液层高度的增大而增大，随罩体高度的增大而减小，但随板孔动能因子的增加，罩体高度的影响逐渐变小；漏液量随板孔动能因子的增大迅速减小，随清液层高度的增大而增大，但接近漏液点时清液层高度的影响不明显。

Phase modulation depth decreases with the incident angle increasing, while phase modulation depth increases with the obliquity of LC-SLM molecule decreasing, i.e., driving voltage of the LC-SLM increases with the intensity of write-in light increasing.

结果表明，随着入射角的增加，液晶层的相位调制深度逐渐减小；随着分子倾角的减小，相位调制深度逐渐升高，即随着写入光的增强，加到液晶层两端的电压增加；随着入射角的增加，读出光强的初相位逐渐减小，但该初相位值并不大，即使在入射角10°下达到最大，也仅为0.21π。

Hen THP-1 macrophages were induced to the foam cells by ox-LDL. Treatment of THP-1 macrophage derived foam cells with apoA-Ⅰ, forskolin (FRK, an adenyl cyclase activator), and SQ-22536 for long periods of time (24 h). In addition, THP-1 macrophage derived foam cells were treated with increasing amounts of FRK (0, 10, 20, 40 and 80 μmol/L) and treated with FRK for increasing time(0, 6, 12 and 24 h).

HP-1巨噬细胞源性泡沫细胞经各种因素处理后，采用油红&O&染色，观察细胞内的脂滴，运用液体闪烁计数器检测细胞内胆固醇流出，高效液相色谱分析细胞内总胆固醇、游离胆固醇和胆固醇酯含量，用逆转录-聚合酶链反应和蛋白质印迹分析法分别检测ABCA1 mRNA与ABCA1蛋白质的水平。

These results indicated that the increasing of the nitrate reductase activity stimulated flower-bud to pass during physiological and moephological differentiation stage. The decreasing of nitrate reductase activity and the increasing of ammoniacal nitrogen content stimulated the plants to blossom.

表明硝酸还原酶活性在花芽生理分化期至形态分化期的升高有利于促进花芽的转化和形成；形态分化后期至初花期，硝酸还原酶活性的下降，氨态氮含量的上升有利于促进开花。

The frictional heat energy was concentrated on the thermal effect layer with the thickness of 4 mm, The temperature gradient of contact surface is the highest, and decreased rapidly with the radius direction of the lining's groove. The temperature gradient and TEL's thickness increased with the increasing of the sliding speed. The temperature decreased rapidly with the radius direction and also with the increasing of center angle of the lining's groove. The sliding speed and distance are obtained under two sliding conditions when the lining fails, which supply the theoretical basis with the antislip design of friction hoist.

摩擦热量集中在热影响表面层，其厚度仅为4mm，接触表面温度梯度最大，沿绳槽径向迅速减小；温度梯度和热影响表面层厚度随相对滑速的增大而增大；衬垫温度沿径向急剧降低且随圆心角增大而减小；并得到了2种滑动工况下衬垫失效时的相对滑速和滑动距离，为摩擦提升防滑设计提供理论依据。

The main results and conclusions are as follows:The trans-1,4 content of polybutadiene increased from 50%to 89%along with the increasing of Al/Li ratio;the trans-1,4 content of polyisoprene increased from 24%to 46%as well as 3,4 content along with the increasing of Al/Li ratio;the microstructure of polystyrene was invariable and atactic.

主要研究结果及结论如下：随着Al/Li的增加，聚丁二烯的反式结构含量从50%增加到89%；聚异戊二烯的反式-1，4-结构含量从24%增加到46%，并且其3，4结构含量也有所增加；聚苯乙烯的微观结构基本没有变化，为无规聚苯乙烯。

The main results and conclusions are as follows:The trans-1,4 content of polybutadiene increased from 50%to 89%along with the increasing of Al/Li ratio;the trans-1,4 content of polyisoprene increased from 24%to 46%as well as 3,4 content along with the increasing of Al/Li ratio;the microstructure of polystyrene was invariable and atactic.

加热器主要研究结果及结论如下：随着Al/L i的增加，聚丁二烯的反式结构含量从50%增加到89%；聚异戊二烯的反式-1，4-结构含量从24%增加到46%，并且其3，4结构含量也有所增加；聚苯乙烯的微观结构基本没有变化，为无规聚苯乙烯。

The activated or leached process and their influence elements are studied by 1DREACT software package of coupled mass/heat transfer and chemical reaction dynamics of water-rock interaction, according to the geological and geochemical characters of fine disseminated gold deposits.(1) Water-rock reaction time is not the important influence element of activating gold;(2) At first, activating capability of hydrothermal solution increases with the increasing of total sulfur activity; after lga〓≥-4, the content of activated gold in solution is mainly related to original content of gold in wall rock, and does not visibly dependent on total sulfur activity.(3) It is a complicated nonlinear process of influence of activating gold capacity of hydrothermal solution with the change of temperature, in general, 220 ℃ is most favorable to gold activation.(4) The influence of oxygen fugacity on gold activation has a multiple functions coupling nonlinear effect, in general, Igfo〓=-41 is most favorable to gold activation.(5) Solubility of gold in fluid decreases with the increasing of velocity of flow, the product of velocity and aurous solubility reaches maximum when velocity is 0.2～0.5m〓m〓. yr〓, i. e. this scope of velocity is most favorable to gold activation.

利用1DREACT水-岩相互作用反应-输运耦合动力学软件包，根据微细浸染型金矿床地质地球化学特征，计算机模拟研究了金的活化、浸取过程及其影响因素，发现：(1)金活化过程中水-岩反应时间不是其主要制约因素；(2)热液对金的活化能力开始随总硫活度的增高而增高，当lg a〓≥-4后，热液中活化金的含量将主要与围岩中金的初始丰度有关，而对总硫活度无明显依赖关系；(3)温度对热液浸金能力的影响是一个复杂的非线性过程，总体而言，220℃最有利于金的活化；(4)氧逸度对金活化的影响呈现出一种多因素叠加的非线性效应，总体而言，lgfo〓＝-41最有利于金的活化与浸取；(5)流体中金的浓度随流体流速的加快而降低，流速与金浓度的乘积在流速为0.2～0.5m〓m〓。yr〓时达到极大，即0.2～0.5m〓m〓。yr〓的流速范围最有利于本类矿床的金的活化。

When I started coding, I had problems with the ASF file writer.

当我开始编码，我曾与ASF文件作家的问题。

I know that in one of the schools the boys have risen up in the classroom and enlisted in a mass.

如果你们也和他们一样，是集体自愿的话，你们的老师将是多么地光荣啊。