查询词典 increasing directed set

This barding could come in many forms, some increasing dps, some increasing armour, some just granting procs/stats...

这个装饰品可以有很多形式，有些可以提高DPS，有些可以提高护甲，有些只可以得到保护/装饰。。

This barding could come in many forms, some increasing dps, some increasing armour, some just granting procs/stats...

这个装饰品可以有很多形式，有些可以提高DPS，有些可以提高护甲，有些只可以得到特效激发/所有属性。。

Whereas the absorption spectrum undergoes minor change with increasing polarity of the solvents, the fluorescence spectrum experiences a distinct bathochromic shift in the band position and the fluorescence quantum yield increases reaching a maximum before decrease with increasing the solvent polarity.

第三章：本章采用紫外可见和荧光分光光度法研究了一种新型的分子内电荷转移荧光探针1-酮-2--四氢萘在不同极性有机溶剂中的发光行为和光物理性质。

The result showed that toughness of coarse-grain zone in X70 grade steel pipe HAZ was weak.Coarse grain,granular bainite,high binate and other unbalance low temperature variation result in quantity increasing. In addition to,impact toughness of coarse grain zone decrease with the t8/5 increasing.

结果表明：粗晶区是X70级管线钢热影响区中韧性较差的区域，粗晶区韧性恶化主要是晶粒粗化以及粒状贝氏体、上贝氏体等非平衡低温转变产物数量增多造成的，且粗晶区的冲击韧性随着 t8/5 的增加而降低。

With increasing of electronic slug's frequency and development of electronic slug's integration and capsulation, the heat productivity of electronic component rapidly increases. Now the heat flow density of electronic component is up to 10~4W/m~2-10~5 W/m~2, and that it is increasing continually.

随着电子芯片频率的提高，芯片集成和封装技术的发展，电子元器件的发热量迅速提高，如今其热流密度已经达到10~4W/m~2～10~5W/m~2，并且持续增大。

The results showed that with the same coprecipitation mixing time the average manganese valence of MnZn-ferrite samples were increasing as the pH value increasing.

重点研究了前驱体制备过程中共沉淀时的pH值和共沉淀时的搅拌时间的影响。

The IR analyses proved that the polymerization effects really occurred. The BET adsorption test indicated that the adsorption amount of MIPMs to LMD was as three times as that of non-imprinted microspheres. The controlled release test indicated that the release ratio of LMD on NIPMs was linearly increased with increasing time, which suggests that the release process is completely controlled by diffusion. Meanwhile, the release ratio of LMD on MIPMs was curvedly increased with increasing time, which indicates that the release process is controlled by both diffusion and the imprinting effect.

药物扩散实验表明， LMD在非印迹微球上的释药率几乎与时间呈直线关系，说明其释药过程完全受扩散控制；而LMD在MIPMs上的释药率则呈曲线上升趋势，说明其释药过程除了受扩散控制外，还受到药物模板分子与MIPMs之间的印迹效应的协同作用的控制，从而达到了缓释药物分子的目的。

The results were found as following:(1) The damage value increases more significantly with the increase in PVF before 30% PVF, beyond which the increasing trend becomes gradually gentle.(2)Keeping the interphase strength and PVF unchanged, the damage increase with increasing moisture concentration in a nearly linear relation.(3)The results generated from the FCC model with consideration of the interphase debonding are in good agreement with the experimental data, meanwhile, the FCC model is also capable of predicting the critical load for the damaged and the undamaged dental composite subject too the 3-point flexural test.4 A 3D-fmite element analysis has been successfully exploited to examine the mechanical behavior of the restoration-tooth structure under the polymerization shrinkage and water sorption. It was found:(1) The low stiffness of the composite has the effect to limit the displacement occurring in the remaining tooth tissue. For lower interphase, the cuspal flexures are litter higher. The high interphase modulus acts as a \'shielding effect\' for stress transfer.

得到如下结论：(1)相同的吸湿性，在30％PVF(颗粒体积分数：Particle volume fraction，PVF)前增加PVF，层间脱胶损伤值显著增加；此后损伤值的增加趋于平缓；(2)保持层间强度和PVF不变，层间脱胶损伤随吸湿率的增加而接近线性增加；(3)FCC(面心立方：Face-centred cubic，FCC)模型层间脱胶损伤的预测结果和实验数据基本吻合；同时此模型可以用于预测牙齿填充材料三点弯曲实验的临界载荷。4、建立理想牙齿修复结构，利用有限元方法研究了同时考虑聚合收缩和吸湿膨胀耦合作用下的填充修复材料和粘结界面层材料性能对牙齿修复结构的力学行为的影响，得到如下结论：(1)低弹性模量的牙齿填充修复材料能限制天然牙组织的位移，但天然牙组织的位移与粘结界面层的弹性模量无关。

In the procedure of multilevel cyclic loading, the stress-strain curve displays cusped hysteresis loop, which moves toward the direction of strain increasing with time and strain amplitude increasing, indicating the generation of plastic strain continuously.

在多级循环荷载过程中，岩石的应力-应变关系呈现尖叶状的滞后回线，滞后回线随着循环次数的增加向应变增大的方向移动，并不断地产生弹塑性应变。

On the basis of census of all individuals of the populations at different plots, the structure and dynamics of the populations were described. The result showed that P. tabulaeformisf.shekannesis were growing populations, and the distributions of the structure were reverse J. The density decreased with the increasing of Size-class structure. The populations developed the characteristic of increasing in the early stage and stabilizing in the late. The survive curve of Pinus tabulaeformisf.shekannesis were between DeeveyⅡand DeeveyⅢ. The analysis of time sequence showed that most of the inividuals would be adult after 20 years.

结果表明：柴松种群结构呈反J分布型，种群处于增长阶段；种群的密度随径级的增加而降低，种群密度与径级呈现出明显的负相关；四个函数估计值说明柴松种群具有前期增长、后期稳定的特点，其存活曲线介于DeeveyⅡ型和DeeveyⅢ型之间；随时间推移，种群中树和大树数量逐渐增多，种群在20年后开始大量进入成熟阶段。

He became prime minister in 1997 and won international acclaim for his role in the Northern Ireland peace process.

他在1997年成为总理，并且因为在北爱尔兰的和平进程中发挥的作用受到国际社会的赞许。

Mixed Page Sorting Method Using the cuttable user model, this thesis proposes a mixed page sorting method by using cutted user model in server-side and complete user model in client-side.

隐私分级利用的混合式页面排序方法针对个性化搜索中搜索结果排序的问题，本文利用隐私可控开放的用户偏好模型，提出一个在客户端和服务器端分步进行的隐私分级利用的混合式页面排序方法。