查询词典 impulse transformer

The thesis shows a new impulse fault discrimination system for transformer through transformer impulse test.

整个系统共有三部分组成，分别是采集测量部分、滤波算法部分和故障诊断部分。

The mechanism of oscillation overvoltage and induction overvoltage produced in transformer windings under impulse voltage conditions, the principle of the simulation of impulse voltage distribution in transformer windings, and the experience of winding insulation design using the simulation software are theoretically summarized.

在工频电压和操作电压作用下，电力变压器绕组匝间和饼间的电压差值近似按匝数平均分布。但在雷电冲击作用下，由于电压波形的波前等值频率高达数百千赫兹，绕组匝间和饼间的电容和绕组对地的电容影响已不能忽略。

The signals during transformer impulse test are considered to be evolving in time, also is non-stationary signals, so we can design a software algorithm for noise reduction based on discrete Gabor transform, and the basic principle is: The Gabor coefficients of Effective signals during transformer impulse test is centralized in the time frequency range, and the peak-to-peak value is big, whereas the noise Gabor coefficient distribute in the entire time frequency range equally, the peak-to-peak value is small, we can realize the desired signal and the noise separated through frequency mask function.

考虑到冲击试验中的信号都是时变信号，也就是非平稳信号，因此设计了一种基于离散GABOR变换的软件滤波算法对冲击信号进行滤波，其滤波理论依据是：有效信号的Gabor系数在时频域分布比较集中，幅值比较大，噪声的Gabor系数均匀分布于整个时频域，幅值较小，通过构造时频掩模函数来实现有效信号与噪声的分离。

This dissertation gives a special research in microcomputer relay protection for power transformer of 110kV or below voltage ratings, which based on widely summarizing the theory of power system relay protection and its advanced trend. After analyzing the working character of the transformer in details and absorbing the advantages in other power transformer protection, a scheme which is fit to power transformer of 110kV or below voltage ratings is put forward.

本文在全面介绍和评述电力系统微机保护原理及其发展趋势的基础上，对电力系统中大量应用的110kV及以下各电压等级的变压器保护进行了专门研究，根据这一类电力变压器的运行特点，吸取以往各种保护方法的长处，提出了这类电力变压器保护方案。

At present, the production of machine tool control transformers JBK Series, BKZ Series rectifier power supply, BKC series control transformer, QZB three-phase autotransformer, SG series three-phase transformer, BZ, JMB series lights transformer, new R-series transformer, CSG series dedicated servo-controlled machine tool transformers, BK series machine tool control transformers, product quality in line with the IEC standards and national standards.

目前生产JBK系列机床控制变压器，BKZ系列硅整流电源装置，BKC系列控制变压器，QZB三相自耦变压器，SG系列三相变压器，BZ，JMB系列照明变压器，新开发R型系列变压器，CSG系列数控机床专用伺服变压器，BK系列机床控制变压器，产品质量符合IEC标准和国家标准。

A novel layout of IC transformer is proposed to achieve both high turn ratio and coupling coefficient in this paper. In order to discuss the coupling coefficient, the layouts are designed with different turn ratio. The thesis is mainly includes of three experiment topics. The multi-stack structure is proposed to achieve prior goal in first topic. Two groups of proposed devices are designed to maintain identical self- inductances in transformer's primary and secondary coils. Total six devices are fabricated in foundry 90-nm CMOS technology. Using the 9 and 5 metal layers in primary and secondary coils in a specific layout, measurement results show that the transformer has the largest benefit using the bottommost return layer in layout design. In one word, the adoption of more metal layers to construct different turn ratio transformer shows not only improving the N value but also saving the chip area in this experiment.

中文摘要本文是针对不同圈数比变压器探讨其耦合量的变化，并且期望其变压器能同时达到高圈数比及高耦合系数的特性，本论文主要可分为三个实验主题，首先第一个主题提出以90nm CMOS制程技术实现的多层金属层的布局方式，并以相同的一、二次侧自感值分为两组，利用不同返回层来达到不同的圈数比，且从量测结果可以得知，在变压器布局设计上使用最底金属层来作返回层会得到较好的特性，最后从此实验得知一结论，利用合适的多层金属架构达到不同的圈数比，不仅可以改善圈数比，还可以缩小晶片面积。

On the based of the practical project — HTSSP20-6300/35 shell type cooker transformer design, this paper construes the calculate methods and the protect principium, discusses the relation of the gassiness component in oil to the transformer" malfunction and transformer inside fault, and draws the reliability design"s basic concepts of the shell type electric cooker transformer.

借助于对工程实际HTSSP20-6300／35壳式电炉变压器的研究分析，综述了壳式电炉变压器的计算方法和保护原理，深入探讨了油中含气组份和电炉变压器内部故障之间的关系，并提出了壳式电炉变压器可靠性设计的基本概念体系。

In order to overcome the technological difficulties encountered in the course of insulation fault diagnosis on the base of dissolved gases analysis, several kinds of mathematic models and actualized methods are brought forward to improve the reliability and veracity of fault diagnosis of transformers. The research works are shown mainly as followings:1 A modified fuzzy multi-criteria method is brought forward for insulation fault diagnosis of transformer. Furthermore, a new method for insulation fault diagnosis is proposed on the base of fuzzy multi-criteria together with rule reasoning. With fuzzy diagnosis in the method, fault reasons are filtrated and then the reasons in low probability are prohibited, Moreover, the left reasons are testified by using rule reasoning and then final concludes are drawn in much less misjudge probability and better results.2 On the base of geometry characteristics of C- partition to sample set of DGA data of transformer, a method is put forward to compute effective radius of neighbor field of a sample, number of clusters and values of initial centers. Moreover, the fuzzy C- means cluster model with adaptive weight is brought forward in the first time and then the fault classifier is designed for insulation fault diagnosis of transformer.3 According to the weakness of the degree of gray of gray incidence, a new formula to compute DGI is put forward and then incidence order criterion is ascertained. Moreover, a new DGI model for fault diagnosis is proposed according to the further analysis to relationship between fault reason and content of oil dissolved gases of transformer.

为解决在应用油中溶解气体分析方法（Dissolved Gases Analysis，简称DGA）诊断变压器内部绝缘故障时所遇到的主要技术难题，论文提出了用于提高变压器故障诊断准确性和可靠性的数学模型及实现方法，主要研究工作如下：1）提出了一种改进的变压器绝缘故障诊断模糊综合评判方法；进一步提出了将模糊综合诊断与规则推理相结合进行绝缘故障诊断的方法，该方法采用模糊推理对故障原因进行"过滤"，滤掉可能性极小的原因，然后进一步利用规则推理验证剩下的可能原因，得出最终结论，大大减少了误判比率，获得了较好的效果。2）根据以变压器DGA数据为特征量的样本空间的c-划分几何特性出发，提出了一种求取样本有效邻域半径和聚类数及聚类中心初值的方法，在此基础上，首次提出了一种自适应加权的变压器绝缘故障诊断的模糊c-均值聚类模型，并设计出故障分类器。3）针对常用灰色关联度的不足，提出了一新的灰色关联度计算公式及确定关联序的准则；并在此基础上，通过深入分析变压器发生绝缘故障时的原因与油中溶解特征气体含量的关系，建立了一种新的故障诊断灰色关联模型；通过实例分析证明，该方法能有效地诊断出变压器绝缘故障及故障部位，大大提高了诊断的准确性。

We are a professional factory to produce Inverter Transformer、Power Factor Corrector、electronic power transformer、audio frequency transformer、 switching power transformer and inductance coil , main products are exported to America, Japan and Taiwan mostly.

本公司是生产各种贴片变压器、功率因素校正器、电子电源变压器和音频变压器的专业厂家，产品大部份与国内名牌整机厂家配套、出口美国、日本和台湾等地。

The present paper introduced one kind of brand-new transformer measured the warm far biography method -separate method, it has abandoned the tradition the transformer temperature signal by in the remote survey way the biography, the demonstration mentality, but is fully excavates the existing dispatch monitoring automated system the function, the scene transformer temperature signal through the self-made temperature converter, transforms with the transformer temperature correspondence discrete magnitude, far passes to through the RTU remote letter signal the dispatch monitoring end, carries on the demonstration again in the dispatch end using the monitoring software corresponding formula inversion for the warm measure.

本论文介绍了一种全新的变压器测温远传方法-离散法，它摒弃了传统的将变压器温度信号以遥测量的方式上传、显示的思路，而是充分发掘现有调度监控自动化系统的潜在能力，将现场变压器温度信号通过自制的温度变换器，转换成与变压器温度对应的离散量，通过RTU遥信信号远传到调度监控端，在调度端利用监控软件相应的公式再反演为温度量。

Panorama Many people are dancing in a large sitting room.

在一个大客厅里，许多人在跳舞。

We fully understand how a microwave oven cooks food, it is first necessary to talk ...

我们充分理解一个微波炉煮的食物，这是首先要谈。。。